Table of Contents
Textures and Microstructures
Volume 14–18
http://dx.doi.org/10.1155/TSM.14-18.617

Recrystallization of High Symmetry Aluminium Single Crystals After Plane Strain Compression

1Materials Department, Ecole des Mines de Saint-Etienne, France
2UNIREC, Firminy, France
3Department of Materials Science, Faculty of Engineering, Tohoku University, Sendai, Japan

Copyright © 1991 Hindawi Publishing Corporation. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Citations to this Article [7 citations]

The following is the list of published articles that have cited the current article.

  • D. Juul Jensen, “Growth rates and misorientation relationships between growing nuclei/grains and the surrounding deformed matrix during recrystallization,” Acta Metallurgica et Materialia, vol. 43, no. 11, pp. 4117–4129, 1995. View at Publisher · View at Google Scholar
  • K. Matsumoto, N. Tamura, T. Shibayanagi, and Y. Umakoshi, “Effect of Rolling Direction on Recrystallization Behavior of Al-0.6 mass%Mg Alloy with Columnar Grains,” Materials Transactions, JIM, vol. 39, no. 3, pp. 334–342, 1998. View at Publisher · View at Google Scholar
  • O Engler, X.W Kong, and K Lücke, “Recrystallisation textures of particle-containing Al–Cu and Al–Mn single crystals,” Acta Materialia, vol. 49, no. 10, pp. 1701–1715, 2001. View at Publisher · View at Google Scholar
  • Mao Liu, Cheng Lu, Kiet Tieu, and Hailiang Yu, “Numerical comparison between Berkovich and conical nano-indentations: Mechanical behaviour and micro-texture evolution,” Materials Science and Engineering: A, 2014. View at Publisher · View at Google Scholar
  • Mao Liu, Cheng Lu, Kiet Anh Tieu, and Kun Zhou, “Crystal plasticity FEM study of nanoindentation behaviors of Cu bicrystals and Cu–Al bicrystals,” Journal of Materials Research, pp. 1–15, 2015. View at Publisher · View at Google Scholar
  • Mao Liu, Cheng Lu, Kiet Anh Tieu, Ching-Tun Peng, and Charlie Kong, “A combined experimental-numerical approach for determining mechanical properties of aluminum subjects to nanoindentation,” Scientific Reports, vol. 5, pp. 15072, 2015. View at Publisher · View at Google Scholar
  • Mao Liu, Shoichi Nambu, Toshihiko Koseki, Kiet Anh Tieu, and Kun Zhou, “Three-dimensional quantification of texture heterogeneity in single-crystal aluminium subjected to equal channel angular pressing,” Philosophical Magazine, pp. 1–21, 2017. View at Publisher · View at Google Scholar