Table of Contents Author Guidelines Submit a Manuscript
Applied Bionics and Biomechanics
Volume 2017 (2017), Article ID 9701762, 10 pages
Research Article

Additive Manufacturing Techniques for the Reconstruction of 3D Fetal Faces

1Department of Civil and Mechanical Engineering, University of Cassino and Southern Lazio, Cassino, Italy
2Department of Prenatal Diagnosis, ALTAMEDICA, Fetal Maternal Medical Centre, Rome, Italy
3Polytechnic Department of Engineering and Architecture, University of Udine, Udine, Italy
4Department of Management and Production Engineering, Polytechnic of Turin, Turin, Italy
5Department of Electric, Electronics and Computer Engineering, University of Catania, Catania, Italy
6Department of Industrial Engineering, University of Naples Federico II, Naples, Italy

Correspondence should be addressed to Domenico Speranza

Received 11 July 2017; Revised 1 November 2017; Accepted 26 November 2017; Published 19 December 2017

Academic Editor: Eugenio Guglielmelli

Copyright © 2017 Domenico Speranza et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

How to Cite this Article

Domenico Speranza, Daniela Citro, Francesco Padula, et al., “Additive Manufacturing Techniques for the Reconstruction of 3D Fetal Faces,” Applied Bionics and Biomechanics, vol. 2017, Article ID 9701762, 10 pages, 2017. doi:10.1155/2017/9701762