Table of Contents Author Guidelines Submit a Manuscript
Journal of Nanomaterials
Volume 2018 (2018), Article ID 2560641, 11 pages
https://doi.org/10.1155/2018/2560641
Research Article

Influence of Milling Time on Structural and Microstructural Parameters of Ni50Ti50 Prepared by Mechanical Alloying Using Rietveld Analysis

1Laboratoire de Physique des Solides, Department of Physics, Faculty of Science, University Badji Mokhtar, Annaba, Algeria
2Laboratoire d’Elaboration et d’Analyse des Materiaux LEAM, Department of Physics, Faculty of Science, University Badji Mokhtar, Annaba, Algeria
3Laboratoire de Microstructures et Defauts, Department of Physics, Faculty of Science, University of Mentouri, Constantine, Algeria
4Department of Physics, College of Science, University of Bahrain, P.O. Box 32038, Manama, Bahrain

Correspondence should be addressed to E. Sakher; gro.abanna-vinu@rehkas.mehafle

Received 16 September 2017; Accepted 5 December 2017; Published 14 January 2018

Academic Editor: Leszek A. Dobrzański

Copyright © 2018 E. Sakher et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

How to Cite this Article

E. Sakher, N. Loudjani, M. Benchiheub, and M. Bououdina, “Influence of Milling Time on Structural and Microstructural Parameters of Ni50Ti50 Prepared by Mechanical Alloying Using Rietveld Analysis,” Journal of Nanomaterials, vol. 2018, Article ID 2560641, 11 pages, 2018. doi:10.1155/2018/2560641