Table of Contents Author Guidelines Submit a Manuscript
Complexity
Volume 2018, Article ID 7030184, 14 pages
https://doi.org/10.1155/2018/7030184
Research Article

Intelligent Torque Vectoring Approach for Electric Vehicles with Per-Wheel Motors

1Tecnalia Research & Innovation, Industry and Transport Division, Donostia, Spain
2Department of Automatics and System Engineering, Faculty of Engineering of Bilbao, University of the Basque Country (UPV/EHU), Bilbao, Spain

Correspondence should be addressed to Alberto Parra; moc.ailancet@arrap.otrebla

Received 24 November 2017; Revised 15 January 2018; Accepted 23 January 2018; Published 25 February 2018

Academic Editor: José Manuel Andújar

Copyright © 2018 Alberto Parra et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. ACEA, European Automobile Manufacturers Association - New passenger car registrations by alternative fuel type in the European Union Q4 2015, 2016.
  2. A. Al-Hmouz, J. Shen, R. Al-Hmouz, and J. Yan, “Modeling and simulation of an Adaptive Neuro-Fuzzy Inference System (ANFIS) for mobile learning,” IEEE Transactions on Learning Technologies, vol. 5, no. 3, pp. 226–237, 2012. View at Publisher · View at Google Scholar · View at Scopus
  3. M. Nikowitz, Advanced Hybrid and Electric Vehicles, Springer, 2016.
  4. A. Broggi, A. Zelinsky, Ü. Özgüner, and C. Laugier, “Intelligent Vehicles,” in Springer Handbook of Robotics, B. Siciliano and O. Khatib, Eds., Springer, Cham, Switzerland, 2016. View at Google Scholar
  5. S. Inoue, T. Ozawa, H. Inoue, P. Raksincharoensak, and M. Nagai, “Cooperative lateral control between driver and ADAS by haptic shared control using steering torque assistance combined with direct yaw moment control,” in Proceedings of the 19th IEEE International Conference on Intelligent Transportation Systems (ITSC '16), pp. 316–321, Brazil, November 2016. View at Publisher · View at Google Scholar · View at Scopus
  6. L. De Novellis, A. Sorniotti, P. Gruber, and A. Pennycott, “Comparison of feedback control techniques for torque-vectoring control of fully electric vehicles,” IEEE Transactions on Vehicular Technology, vol. 63, no. 8, pp. 3612–3623, 2014. View at Publisher · View at Google Scholar · View at Scopus
  7. K. Shimada and Y. Shibahata, “Comparison of three active chassis control methods for stabilizing yaw moments,” SAE Technical Papers, 1994. View at Publisher · View at Google Scholar · View at Scopus
  8. L. De Novellis, A. Sorniotti, P. Gruber, L. Shead, V. Ivanov, and K. Hoepping, “Torque vectoring for electric vehicles with individually controlled motors: State-of-the-art and future developments,” World Electric Vehicle Journal, vol. 5, no. 2, pp. 617–628, 2012. View at Google Scholar · View at Scopus
  9. A. Haddoun et al., “Sliding mode control of EV electric differential system,” in Proceedings of the ICEM, Chania, Greece.
  10. A. Haddoun, M. E. H. Benbouzid, D. Diallo, R. Abdessemed, J. Ghouili, and K. Srairi, “Modeling, analysis, and neural network control of an EV electrical differential,” IEEE Transactions on Industrial Electronics, vol. 55, no. 6, pp. 2286–2294, 2008. View at Publisher · View at Google Scholar · View at Scopus
  11. K. Jalali, T. Uchida, J. Mcphee, and S. Lambert, “Integrated stability control system for electric vehicles with in-wheel motors using soft computing techniques,” SAE International Journal of Passenger Cars - Electronic and Electrical Systems, vol. 2, no. 1, pp. 109–119, 2009. View at Publisher · View at Google Scholar · View at Scopus
