Table of Contents Author Guidelines Submit a Manuscript
Journal of Healthcare Engineering
Volume 2017 (2017), Article ID 7981513, 6 pages
https://doi.org/10.1155/2017/7981513
Research Article

Effect of Graded Facetectomy on Lumbar Biomechanics

1Spine Division of Orthopaedic Department, Tongji Hospital, Tongji University School of Medicine, 389 Xincun Road, Shanghai 200065, China
2Department of Histology and Embryology, Tongji University School of Medicine, 1239 Siping Road, Shanghai 200092, China

Correspondence should be addressed to Rui Zhu

Received 21 November 2016; Revised 8 January 2017; Accepted 23 January 2017; Published 19 February 2017

Academic Editor: Jie Yao

Copyright © 2017 Zhi-li Zeng et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. C. Ammendolia, P. Cote, Y. R. Rampersaud et al., “The boot camp program for lumbar spinal stenosis: a protocol for a randomized controlled trial,” Chiropractic & Manual Therapies, vol. 24, no. 1, p. 25, 2016. View at Google Scholar
  2. S. J. Atlas, R. B. Keller, D. Robson, R. A. Deyo, and D. E. Singer, “Surgical and nonsurgical management of lumbar spinal stenosis: four-year outcomes from The Maine Lumbar Spine Study,” Spine (Phila Pa 1976), vol. 25, no. 5, pp. 556–562, 2000. View at Publisher · View at Google Scholar · View at Scopus
  3. K. Abumi, M. M. Panjabi, K. M. Kramer, J. Duranceau, T. Oxland, and J. J. Crisco, “Biomechanical evaluation of lumbar spinal stability after graded facetectomies,” Spine (Phila Pa 1976), vol. 15, no. 11, pp. 1142–1147, 1990. View at Publisher · View at Google Scholar
  4. A. Okawa, K. Shinomiya, K. Takakuda, and O. Nakai, “A cadaveric study on the stability of lumbar segment after partial laminotomy and facetectomy with intact posterior ligaments,” Journal of Spinal Disorders, vol. 9, no. 6, pp. 518–526, 1996. View at Publisher · View at Google Scholar
  5. Y. Zhou, G. Luo, T. W. Chu et al., “The biomechanical change of lumbar unilateral graded facetectomy and strategies of its microsurgical reconstruction: report of 23 cases,” Zhonghua Yi Xue Za Zhi, vol. 87, no. 19, pp. 1334–1338, 2007. View at Google Scholar
  6. H. Li and Z. Wang, “Intervertebral disc biomechanical analysis using the finite element modeling based on medical images,” Computerized Medical Imaging and Graphics, vol. 30, no. 6-7, pp. 363–370, 2006. View at Publisher · View at Google Scholar · View at Scopus
  7. T. Zander, A. Rohlmann, C. Klockner, and G. Bergmann, “Influence of graded facetectomy and laminectomy on spinal biomechanics,” European Spine Journal, vol. 12, no. 4, pp. 427–434, 2003. View at Publisher · View at Google Scholar · View at Scopus
  8. K. K. Lee and E. C. Teo, “Effects of laminectomy and facetectomy on the stability of the lumbar motion segment,” Medical Engineering & Physics, vol. 26, no. 3, pp. 183–192, 2004. View at Publisher · View at Google Scholar · View at Scopus
  9. C. S. Chen, C. K. Feng, C. K. Cheng, M. J. Tzeng, C. L. Liu, and W. J. Chen, “Biomechanical analysis of the disc adjacent to posterolateral fusion with laminectomy in lumbar spine,” Journal of Spinal Disorders & Techniques, vol. 18, no. 1, pp. 58–65, 2005. View at Publisher · View at Google Scholar · View at Scopus
  10. A. Kiapour, D. Ambati, R. W. Hoy, and V. K. Goel, “Effect of graded facetectomy on biomechanics of Dynesys dynamic stabilization system,” Spine (Phila Pa 1976), vol. 37, no. 10, pp. E581–E589, 2012. View at Publisher · View at Google Scholar · View at Scopus
  11. D. U. Erbulut, “Biomechanical effect of graded facetectomy on asymmetrical finite element model of the lumbar spine,” Turkish Neurosurgery, vol. 24, no. 6, pp. 923–928, 2014. View at Publisher · View at Google Scholar · View at Scopus
  12. W. T. Edwards, Y. Zheng, L. A. Ferrara, and H. A. Yuan, “Structural features and thickness of the vertebral cortex in the thoracolumbar spine,” Spine (Phila Pa 1976), vol. 26, no. 2, pp. 218–225, 2001. View at Publisher · View at Google Scholar · View at Scopus
  13. U. M. Ayturk and C. M. Puttlitz, “Parametric convergence sensitivity and validation of a finite element model of the human lumbar spine,” Computer Methods in Biomechanics and Biomedical Engineering, vol. 14, no. 8, pp. 695–705, 2011. View at Publisher · View at Google Scholar · View at Scopus
  14. A. Shirazi-Adl, A. M. Ahmed, and S. C. Shrivastava, “Mechanical response of a lumbar motion segment in axial torque alone and combined with compression,” Spine (Phila Pa 1976), vol. 11, no. 9, pp. 914–927, 1986. View at Publisher · View at Google Scholar
  15. V. K. Goel, Y. E. Kim, T. H. Lim, and J. N. Weinstein, “An analytical investigation of the mechanics of spinal instrumentation,” Spine (Phila Pa 1976), vol. 13, no. 9, pp. 1003–1011, 1988. View at Publisher · View at Google Scholar
