Table of Contents Author Guidelines Submit a Manuscript
International Journal of Antennas and Propagation
Volume 2017 (2017), Article ID 7516323, 15 pages
https://doi.org/10.1155/2017/7516323
Research Article

Design, Fabrication, and Testing of Active Skin Antenna with 3D Printing Array Framework

1Key Laboratory of Electronic Equipment Structure Design, Ministry of Education, Xidian University, Xi’an 710071, China
2State Key Laboratory of Structural Analysis for Industrial Equipment, Dalian University of Technology, Dalian 116024, China
3National Key Laboratory of Antennas and Microwave Technology, Xidian University, Xi’an 710071, China
4Nanjing Research Institute of Electronic Technology, Nanjing 210039, China

Correspondence should be addressed to Jinzhu Zhou; moc.621@uohzzj_naidix

Received 25 August 2017; Accepted 17 October 2017; Published 23 November 2017

Academic Editor: Maggie Y. Chen

Copyright © 2017 Jinzhu Zhou et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

How to Cite this Article

Jinzhu Zhou, Haitao Li, Le Kang, Baofu Tang, Jin Huang, and Zhiheng Cai, “Design, Fabrication, and Testing of Active Skin Antenna with 3D Printing Array Framework,” International Journal of Antennas and Propagation, vol. 2017, Article ID 7516323, 15 pages, 2017. doi:10.1155/2017/7516323