  12. H. Kahveci, H. I. Okumus, and M. Ekici, “An electronic differential system using fuzzy logic speed controlled in-wheel brushless DC motors,” in Proceedings of the 4th International Conference on Power Engineering, Energy and Electrical Drives, pp. 881–885, Turkey, May 2013. View at Publisher · View at Google Scholar · View at Scopus
  13. D. E. Williams and W. M. Haddad, “Nonlinear control of roll moment distribution to influence vehicle yaw characteristics,” IEEE Transactions on Control Systems Technology, vol. 3, no. 1, pp. 110–116, Mar 1995. View at Google Scholar
  14. Y. Hu, L. Yang, B. Yan, T. Yan, and P. Ma, “An online rolling optimal control strategy for commuter hybrid electric vehicles based on driving condition learning and prediction,” IEEE Transactions on Vehicular Technology, vol. 65, no. 6, pp. 4312–4327, 2016. View at Publisher · View at Google Scholar · View at Scopus
  15. I. Yang, S. Byun, B. Seo, D. Lee, and D. S. Han, “Integrated control systems of active front steering and direct yaw moment control using dynamic inversion,” in Proceedings of the 2013 IEEE Intelligent Vehicles Symposium (IEEE IV '13), pp. 1303–1306, Australia, June 2013. View at Publisher · View at Google Scholar · View at Scopus
  16. C. Shen, G. Yin, and X. Jin, “Study on the active steering system with direct yaw-moment control for electric vehicle with electric motored wheels,” in Proceedings of the 35th Chinese Control Conference (CCC '16), pp. 8945–8950, China, July 2016. View at Publisher · View at Google Scholar · View at Scopus
  17. E. Siampis, E. Velenis, and S. Longo, “Model Predictive torque vectoring control for electric vehicles near the limits of handling,” in Proceedings of the European Control Conference (ECC '15), pp. 2553–2558, Austria, 2015. View at Publisher · View at Google Scholar · View at Scopus
  18. H. B. Pacejka, “Tyre and Vehicle Dynamics, BH, 2005”.
  19. J. Kim, H. Lee, and S. Choi, “A robust road bank angle estimation based on a proportional-integral Hfilter,” Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, vol. 226, no. 6, pp. 779–794, 2012. View at Google Scholar
  20. R. Ghandour, A. Victorino, M. Doumiati, and A. Charara, “Tire/road friction coefficient estimation applied to road safety,” in Proceedings of the 18th Mediterranean Conference on Control and Automation (MED '10), pp. 1485–1490, June 2010. View at Publisher · View at Google Scholar · View at Scopus
  21. W. Cho, J. Yoon, S. Yim, B. Koo, and K. Yi, “Estimation of tire forces for application to vehicle stability control,” IEEE Transactions on Vehicular Technology, vol. 59, no. 2, pp. 638–649, 2010. View at Publisher · View at Google Scholar · View at Scopus
  22. M. Doumiati, A. Victorino, D. Lechner, G. Baffet, and A. Charara, “Observers for vehicle tyre/road forces estimation: Experimental validation,” Vehicle System Dynamics, vol. 48, no. 11, pp. 1345–1378, 2010. View at Publisher · View at Google Scholar · View at Scopus
  23. S. Antonov, A. Fehn, and A. Kugi, “Unscented Kalman filter for vehicle state estimation,” Vehicle System Dynamics, vol. 49, no. 9, pp. 1497–1520, 2011. View at Publisher · View at Google Scholar · View at Scopus
  24. M. Doumiati, A. Victorino, A. Charara, and D. Lechner, “Lateral load transfer and normal forces estimation for vehicle safety: Experimental test,” Vehicle System Dynamics, vol. 47, no. 12, pp. 1511–1533, 2009. View at Publisher · View at Google Scholar · View at Scopus
  25. A. Rabhi, N. K. M'Sirdi, and A. Elhajjaji, “Estimation of contact forces and tire road friction,” in Proceedings of the Mediterranean Conference on Control and Automation, pp. 1–6, 2007.