  16. A. Rohlmann, T. Zander, H. Schmidt, H. J. Wilke, and G. Bergmann, “Analysis of the influence of disc degeneration on the mechanical behaviour of a lumbar motion segment using the finite element method,” Journal of Biomechanics, vol. 39, no. 13, pp. 2484–2490, 2006. View at Publisher · View at Google Scholar · View at Scopus
  17. B. Ilharreborde, M. N. Shaw, L. J. Berglund, K. D. Zhao, R. E. Gay, and K. N. An, “Biomechanical evaluation of posterior lumbar dynamic stabilization: an in vitro comparison between universal clamp and Wallis systems,” European Spine Journal, vol. 20, no. 2, pp. 289–296, 2011. View at Publisher · View at Google Scholar · View at Scopus
  18. A. Rohlmann, S. Neller, L. Claes, G. Bergmann, and H. J. Wilke, “Influence of a follower load on intradiscal pressure and intersegmental rotation of the lumbar spine,” Spine, vol. 26, no. 24, pp. E557–E561, 2001. View at Publisher · View at Google Scholar · View at Scopus
  19. M. J. Pearcy and S. B. Tibrewal, “Axial rotation and lateral bending in the normal lumbar spine measured by three-dimensional radiography,” Spine (Phila Pa 1976), vol. 9, no. 6, pp. 582–587, 1984. View at Publisher · View at Google Scholar
  20. M. Pearcy, I. Portek, and J. Shepherd, “Three-dimensional x-ray analysis of normal movement in the lumbar spine,” Spine (Phila Pa 1976), vol. 9, no. 3, pp. 294–297, 1984. View at Publisher · View at Google Scholar
  21. K. Ueno and Y. K. Liu, “A three-dimensional nonlinear finite element model of lumbar intervertebral joint in torsion,” Journal of Biomechanical Engineering, vol. 109, no. 3, pp. 200–209, 1987. View at Publisher · View at Google Scholar
  22. R. Eberlein, G. Holzapfel, and C. A. Schulze-Bauer, “An anisotropic model for annulus tissue and enhanced finite element analyses of intact lumbar disc bodies,” Computer Methods in Biomechanics and Biomedical Engineering, vol. 4, no. 3, pp. 209–229, 2000. View at Publisher · View at Google Scholar · View at Scopus
  23. A. Rohlmann, T. Zander, M. Rao, and G. Bergmann, “Applying a follower load delivers realistic results for simulating standing,” Journal of Biomechanics, vol. 42, no. 10, pp. 1520–1526, 2009. View at Publisher · View at Google Scholar · View at Scopus
  24. A. Rohlmann, T. Zander, M. Rao, and G. Bergmann, “Realistic loading conditions for upper body bending,” Journal of Biomechanics, vol. 42, no. 7, pp. 884–890, 2009. View at Publisher · View at Google Scholar · View at Scopus
  25. M. Dreischarf, A. Rohlmann, G. Bergmann, and T. Zander, “Optimised loads for the simulation of axial rotation in the lumbar spine,” Journal of Biomechanics, vol. 44, no. 12, pp. 2323–2327, 2011. View at Publisher · View at Google Scholar · View at Scopus
  26. M. Dreischarf, A. Rohlmann, G. Bergmann, and T. Zander, “Optimised in vitro applicable loads for the simulation of lateral bending in the lumbar spine,” Medical Engineering & Physics, vol. 34, no. 6, pp. 777–780, 2012. View at Publisher · View at Google Scholar · View at Scopus
  27. F. Heuer, H. Schmidt, Z. Klezl, L. Claes, and H. J. Wilke, “Stepwise reduction of functional spinal structures increase range of motion and change lordosis angle,” Journal of Biomechanics, vol. 40, no. 2, pp. 271–280, 2007. View at Publisher · View at Google Scholar · View at Scopus
  28. H. Wilke, P. Neef, B. Hinz, H. Seidel, and L. Claes, “Intradiscal pressure together with anthropometric data--a data set for the validation of models,” Clinical Biomechanics (Bristol, Avon), vol. 16, Suppl 1, pp. S111–S126, 2001. View at Publisher · View at Google Scholar
  29. G. Choi, S. H. Lee, P. Lokhande et al., “Percutaneous endoscopic approach for highly migrated intracanal disc herniations by foraminoplastic technique using rigid working channel endoscope,” Spine (Phila Pa 1976), vol. 33, no. 15, pp. E508–E515, 2008. View at Publisher · View at Google Scholar · View at Scopus
  30. U. Quint, H. J. Wilke, F. Loer, and L. E. Claes, “Functional sequelae of surgical decompression of the lumbar spine--a biomechanical study in vitro,” Zeitschrift für Orthopädie und Ihre Grenzgebiete, vol. 136, no. 4, pp. 350–357, 1998. View at Publisher · View at Google Scholar
  31. J. Grogan, B. H. Nowicki, T. A. Schmidt, and V. M. Haughton, “Lumbar facet joint tropism does not accelerate degeneration of the facet joints,” American Journal of Neuroradiology, vol. 18, no. 7, pp. 1325–1329, 1997. View at Google Scholar
  32. X. Yang and J. Wang, “The affections of the orientations and the severity of degeneration of facet joints to the degenerative lumbar pondylolisthesiss,” Chinese Journal of Spine and Spinal Cord, vol. 19, no. 1, pp. 52–55, 2009. View at Google Scholar
  33. W. Pichaisak, C. Chotiyarnwong, and P. Chotiyarnwong, “Facet joint orientation and tropism in lumbar degenerative disc disease and spondylolisthesis,” Journal of the Medical Association of Thailand, vol. 98, no. 4, pp. 373–379, 2015. View at Google Scholar