Table of Contents Author Guidelines Submit a Manuscript
Advances in Civil Engineering
Volume 2015 (2015), Article ID 537405, 10 pages
Research Article

Seismic Vulnerability Assessment of Deficient RC Structures with Bar Pullout and Joint Shear Degradation

NUST Institute of Civil Engineering, School of Civil & Environmental Engineering, National University of Sciences & Technology, Islamabad, Pakistan

Received 14 August 2014; Revised 15 December 2014; Accepted 22 December 2014

Academic Editor: Polat Gülkan

Copyright © 2015 Arslan Mushtaq et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. S. Ahmed, Seismic vulnerability of non-ductile reinforced concrete structures in developing countries [Ph.D. thesis], Earthquake Engineering Group, Department of Civil & Structural Engineering, University of Sheffield, 2011.
  2. M. F. Giberson, “Two nonlinear beams with definitions of ductility,” Journal of the Structural Division, vol. 95, supplement 2, pp. 137–157, 1969. View at Google Scholar
  3. H. Krawinkler and S. Mohasseb, “Effects of panel zone deformations on seismic response,” Journal of Constructional Steel Research, vol. 8, pp. 233–250, 1987. View at Publisher · View at Google Scholar
  4. H. Krawinkler, “State of the art report on systems performance of steel moment frames subjected to earthquake ground shaking,” Tech. Rep. FEMA-355C, Federal Emergency Management Agency, Washington, DC, USA, 2001. View at Google Scholar
  5. S. Alath and S. Kunnath, “Modeling inelastic shear deformation in RC beam-column joints,” in Proceedings of the 10th Conference on Engineering Mechanics, pp. 822–825, University of Colorado at Boulder, Boulder, Colo, USA, 1995.
  6. L. Lowes, N. Mitra, and A. Altontash, A Beam-Column Joint Model for Simulating the Earthquake Response of Reinforced Concrete Frames, Pacific Earthquake Engineering Research Centre, University of California, Berkeley, Calif, USA, 2003.
  7. N. J. Stevens, S. M. Uzumeri, and M. P. Collins, “Reinforced concrete subjected to reversed cyclic shear—experiments and constitutive model,” ACI Structural Journal, vol. 88, no. 2, pp. 135–146, 1991. View at Google Scholar · View at Scopus
  8. B. B. Canbolat, “Structural applications of a reinforced concrete beam-column-slab connection model for earthquake loading,” in Proceedings of the 14th World Conference on Earthquake Engineering, Beijing, China, 2008.
  9. J. Kim and M. J. Lafave, “Joint shear behavior prediction for RC beam-column connections,” International Journal of Concrete Structures and Materials, vol. 5, no. 1, pp. 57–64, 2011. View at Publisher · View at Google Scholar
  10. Building Codes of Pakistan (BCP), Seismic Provisions, Government of Islamic Republic of Pakistan, Ministry of Housing and Works, Islamabad, Pakistan, 2007.
  11. K. Shehzada, B. Gencturk, A. N. Khan, A. Naseer, M. Javed, and M. Fahad, “Vulnerability assessment of typical buildings in Pakistan,” International Journal of Earth Sciences and Engineering, vol. 4, no. 6, pp. 208–211, 2011. View at Google Scholar
  12. Rashid Khan and J. Rodgers, Four Storey Office Building in Muzafarabad. A Case Study of Seismic Assessment and Retrofit Design, GeoHazards International and NED University of Engineering & Technology, Karachi, Pakistan, 2012.
  13. Rashid Khan and J. Rodgers, Four Storey Academic Building. A Case Study of Seismic Assessment, NED University of Engineering & Technology, 2012,
  14. A. Naeem, Q. Ali, M. Javed et al., “First report on the Kashmir earthquake of October 8, 2005,” Tech. Rep., Department of Civil Engineering, University of Engineering & Technology, Peshawar, Pakistan, 2005. View at Google Scholar
  15. CEB-FIP Model Code 1990, “Bond stress strain relationship,” in Comite Euro-International du Beton, Chapter 3, 1991, First Published in 1993 by Thomas Telford.
  16. N. Kyriakides, Vulnerability of RC buildings and risk assessment for Cyprus [Ph.D. thesis], Department of Civil & Structural Engineering, Center for Cement and Concrete, University of Sheffield, Sheffield, UK, 2007.
  17. N. Kyriakides, K. Pilakoutas, and K. Chrysostomou, “Vulnerability of RC buildings and risk assessment for Cyprus,” in Proceedings of the 3rd International Fib Congress Incorporating the PCI Annual Convention and Bridge Conference, Washington, DC, USA, 2010.
  18. FEMA 440, “Improvement of nonlinear static seismic analysis procedures,” Project Report ATC-55, Applied Technology Council, Redwood City, Calif, USA, 2005. View at Google Scholar
  19. T. Rossetto and A. Elnashai, “Derivation of vulnerability functions for European-type RC structures based on observational data,” Engineering Structures, vol. 25, no. 10, pp. 1241–1263, 2003. View at Publisher · View at Google Scholar · View at Scopus