Table of Contents Author Guidelines Submit a Manuscript
Advances in Civil Engineering
Volume 2015, Article ID 191359, 13 pages
http://dx.doi.org/10.1155/2015/191359
Research Article

Research on Dissipation and Fatigue Capacity of Nonstiffener Shear Panel Dampers

1Ministry of Education Key Laboratory of Structural Engineering Disaster and Control, Harbin Institute of Technology, Harbin, Heilongjiang 150090, China
2Department of Civil Engineering, Harbin Institute of Technology, Harbin, Heilongjiang 150090, China
3Department of Civil and Environmental Engineering, University of California, Berkeley, CA 94710, USA

Received 18 May 2015; Revised 7 August 2015; Accepted 9 August 2015

Academic Editor: Hossein Moayedi

Copyright © 2015 Ji-long Li et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. O. Jin-ping, Structural Vibration Control—Active, Semi-Active and Intelligent Control, Science Press, 2003 (Chinese).
  2. T. Kobori and R. Minai, “Analytical study on active seismic response control,” Transactions of the Architectural Institute of Japan, vol. 66, 1960. View at Google Scholar
  3. J. T. P. Yao, “Concept of structural control,” ASCE Journal of Structure Division, vol. 98, no. 7, pp. 1567–1574, 1972. View at Google Scholar
  4. J. P. Ou, B. Wu, and T. T. Soong, “Recent advances in research on and application of passive energy dissipation systems,” Earthquake Engineering and Engineering Vibration, vol. 16, no. 3, pp. 72–96, 1996. View at Google Scholar
  5. T. T. Soong and G. F. Dargush, Passive Energy Dissipation Systems in Structural Engineering, John Wiley & Sons, London, UK, 1997.
  6. J. M. Kelly, R. I. Skinner, and A. J. Heine, “Mechanisms of energy absorption in special devices for use in earthquake resistant structures,” Bulletin of the New Zealand Society for Earthquake Engineering, vol. 5, no. 3, pp. 63–88, 1972. View at Google Scholar · View at Scopus
  7. Z.-Y. Chen, H.-B. Ge, T. Usami, and Y. Yuan, “Ultimate shear strength of shear panel damper under cyclic load,” Journal of Shenyang University of Technology, vol. 33, no. 2, pp. 219–225, 2011 (Chinese). View at Google Scholar · View at Scopus
  8. M. Nakashima, S. Iwai, M. Iwata et al., “Energy dissipation behaviour of shear panels made of low yield steel,” Earthquake Engineering & Structural Dynamics, vol. 23, no. 12, pp. 1299–1313, 1994. View at Publisher · View at Google Scholar · View at Scopus
  9. K. Otani, “Recent trend of technology for steel plates used in building construction,” Nippon Steel Technical Report, vol. 54, pp. 27–36, 1992. View at Google Scholar
  10. M. Aohashi, H. Mochizuki, T. Yamaguchi et al., “Development of new steel plates for building structural use,” Steel Research, no. 334, pp. 17–28, 1989. View at Google Scholar
  11. T. Yamaguchi, T. Takeuchi, T. Nagao et al., “Seismic control devices using low-yield-point steel,” Nippon Steel Technical Report, no. 77, pp. 65–72, 1998. View at Google Scholar · View at Scopus
  12. M. Nakashima, “Strain-hardening behavior of shear panels made of low-yield steel. I: test,” Journal of Structural Engineering, vol. 121, no. 12, pp. 1742–1749, 1995. View at Publisher · View at Google Scholar · View at Scopus
  13. H. Tamai, H. Takenaka, T. Nakano, O. Kojima, K. Kondoh, and M. Hanai, “On hysteretic damper using low-yield stress steel plate installed in K-braced frame,” in Proceedings of the Annual Meeting of Architectural Institute of Japan, pp. 1447–1450, Tokyo, Japan, September 1991 (Japanese).
  14. M. Izumi, N. Kani, H. Narihara, Y. Kawamata, K. Ogura, and O. Hosozawa, “Low cycle fatigue test on shear yielding type low-yield stress steel hysteretic damper for response control, part 1 and 2,” in Proceedings of the Annual Meeting of the Architectural Institute of Japan, pp. 1333–1336, Tokyo, Japan, 1992 (Japanese).
  15. L. Fu, Y.-Q. Zhang, Y.-R. Luo, Q. Yu, M.-T. Li, and X.-G. Zeng, “Low cycle fatigue properties of steel BLY160 with low yield point for damper,” Journal of Iron and Steel Research, vol. 27, no. 3, pp. 65–69, 2015. View at Publisher · View at Google Scholar
  16. S. Fengming, W. Donghui, L. Zigang, and B. Mingzhuo, “Application and development of low yield point steel,” Material & Heat Treatment, vol. 37, no. 6, pp. 85–89, 2008 (Chinese). View at Google Scholar
  17. S. Gong, G. Sheng, D. Yao, S. Li, and Q. Chen, “Research on steels for earthquake damping device,” Iron and Steel, vol. 36, no. 9, pp. 55–57, 2001. View at Google Scholar · View at Scopus
  18. D. Wen, F. Song, Z. Li et al., “Develop and performance study on low yield point steel used in earthquake control building,” (Chinese), http://www.chinabaike.com/z/yj/554590.html.
  19. S. Zhongshuang, Research on behaviors of energy dissipation of shear panels dampers made of low-yield steel [M.S. thesis], Harbin Institute of Technology, Harbin, China, 2013.
  20. Z. Song, H. Li, L. Han et al., “Experimental study on hysteretic behavior of shear panel dampers made of steel with low yield point,” Journal of Disaster Prevention and Mitigation Engineering, vol. 34, no. 3, pp. 289–295, 2014. View at Google Scholar
  21. W. Bin, Testing, analysis and design approaches of hysteretic energy dissipation systems [Ph.D. thesis], Harbin University of Civil Engineering and Architecture, 1998 (Chinese).
  22. H.-F. Chen, Elasticity and Plasticity, China Architecture & Building Press, Beijing, China, 2004, (Chinese).
  23. S.-J. Chen and C. Jhang, “Cyclic behavior of low yield point steel shear walls,” Thin-Walled Structures, vol. 44, no. 7, pp. 730–738, 2006. View at Publisher · View at Google Scholar · View at Scopus
  24. C. Zhang, Z. Zhang, and J. Shi, “Development of high deformation capacity low yield strength steel shear panel damper,” Journal of Constructional Steel Research, vol. 75, pp. 116–130, 2012. View at Publisher · View at Google Scholar · View at Scopus