Table of Contents Author Guidelines Submit a Manuscript
Journal of Chemistry
Volume 2015, Article ID 596740, 8 pages
http://dx.doi.org/10.1155/2015/596740
Research Article

Study of Flow-Assisted Corrosion of AZ91D Magnesium Alloy in Loop System Based on Array Electrode Technology

1Hubei Key Laboratory of Materials Chemistry and Service Failure, School of Chemistry and Chemical Engineering, Huazhong University of Science and Technology, Wuhan 430074, China
2School of Chemistry and Environmental Engineering, Wuhan Institute of Technology, Wuhan 430073, China

Received 10 July 2014; Accepted 12 October 2014

Academic Editor: Guang-Ling Song

Copyright © 2015 Hualiang Huang et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. G. Song, A. L. Bowles, and D. H. St John, “Corrosion resistance of aged die cast magnesium alloy AZ91D,” Materials Science and Engineering A, vol. 366, no. 2, pp. 74–86, 2004. View at Publisher · View at Google Scholar
  2. T. Zhang, X. Liu, Y. Shao, G. Meng, and F. Wang, “Electrochemical noise analysis on the pit corrosion susceptibility of Mg–10Gd–2Y–0.5Zr, AZ91D alloy and pure magnesium using stochastic model,” Corrosion Science, vol. 50, pp. 3500–3507, 2008. View at Publisher · View at Google Scholar
  3. A. M. Fekry and M. Z. Fatayerji, “Electrochemical corrosion behavior of AZ91D alloy in ethylene glycol,” Electrochimica Acta, vol. 54, no. 26, pp. 6522–6528, 2009. View at Publisher · View at Google Scholar · View at Scopus
  4. J. H. Nordlien, S. Ono, N. Masuko, and K. Nisancioglu, “Morphology and structure of oxide films formed on magnesium by exposure to air and water,” Journal of the Electrochemical Society, vol. 142, no. 10, pp. 3320–3322, 1995. View at Publisher · View at Google Scholar · View at Scopus
  5. G. Song, A. Atrens, X. Wu, and B. Zhang, “Corrosion behaviour of AZ21, AZ501 and AZ91 in sodium chloride,” Corrosion Science, vol. 40, no. 10, pp. 1769–1791, 1998. View at Publisher · View at Google Scholar
  6. G. Baril, C. Blanc, and N. Pebere, “AC impedance spectroscopy in characterizing time-dependent corrosion of AZ91 and AM50 magnesium alloys characterization with respect to their microstructures,” Journal of the Electrochemical Society, vol. 148, no. 12, pp. B489–B496, 2001. View at Publisher · View at Google Scholar
  7. P. Schmutz, V. Guillaumin, R. S. Lillard, J. A. Lillard, and G. S. Frankel, “Influence of dichromate ions on corrosion processes on pure magnesium,” Journal of the Electrochemical Society, vol. 150, no. 4, pp. B99–B110, 2003. View at Publisher · View at Google Scholar · View at Scopus
  8. N. LeBozec, M. Jönsson, and D. Thierry, “Atmospheric corrosion of magnesium alloys: influence of temperature, relative humidity, and chloride deposition,” Corrosion, vol. 60, no. 4, pp. 356–361, 2004. View at Publisher · View at Google Scholar · View at Scopus
  9. J. Chen, J. Wang, E. Han, J. Dong, and W. Ke, “AC impedance spectroscopy study of the corrosion behavior of an AZ91 magnesium alloy in 0.1 M sodium sulfate solution,” Electrochimica Acta, vol. 52, no. 9, pp. 3299–3309, 2007. View at Publisher · View at Google Scholar
  10. M. Ö. Öteyaka, E. Ghali, and R. Tremblay, “Corrosion behaviour of AZ and ZA magnesium alloys in alkaline chloride media,” International Journal of Corrosion, vol. 2012, Article ID 452631, 10 pages, 2012. View at Publisher · View at Google Scholar · View at Scopus
  11. S. A. Salman, R. Ichino, and M. Okido, “A comparative electrochemical study of AZ31 and AZ91 magnesium alloy,” International Journal of Corrosion, vol. 2010, Article ID 412129, 7 pages, 2010. View at Publisher · View at Google Scholar · View at Scopus
  12. G. L. Song and M. Liu, “The effect of surface pretreatment on the corrosion performance of Electroless E-coating coated AZ31,” Corrosion Science, vol. 62, pp. 61–72, 2012. View at Publisher · View at Google Scholar
