Table of Contents Author Guidelines Submit a Manuscript
Journal of Engineering
Volume 2014 (2014), Article ID 643051, 7 pages
http://dx.doi.org/10.1155/2014/643051
Research Article

Experimental Finite Element Approach for Stress Analysis

Mechanical Engineering Department, University of Gaziantep, 27310 Gaziantep, Turkey

Received 25 December 2013; Accepted 22 April 2014; Published 11 May 2014

Academic Editor: Jong M. Park

Copyright © 2014 Ahmet Erklig and M. Akif Kütük. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. J. Wei and J. H. Zhao, “A two-strain-gage technique for determining mode I stress-intensity factor,” Theoretical and Applied Fracture Mechanics, vol. 28, pp. 135–140, 1997. View at Publisher · View at Google Scholar
  2. S. Simandjuntak, H. Alizadeh, M. J. Pavier, and D. J. Smith, “Fatigue crack closure of a corner crack: a comparison of experimental results with finite element predictions,” International Journal of Fatigue, vol. 27, no. 8, pp. 914–919, 2005. View at Publisher · View at Google Scholar · View at Scopus
  3. B. J. Briscoe and A. Chateauminois, “Measurements of friction-induced surface strains in a steel/polymer contact,” Tribology International, vol. 35, no. 4, pp. 245–254, 2002. View at Publisher · View at Google Scholar · View at Scopus
  4. H. Kanehara and T. Fujioka, “Measuring rail/wheel contact points of running railway vehicles,” Wear, vol. 253, no. 1-2, pp. 275–283, 2002. View at Publisher · View at Google Scholar · View at Scopus
  5. N. El-Abbasi, J. S. Cirne, and S. A. Meguid, “Numerical and experimental investigations of contact in thin and thick rings,” International Journal of Mechanical Sciences, vol. 41, no. 9, pp. 1051–1066, 1999. View at Publisher · View at Google Scholar · View at Scopus
  6. J. Cordey and E. Gautier, “Strain gauges used in the mechanical testing of bones. Part II: “in vitro” and “in vivo” technique,” Injury, vol. 30, no. 1, pp. S-A14–S-A20, 1999. View at Google Scholar · View at Scopus
  7. D. S. Barker, D. J. Netherway, J. Krishnan, and T. C. Hearn, “Validation of a finite element model of the human metacarpal,” Medical Engineering & Physics, vol. 27, no. 2, pp. 103–113, 2005. View at Publisher · View at Google Scholar · View at Scopus
  8. K. Akça, M. C. Çehreli, and H. İplikçioğlu, “A comparison of three dimensional finite element stress analysis with in vitro strain gauge measurements on dental implants,” The International Journal of Prosthodontics, vol. 15, no. 2, pp. 115–121, 2002. View at Google Scholar
  9. P. Reymer, “Validation of the fem model of the mi-24 tail boom and vertical stabilizer,” Journal of KONES Powertrain and Transport, vol. 18, no. 2, pp. 369–376, 2011. View at Google Scholar
  10. ANSYS Procedures, Engineering Analysis System Verification Manual, vol. 1, Swanson Analysis System, Houston, Pa, USA, 1993.