Table of Contents Author Guidelines Submit a Manuscript
Journal of Combustion
Volume 2016, Article ID 5127682, 9 pages
http://dx.doi.org/10.1155/2016/5127682
Research Article

The Role of Molecule Clustering by Hydrogen Bond in Hydrous Ethanol on Laminar Burning Velocity

1Mechanical Engineering Department, Bali State Polytechnic, Badung, Bali 80361, Indonesia
2Department of Mechanical Engineering, University of Brawijaya, Malang, East Java, Indonesia

Received 16 January 2016; Revised 28 April 2016; Accepted 17 May 2016

Academic Editor: Satyanarayanan R. Chakravarthy

Copyright © 2016 I Made Suarta et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. S. Saxena, S. Schneider, S. Aceves, and R. Dibble, “Wet ethanol in HCCI engines with exhaust heat recovery to improve the energy balance of ethanol fuels,” Applied Energy, vol. 98, pp. 448–457, 2012. View at Publisher · View at Google Scholar · View at Scopus
  2. T. C. C. de Melo, G. B. Machado, C. R. P. Belchior et al., “Hydrous ethanol–gasoline blends—combustion and emission investigations on a Flex-Fuel engine,” Fuel, vol. 97, pp. 796–804, 2012. View at Publisher · View at Google Scholar · View at Scopus
  3. D. Bradley, M. Lawes, S. Liao, and A. Saat, “Laminar mass burning and entrainment velocities and flame instabilities of i-octane, ethanol and hydrous ethanol/air aerosols,” Combustion and Flame, vol. 161, no. 6, pp. 1620–1632, 2014. View at Publisher · View at Google Scholar · View at Scopus
  4. R. C. Costa and J. R. Sodré, “Hydrous ethanol vs. gasoline-ethanol blend: engine performance and emissions,” Fuel, vol. 89, no. 2, pp. 287–293, 2010. View at Publisher · View at Google Scholar · View at Scopus
  5. I. Schifter, L. Diaz, J. P. Gómez, and U. Gonzalez, “Combustion characterization in a single cylinder engine with mid-level hydrated ethanol-gasoline blended fuels,” Fuel, vol. 103, pp. 292–298, 2013. View at Publisher · View at Google Scholar · View at Scopus
  6. B. B. Breaux and S. Acharya, “The effect of elevated water content on swirl-stabilized ethanol/air flames,” Fuel, vol. 105, pp. 90–102, 2013. View at Publisher · View at Google Scholar · View at Scopus
  7. G. Li, Z. Zhang, F. You et al., “A novel strategy for hydrous-ethanol utilization: demonstration of a spark-ignition engine fueled with hydrogen-rich fuel from an onboard ethanol/steam reformer,” International Journal of Hydrogen Energy, vol. 38, no. 14, pp. 5936–5948, 2013. View at Publisher · View at Google Scholar · View at Scopus
  8. B. M. Masum, H. H. Masjuki, M. A. Kalam, I. M. Rizwanul Fattah, S. M Palash, and M. J. Abedin, “Effect of ethanol–gasoline blend on NOx emission in SI engine,” Renewable and Sustainable Energy Reviews, vol. 24, pp. 209–222, 2013. View at Publisher · View at Google Scholar · View at Scopus
  9. A. Kyriakides, V. Dimas, E. Lymperopoulou, D. Karonis, and E. Lois, “Evaluation of gasoline-ethanol-water ternary mixtures used as a fuel for an Otto engine,” Fuel, vol. 108, pp. 208–215, 2013. View at Publisher · View at Google Scholar · View at Scopus
  10. R. Munsin, Y. Laoonual, S. Jugjai, and Y. Imai, “An experimental study on performance and emissions of a small SI engine generator set fuelled by hydrous ethanol with high water contents up to 40%,” Fuel, vol. 106, pp. 586–592, 2013. View at Publisher · View at Google Scholar · View at Scopus
  11. J. M. Smith, H. C. Van Ness, and M. M. Abbott, Introduction to Chemical Engineering Thermodynamics, McGraw-Hill, New York, NY, USA, 2001.
  12. J. Beeckmann, L. Cai, and H. Pitsch, “Experimental investigation of the laminar burning velocities of methanol, ethanol, n-propanol, and n-butanol at high pressure,” Fuel, vol. 117, pp. 340–350, 2014. View at Publisher · View at Google Scholar · View at Scopus
  13. Z. Zhang, G. Li, L. Ouyang, Z. Pan, F. You, and X. Gao, “Experimental determination of laminar burning velocities and Markstein lengths for 75% hydrous-ethanol, hydrogen and air gaseous mixtures,” International Journal of Hydrogen Energy, vol. 36, no. 20, pp. 13194–13206, 2011. View at Publisher · View at Google Scholar · View at Scopus
  14. R. J. Johnston and J. T. Farrell, “Laminar burning velocities and Markstein lengths of aromatics at elevated temperature and pressure,” Proceedings of the Combustion Institute, vol. 30, no. 1, pp. 217–224, 2005. View at Publisher · View at Google Scholar
  15. X. J. Gu, M. Z. Haq, M. Lawes, and R. Woolley, “Laminar burning velocity and Markstein lengths of methane-air mixtures,” Combustion and Flame, vol. 121, no. 1-2, pp. 41–58, 2000. View at Publisher · View at Google Scholar
  16. X. Qin and Y. Ju, “Measurements of burning velocities of dimethyl ether and air premixed flames at elevated pressures,” Proceedings of the Combustion Institute, vol. 30, no. 1, pp. 233–240, 2005. View at Google Scholar
  17. http://www.acdlabs.com/.
  18. A. Nose and M. Hojo, “Hydrogen bonding of water-ethanol in alcoholic beverages,” Journal of Bioscience and Bioengineering, vol. 102, no. 4, pp. 269–280, 2006. View at Publisher · View at Google Scholar · View at Scopus
  19. E. E. Fileti, P. Chaudhuri, and S. Canuto, “Relative strength of hydrogen bond interaction in alcohol–water complexes,” Chemical Physics Letters, vol. 400, no. 4–6, pp. 494–499, 2004. View at Publisher · View at Google Scholar · View at Scopus
  20. S. Y. Liao, D. M. Jiang, Z. H. Huang, K. Zeng, and Q. Cheng, “Determination of the laminar burning velocities for mixtures of ethanol and air at elevated temperatures,” Applied Thermal Engineering, vol. 27, no. 2-3, pp. 374–380, 2007. View at Publisher · View at Google Scholar · View at Scopus
  21. E. Ranzi, A. Frassoldati, R. Grana et al., “Hierarchical and comparative kinetic modeling of laminar flame speeds of hydrocarbon and oxygenated fuels,” Progress in Energy and Combustion Science, vol. 38, no. 4, pp. 468–501, 2012. View at Publisher · View at Google Scholar · View at Scopus