Table of Contents Author Guidelines Submit a Manuscript
International Journal of Corrosion
Volume 2018, Article ID 7479383, 7 pages
https://doi.org/10.1155/2018/7479383
Research Article

Chemical Composition of Corrosion Products of Rebar Caused by Carbonation and Chloride

Faculty of Architectural, Civil Engineering and Environment, Ningbo University, Ningbo 315211, China

Correspondence should be addressed to Junzhe Liu; moc.361@uilehznuj

Received 14 January 2018; Revised 9 April 2018; Accepted 10 April 2018; Published 19 June 2018

Academic Editor: Michael J. Schütze

Copyright © 2018 Jundi Geng et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. A. Poursaee, “Temperature dependence of the formation of the passivation layer on carbon steel in high alkaline environment of concrete pore solution,” Electrochemistry Communications, vol. 73, pp. 24–28, 2016. View at Publisher · View at Google Scholar · View at Scopus
  2. A. Scott and M. G. Alexander, “Effect of supplementary cementitious materials (binder type) on the pore solution chemistry and the corrosion of steel in alkaline environments,” Cement and Concrete Research, vol. 89, pp. 45–55, 2016. View at Publisher · View at Google Scholar · View at Scopus
  3. R. Liu, L. Jiang, J. Xu, C. Xiong, and Z. Song, “Influence of carbonation on chloride-induced reinforcement corrosion in simulated concrete pore solutions,” Construction and Building Materials, vol. 56, pp. 16–20, 2014. View at Publisher · View at Google Scholar · View at Scopus
  4. T. V. Shibaeva, V. K. Laurinavichyute, G. A. Tsirlina, A. M. Arsenkin, and K. V. Grigorovich, “The effect of microstructure and non-metallic inclusions on corrosion behavior of low carbon steel in chloride containing solutions,” Corrosion Science, vol. 80, pp. 299–308, 2014. View at Publisher · View at Google Scholar · View at Scopus
  5. Y. Wang, S. Nanukuttan, Y. Bai, and P. A. M. Basheer, “Influence of combined carbonation and chloride ingress regimes on rate of ingress and redistribution of chlorides in concretes,” Construction and Building Materials, vol. 140, pp. 173–183, 2017. View at Publisher · View at Google Scholar · View at Scopus
  6. T. Bellezze, G. Roventi, E. Barbaresi, N. Ruffini, and R. Fratesi, “Effect of concrete carbonation process on the passivating products of galvanized steel reinforcements,” Materials and Corrosion, vol. 62, no. 2, pp. 155–160, 2011. View at Publisher · View at Google Scholar · View at Scopus
  7. H. Luo, H. Su, C. Dong, and X. Li, “Passivation and electrochemical behavior of 316L stainless steel in chlorinated simulated concrete pore solution,” Applied Surface Science, vol. 400, pp. 38–48, 2017. View at Publisher · View at Google Scholar · View at Scopus
  8. J. Williamson and O. B. Isgor, “The effect of simulated concrete pore solution composition and chlorides on the electronic properties of passive films on carbon steel rebar,” Corrosion Science, vol. 106, pp. 82–95, 2016. View at Publisher · View at Google Scholar · View at Scopus
  9. H. B. Gunay, P. Ghods, O. B. Isgor, G. J. C. Carpenter, and X. Wu, “Characterization of atomic structure of oxide films on carbon steel in simulated concrete pore solutions using EELS,” Applied Surface Science, vol. 274, pp. 195–202, 2013. View at Publisher · View at Google Scholar · View at Scopus
  10. A. S. Yaro, K. R. Abdul-Khalik, and A. A. Khadom, “Effect of CO2 corrosion behavior of mild steel in oilfield produced water,” Journal of Loss Prevention in the Process Industries, vol. 38, pp. 24–38, 2015. View at Publisher · View at Google Scholar · View at Scopus
  11. E. Sosa, R. Cabrera-Sierra, M. T. Oropeza et al., “Electrochemically grown passive films on carbon steel (SAE 1018) in alkaline sour medium,” Electrochimica Acta, vol. 48, no. 12, pp. 1665–1674, 2003. View at Publisher · View at Google Scholar · View at Scopus
  12. Y. Tang, S. Wang, Y. Xu, and J. Ni, “Influence of calcium nitrite on the passive films of rebar in simulated concrete pore solution,” Anti-Corrosion Methods and Materials, vol. 64, no. 3, pp. 265–272, 2017. View at Publisher · View at Google Scholar · View at Scopus
  13. A. Alhozaimy, R. R. Hussain, A. Al-Negheimish, R. Al-Zaid, and D. D. N. Singh, “Effect of simulated concrete pore solution chemistry, chloride ions, and temperature on passive layer formed on steel reinforcement,” ACI Materials Journal, vol. 111, no. 4, pp. 411–421, 2014. View at Publisher · View at Google Scholar · View at Scopus
  14. Y. Zhou and Y. Zuo, “Surface films on plasma nitrided stainless steel subjected to passivation treatments,” Applied Surface Science, vol. 353, pp. 924–932, 2015. View at Google Scholar
  15. J. Z. Liu, W. Sun, J. B. Chen et al., “Carbonation rate and microstructural characteristics of hardened cement paste with high alkali content,” Journal of the Chinese Ceramic Society, vol. 42, no. 7, pp. 1005–1010, 2014. View at Google Scholar
  16. P. Ghods, O. B. Isgor, J. R. Brown, F. Bensebaa, and D. Kingston, “XPS depth profiling study on the passive oxide film of carbon steel in saturated calcium hydroxide solution and the effect of chloride on the film properties,” Applied Surface Science, vol. 257, no. 10, pp. 4669–4677, 2011. View at Publisher · View at Google Scholar · View at Scopus
  17. R. Blair, B. Pesic, J. Kline, I. Ehrsam, and K. Raja, “Threshold chloride concentrations and passivity breakdown of rebar steel in real concrete solution at different pH conditions with the addition of glycerol,” Acta Metallurgica Sinica (English Letters), vol. 30, no. 4, pp. 376–389, 2017. View at Publisher · View at Google Scholar · View at Scopus
  18. J. Liu, M. Ba, Y. Du, Z. He, and J. Chen, “Corrigendum to “Effects of chloride ions on carbonation rate of hardened cement paste by X-ray CT techniques” [Constr. Build. Mater. 122 (2016) 619–627],” Construction and Building Materials, vol. 131, p. 800, 2017. View at Publisher · View at Google Scholar