  13. G. A. Zhang, L. Zeng, H. L. Huang, and X. P. Guo, “A study of flow accelerated corrosion at elbow of carbon steel pipeline by array electrode and computational fluid dynamics simulation,” Corrosion Science, vol. 77, pp. 334–341, 2013. View at Publisher · View at Google Scholar
  14. W. S. Miller, L. Zhuang, J. Bottema et al., “Recent development in aluminium alloys for the automotive industry,” Materials Science and Engineering A, vol. 280, no. 1, pp. 37–49, 2000. View at Publisher · View at Google Scholar · View at Scopus
  15. T. J. Harvey, J. A. Wharton, and R. J. K. Wood, “Development of synergy model for erosion-corrosion of carbon steel in a slurry pot,” Tribology—Materials, Surfaces and Interfaces, vol. 1, no. 1, pp. 33–47, 2007. View at Publisher · View at Google Scholar
  16. S. S. Rajahram, T. J. Harvey, and R. J. K. Wood, “Erosion-corrosion resistance of engineering materials in various test conditions,” Wear, vol. 267, no. 1–4, pp. 244–254, 2009. View at Publisher · View at Google Scholar · View at Scopus
  17. S. S. Rajahramn, T. J. Harvey, and R. J. K. Wood, “Electrochemical investigation of erosion-corrosion using a slurry pot erosion tester,” Tribology International, vol. 44, no. 3, pp. 232–240, 2011. View at Publisher · View at Google Scholar
  18. D. López, N. Alonso Falleiros, and A. Paulo Tschiptschin, “Effect of nitrogen on the corrosionerosion synergism in an austenitic stainless steel,” Tribology International, vol. 44, no. 5, pp. 610–616, 2011. View at Publisher · View at Google Scholar · View at Scopus
  19. R. C. Barik, J. A. Wharton, R. J. K. Wood, and K. R. Stokes, “Electro-mechanical interactions during erosion–corrosion,” Wear, vol. 267, no. 11, pp. 1900–1908, 2009. View at Publisher · View at Google Scholar
  20. M. M. Stack and N. Pungwiwat, “Particulate erosion-corrosion of Al in aqueous conditions: some perspectives on pH effects on the erosion-corrosion map,” Tribology International, vol. 35, no. 10, pp. 651–660, 2002. View at Publisher · View at Google Scholar · View at Scopus
  21. G. T. Burstein and K. Sasaki, “Effect of impact angle on the slurry erosion-corrosion of 304L stainless steel,” Wear, vol. 240, no. 1-2, pp. 80–94, 2000. View at Publisher · View at Google Scholar · View at Scopus
  22. A. Neville and C. Wang, “Erosion-corrosion mitigation by corrosion inhibitors—an assessment of mechanisms,” Wear, vol. 267, no. 1–4, pp. 195–203, 2009. View at Publisher · View at Google Scholar · View at Scopus
  23. M. M. Stack and G. H. Abdulrahman, “Mapping erosion-corrosion of carbon steel in oil exploration conditions: some new approaches to characterizing mechanisms and synergies,” Tribology International, vol. 43, no. 7, pp. 1268–1277, 2010. View at Publisher · View at Google Scholar
  24. R. C. Barik, J. A. Wharton, R. J. K. Wood, K. S. Tan, and K. R. Stokes, “Erosion and erosion-corrosion performance of cast and thermally sprayed nickel-aluminium bronze,” Wear, vol. 259, no. 1–6, pp. 230–242, 2005. View at Publisher · View at Google Scholar · View at Scopus
  25. R. Malka, S. Nešić, and D. A. Gulino, “Erosion-corrosion and synergistic effects in disturbed liquid-particle flow,” Wear, vol. 262, no. 7-8, pp. 791–799, 2007. View at Publisher · View at Google Scholar · View at Scopus
  26. R. O. Rihan and S. Nesic, “Erosion–corrosion of mild steel in hot caustic. Part I: NaOH solution,” Corrosion Science, vol. 48, no. 9, pp. 2633–2659, 2006. View at Publisher · View at Google Scholar
  27. M. El-Gammal, H. Mazhar, J. S. Cotton, C. Shefski, J. Pietralik, and C. Y. Ching, “The hydrodynamic effects of single-phase flow on flow accelerated corrosion in a 90-degree elbow,” Nuclear Engineering and Design, vol. 240, no. 6, pp. 1589–1598, 2010. View at Publisher · View at Google Scholar · View at Scopus
  28. J. Hu, D. Huang, G. Song, and X. Guo, “The synergistic inhibition effect of organic silicate and inorganic Zn salt on corrosion of Mg-10Gd-3Y magnesium alloy,” Corrosion Science, vol. 53, no. 12, pp. 4093–4101, 2011. View at Publisher · View at Google Scholar