Fatigue Fracture Properties and Morphology of Polyoxymethylene (POM) Plates Produced under Moderate Processing Conditions

Table 3

Processing parameters used for injection molding (plate dimension: 150 × 150 × 5 mm).

	Delrin	Tenac
Screw diameter (mm)	40
Metering volume (cm^3)	160
Back pressure (bar)	40
Melt temperature (°C)	215	210
Injection flow rate (cm^3/s)	10
Max. injection pressure (bar)	700	630/700 (90°C mold temperature only)
Mold temperature (°C)	60/90/110
Switch-over volume (cm^3)	27
Holding pressure (bar)	600
Holding pressure time (s)	12
Remaining cushion (cm^3)	12	11
Residual cooling time (s)	50
Total cycle time (s)	82.8	80.8