Determining the Geometrical Sizes of Plates with Internal Hinges by Using Additional Conditions

Table 2

The solutions obtained by using the bisection method in the system whose hard clamping condition is given at its borders, with the length values corresponding to these.

(cm)		(cm)
		cm	cm	cm	cm
	2.8	0.1339	1.1744	1.2653	0.2981
	4	0.0760	0.8213	0.9286	0.1729
	3.4	0.1022	1.0014	1.1038	0.2303
	3.1	0.1774	1.0892	1.1865	0.2629
	3.25	0.1096	1.0456	1.1456	0.2463
	3.325	0.1059	1.0236	1.1248	0.2382
	3.3625		1.0125	1.1143
	3.3438		1.0181	1.1195
	3.3344		1.0208	1.1222