Table of Contents
International Journal of Manufacturing Engineering
Volume 2015, Article ID 627218, 11 pages
http://dx.doi.org/10.1155/2015/627218
Research Article

An Investigation of Abrasive Water Jet Machining on Graphite/Glass/Epoxy Composite

1Department of Mechanical and Manufacturing Engineering, Manipal Institute of Technology, Manipal University, Manipal 576104, India
2School of Engineering & IT, Department of Mechanical Engineering, Manipal University Dubai Campus, Dubai International Academic City, P.O. Box 345050, Dubai, UAE

Received 31 July 2014; Revised 9 November 2014; Accepted 12 December 2014

Academic Editor: SeinLeung Soo

Copyright © 2015 Deepak Doreswamy et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Citations to this Article [7 citations]

The following is the list of published articles that have cited the current article.

  • R. Selvam, L. Karunamoorthy, and N. Arunkumar, “Investigation on Performance of Abrasive Water Jet in Machining Hybrid Composites,” Materials and Manufacturing Processes, 2016. View at Publisher · View at Google Scholar
  • Maojun Li, Mingjie Huang, Xujing Yang, Shuo Li, and Kai Wei, “Experimental study on hole quality and its impact on tensile behavior following pure and abrasive waterjet cutting of plain woven CFRP laminates,” The International Journal of Advanced Manufacturing Technology, 2018. View at Publisher · View at Google Scholar
  • S. Madhu, and M. Balasubramanian, “Impact of Nozzle Design on Surface Roughness of Abrasive Jet Machined Glass Fibre Reinforced Polymer Composites,” Silicon, 2018. View at Publisher · View at Google Scholar
  • Kashif Ishfaq, Nadeem Ahmad Mufti, Naveed Ahmed, and Salman Pervaiz, “Abrasive waterjet cutting of cladded material: kerf taper and MRR analysis,” Materials and Manufacturing Processes, pp. 1–10, 2018. View at Publisher · View at Google Scholar
  • S. Madhu, and M. Balasubramanian, “Effect of swirling abrasives induced by a novel threaded nozzle in machining of CFRP composites,” The International Journal of Advanced Manufacturing Technology, 2018. View at Publisher · View at Google Scholar
  • M. El-Hofy, M.O. Helmy, G. Escobar-Palafox, K. Kerrigan, R. Scaife, and H. El-Hofy, “Abrasive Water Jet Machining of Multidirectional CFRP Laminates,” Procedia CIRP, vol. 68, pp. 535–540, 2018. View at Publisher · View at Google Scholar
  • S M Mullaikodi, K Shanmugasundaram, Vaddi Seshagiri Rao, and Sathish Rengarajan, “Synthesis, characterization and machinability studies on thin hybrid composites with SiC nano particles,” Materials Research Express, vol. 6, no. 6, pp. 065321, 2019. View at Publisher · View at Google Scholar