Table of Contents Author Guidelines Submit a Manuscript
Applied Bionics and Biomechanics
Volume 2017 (2017), Article ID 7595642, 14 pages
https://doi.org/10.1155/2017/7595642
Research Article

An Investigation into a Gear-Based Knee Joint Designed for Lower Limb Prosthesis

1Manufacturing System Integration, Department of Mechanical Engineering, Faculty of Engineering, University of Malaya, 50603 Kuala Lumpur, Malaysia
2Department of Electrical Engineering, Faculty of Engineering, University of Malaya, 50603 Kuala Lumpur, Malaysia

Correspondence should be addressed to I. A. Choudhury

Received 12 October 2016; Revised 5 January 2017; Accepted 31 January 2017; Published 11 May 2017

Academic Editor: Thibault Lemaire

Copyright © 2017 M. S. H. Bhuiyan et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. K. R. Kaufman, S. Frittoli, and C. A. Frigo, “Gait asymmetry of transfemoral amputees using mechanical and microprocessor-controlled prosthetic knees,” Clinical Biomechanics, vol. 27, no. 5, pp. 460–465, 2012. View at Publisher · View at Google Scholar · View at Scopus
  2. G. McGimpsey and T. Bradford, Limb Prosthetics Services and Devices, Bioengineering Institute Center for Neuroprosthetics, Worcester Polytechnic Institution, Worcester, MA, 2010, Retrieved from https://www.nist.gov/sites/default/files/documents/tip/wp/pswp/239_limb_prosthetics_services_devices.pdf. View at Publisher · View at Google Scholar · View at Scopus
  3. Y. Okita, N. Tatematsu, K. Nagai et al., “Compensation by nonoperated joints in the lower limbs during walking after endoprosthetic knee replacement following bone tumor resection,” Clinical Biomechanics, vol. 28, no. 8, pp. 898–903, 2013. View at Publisher · View at Google Scholar · View at Scopus
  4. E. J. Goldberg, P. S. Requejo, and E. G. Fowler, “The effect of direct measurement versus cadaver estimates of anthropometry in the calculation of joint moments during above-knee prosthetic gait in pediatrics,” Journal of Biomechanics, vol. 41, no. 3, pp. 695–700, 2008. View at Publisher · View at Google Scholar · View at Scopus
  5. L. Zach, L. Kunčická, P. Růžička, and R. Kocich, “Design, analysis and verification of a knee joint oncological prosthesis finite element model,” Computers in Biology and Medicine, vol. 54, no. 2, pp. 53–60, 2014. View at Publisher · View at Google Scholar · View at Scopus
  6. Q. Lian, D. Li, Z. Jin, Z. Wang, and Y. Sun, “Patient-specific design and biomechanical evaluation of a novel bipolar femoral hemi-knee prosthesis,” Journal of Bionic Engineering, vol. 11, no. 2, pp. 259–267, 2014. View at Publisher · View at Google Scholar · View at Scopus