  26. M. Acosta and S. Kanarachos, “Tire lateral force estimation and grip potential identification using Neural Networks, Extended Kalman Filter, and Recursive Least Squares,” Neural Computing and Applications, pp. 1–12, 2017. View at Publisher · View at Google Scholar
  27. R. Jayachandran, S. D. Ashok, and S. Narayanan, “Fuzzy logic based modelling and simulation approach for the estimation of tire forces,” in Proceedings of the 2013 International Conference on Design and Manufacturing, vol. 64, pp. 1109–1118, India, July 2013.
  28. H. Wallentowitz, Vertical and Lateral Dynamics of Passenger Vehicles, Automotive Technology II, Institute of Automotive Engineering, Aachen University of Technology, Germany, 2005.
  29. L. A. Zadeh, “Fuzzy sets,” Information and Control, vol. 8, no. 3, pp. 338–353, 1965. View at Publisher · View at Google Scholar · View at Scopus
  30. M. Blej and M. Azizi, “Comparison of Mamdani-type and Sugeno-type fuzzy inference systems for fuzzy real time scheduling,” International Journal of Applied Engineering Research, vol. 11, no. 22, pp. 11071–11075, 2016. View at Google Scholar · View at Scopus
  31. D. L. Milliken and W. F. Milliken, “Race Car Vehicle Dynamics,” Society of Automotive Engineers, 1995. View at Google Scholar
  32. Y. Bai and D. Wang, “Fundamentals of Fuzzy Logic Control - Fuzzy Sets, Fuzzy Rules and Defuzzifications,” in Advanced Fuzzy Logic Technologies in Industrial Applications, Advances in Industrial Control, Y. Bai, H. Zhuang, and D. Wang, Eds., Springer, London, UK, 2006. View at Google Scholar
  33. J. S. R. Jang, “ANFIS: adaptive-network-based fuzzy inference system,” IEEE Transactions on Systems, Man, and Cybernetics, vol. 23, no. 3, pp. 665–685, 1993. View at Publisher · View at Google Scholar · View at Scopus
  34. M. Asadi, “Optimized Mamdani fuzzy models for predicting the strength of intact rocks and anisotropic rock masses,” Journal of Rock Mechanics and Geotechnical Engineering, vol. 8, no. 2, pp. 218–224, 2016. View at Publisher · View at Google Scholar · View at Scopus
  35. K. M. Passino and S. Yurkovich, Fuzzy Control, 1997.
  36. Dynacar by Tecnalia, http://www.dynacar.es/en/home.php.
  37. A. Pena, I. Iglesias, J. J. Valera, and A. Martin, “Development and validation of Dynacar RT software, a new integrated solution for design of electric and hybrid vehicles,” in Proceedings of the 26th Electric Vehicle Symposium (EVS 2012), pp. 2026–2032, USA, May 2012. View at Scopus
  38. M. Dendaluce, I. Iglesias, A. Martin, P. Prieto, and A. Peña, “Race-Track testing of a torque vectoring algorithm on a motor-in-wheel car using a model-based methodology with a hil and multibody simulator setup,” in Proceedings of the 19th IEEE International Conference on Intelligent Transportation Systems (ITSC 2016), pp. 2500–2505, Brazil, November 2016. View at Publisher · View at Google Scholar · View at Scopus
  39. J. Cuadrado, D. Vilela, I. Iglesias, A. Martín, and A. Peña, “A multibody model to assess the effect of automotive motor in-wheel configuration on vehicle stability and comfort,” in Proceedings of the ECCOMAS Thematic Conference on Multibody Dynamics, pp. 1083–1092, 2013. View at Scopus
  40. https://www.fsaeonline.com/.
  41. https://www.iso.org/standard/57253.html.
  42. Ministerio de Transportes y Comunicaciones, Manual De Carreteras Diseno Geometrico, 2014.
  43. A. Rezaeian, R. Zarringhalam, S. Fallah et al., “Novel tire force estimation strategy for real-time implementation on vehicle applications,” IEEE Transactions on Vehicular Technology, vol. 64, no. 6, pp. 2231–2241, 2015. View at Publisher · View at Google Scholar · View at Scopus