Table of Contents
VLSI Design
Volume 2008, Article ID 312614, 8 pages
http://dx.doi.org/10.1155/2008/312614
Research Article

Design and Implementation of a Hardware Module for MIMO Decoding in a 4G Wireless Receiver

1Departamento de Señales, Sistemas y Radiocomunicaciones, Escuela Técnica Superior de Ingenieros de Telecomunicación, Universidad Politécnica de Madrid, Ciudad Universitaria s/n, Madrid 28040, Spain
2Departamento de Ingeniería Electrónica, Escuela Técnica Superior de Ingenieros de Telecomunicación, Universidad Politécnica de Madrid, Ciudad Universitaria s/n, Madrid 28040, Spain

Received 18 May 2007; Accepted 26 October 2007

Academic Editor: Jean-Baptiste Begueret

Copyright © 2008 Alberto Jiménez-Pacheco et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Citations to this Article [8 citations]

The following is the list of published articles that have cited the current article.

  • Mostafa Wasiuddin Numan, Norbahiah Misran, and Mohammad Tariqul Islam, “An efficient FPGA based prototyping platform for MIMO decoding,” 2009 International Conference on Space Science and Communication, IconSpace - Proceedings, pp. 47–50, 2009. View at Publisher · View at Google Scholar
  • Mohammad Tariqul Islam, Mostafa Wasiuddin Numan, Norbahiah Misran, Mohd Alauddin Mohd Ali, and Mandeep Singh, “Hardware Implementation of a MIMO Decoder Using Matrix Factorization Based Channel Estimation,” Frequenz, vol. 65, no. 3-4, pp. 79–85, 2011. View at Publisher · View at Google Scholar
  • Javier González-Bayón, Angel Fernández-Herrero, and Carlos Carreras, “Evaluation of rapid prototyping solutions for a 802.16d frequency offset estimation scheme,” Journal of Circuits, Systems and Computers, vol. 21, no. 7, 2012. View at Publisher · View at Google Scholar
  • Angel Fernández Herrero, Gabriel Caffarena Fernández, Alberto Jiménez Pacheco, Juan Antonio López Martín, Carlos Carreras Vaquer, and Francisco Javier Casajús Quirós, “Design and Implementation of Hardware Modules for Baseband Processing in Radio Transceivers,” Wireless Radio-Frequency Standards and System Design, pp. 266–286, 2012. View at Publisher · View at Google Scholar
  • Pedro Pinho, and Mario Vestias, “A High-Rate MIMO Receiver in an FPGA,” IEEE Antennas and Propagation Society, AP-S International Symposium (Digest), 2012. View at Publisher · View at Google Scholar
  • Mário Véstias, “Design and test of a MIMO receiver based on the Alamouti scheme in FPGA,” IEEE International Conference on Consumer Electronics - Berlin, ICCE-Berlin, pp. 107–111, 2012. View at Publisher · View at Google Scholar
  • Vijaykumar S. Shirwal, and Mahesh S. Chavan, “Implementation aspect of MIMO decoder,” Proceedings - 2014 IEEE Global Conference on Wireless Computing and Networking, GCWCN 2014, pp. 61–64, 2015. View at Publisher · View at Google Scholar
  • Pablo Poudereux, Álvaro Hernández, Raúl Mateos, Freddy A. Pinto–Benel, and Fernando Cruz–Roldán, “Design of a Filter Bank Multi-Carrier System for Broadband Power Line Communications,” Signal Processing, 2016. View at Publisher · View at Google Scholar