Table of Contents Author Guidelines Submit a Manuscript
International Journal of Biomaterials
Volume 2017, Article ID 1256537, 11 pages
https://doi.org/10.1155/2017/1256537
Research Article

Effect of Injection Molding Melt Temperatures on PLGA Craniofacial Plate Properties during In Vitro Degradation

1LEBm Biomechanics Engineering Laboratory, University Hospital (HU), Federal University of Santa Catarina, 88040-900 Florianópolis, SC, Brazil
2NIMMA Laboratory of Innovation on Additive Manufacturing and Molding, Federal University of Santa Catarina, 88040-900 Florianópolis, SC, Brazil
3GRANTE, Department of Mechanical Engineering, Federal University of Santa Catarina, 88040-900 Florianópolis, SC, Brazil

Correspondence should be addressed to Liliane Pimenta de Melo; moc.liamg@gne.enailil

Received 10 June 2017; Revised 24 July 2017; Accepted 30 July 2017; Published 6 September 2017

Academic Editor: Junling Guo

Copyright © 2017 Liliane Pimenta de Melo et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

How to Cite this Article

Liliane Pimenta de Melo, Gean Vitor Salmoria, Eduardo Alberto Fancello, and Carlos Rodrigo de Mello Roesler, “Effect of Injection Molding Melt Temperatures on PLGA Craniofacial Plate Properties during In Vitro Degradation,” International Journal of Biomaterials, vol. 2017, Article ID 1256537, 11 pages, 2017. https://doi.org/10.1155/2017/1256537.