Proceedings of the International Conference: Neutron Texture and Stress AnalysisView this Special Issue
A. N. Ezeilo, G. A. Webster, "Advances in Neutron Diffraction for Engineering Residual Stress Measurements", Texture, Stress, and Microstructure, vol. 33, Article ID 425719, 21 pages, 1999. https://doi.org/10.1155/TSM.33.151
Advances in Neutron Diffraction for Engineering Residual Stress Measurements
The increasing awareness amongst engineers and designers, of the significance of residual stresses in influencing the useful lifetimes of engineering components, has resulted in more demanding expectations being placed on the methods used to obtain these stresses. The neutron diffraction technique is emerging as the most attractive measuring method as the residual stresses can usually be obtained non-destructively to depths of up to 40 mm in some common engineering materials. Although it is a relatively new technique it has been used to measure the residual stresses in a range of engineering materials introduced by a wide variety of manufacturing processes such as welding, quenching, machining, shot peening, cold hole expansion and autofrettage.In this paper the neutron diffraction technique for non-destructive residual stress measurements will be described including methods used to validate the measurements. Precautions that should be taken in order to obtain reliable measurements are outlined. Procedures being investigated in order to produce a code of practice will be presented. A representative selection of stress distributions developed by a range of manufacturing processes is examined. Some comparisons are made with strain gauge, X-ray and numerical predictions. It is shown how the results can be of benefit in engineering stress analysis.
Copyright © 1999 Hindawi Publishing Corporation. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.