Table of Contents Author Guidelines Submit a Manuscript
Journal of Nanomaterials
Volume 2018, Article ID 6519694, 9 pages
https://doi.org/10.1155/2018/6519694
Research Article

Room Temperature Detection of Acetone by a PANI/Cellulose/WO3 Electrochemical Sensor

1Polymer Group, Engineering and Chemistry of Materials Department, Center of Research on Advanced Materials (CIMAV), Av. Miguel de Cervantes 120, 31136 Chihuahua, CHIH, Mexico
2CONACYT–CIMAV, Av. Miguel de Cervantes 120, 31136 Chihuahua, CHIH, Mexico
3Center of Research on Advanced Materials (CIMAV), Ejido Arroyo Seco, 34147 Durango, DGO, Mexico

Correspondence should be addressed to Alejandro Vega-Rios; xm.ude.vamic@agev.ordnajela

Received 4 September 2017; Revised 13 November 2017; Accepted 6 December 2017; Published 8 January 2018

Academic Editor: Vincenzo Baglio

Copyright © 2018 Eider Aparicio-Martínez et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. J. Arts, J. Mojet, L. v. Gemert et al., “An Analysis of Human Response to the Irritancy of Acetone Vapors,” Critical Reviews in Toxicology, vol. 32, no. 1, pp. 43–66, 2008. View at Publisher · View at Google Scholar
  2. C. J. Wysocki, P. Dalton, M. J. Brody, and H. J. Lawley, “Acetone odor and irritation thresholds obtained from acetone-exposed factory workers and from control (occupationally unexposed) subjects,” American Industrial Hygiene Association Journal, vol. 58, no. 10, pp. 704–712, 1997. View at Publisher · View at Google Scholar · View at Scopus
  3. S. Liu, F. Zhang, H. Li, T. Chen, and Y. Wang, “Acetone detection properties of single crystalline tungsten oxide plates synthesized by hydrothermal method using cetyltrimethyl ammonium bromide supermolecular template,” Sensors and Actuators B: Chemical, vol. 162, no. 1, pp. 259–268, 2012. View at Publisher · View at Google Scholar · View at Scopus
  4. T. Xiao, X.-Y. Wang, Z.-H. Zhao et al., “Highly sensitive and selective acetone sensor based on C-doped WO 3 for potential diagnosis of diabetes mellitus Dedicated to Prof. Xinquan Xin on the occasion of his 80th birthday.,” Sensors and Actuators B: Chemical, vol. 199, pp. 210–219, 2014. View at Publisher · View at Google Scholar · View at Scopus
  5. T. D. C. Minh, D. R. Blake, and P. R. Galassetti, “The clinical potential of exhaled breath analysis for diabetes mellitus,” Diabetes Research and Clinical Practice, vol. 97, no. 2, pp. 195–205, 2012. View at Publisher · View at Google Scholar · View at Scopus
  6. Y. Shimizu and M. Egashira, “Basic aspects and challenges of semiconductor gas sensors,” MRS Bulletin, vol. 24, no. 6, pp. 18–24, 1999. View at Publisher · View at Google Scholar · View at Scopus
  7. Y.-M. Lee and M.-R. Zheng, “Preparation of high-aspect-ratio ZnO nanorod arrays for the detection of several organic solvents at room working temperature,” Applied Surface Science, vol. 285, pp. 241–248, 2013. View at Publisher · View at Google Scholar · View at Scopus
  8. R. Xing, Q. Li, L. Xia et al., “Aumodified threedimensional In2O3 inverse opals: synthesis and improved performance for acetone sensing toward diagnosis of diabetes,” Nanoscale, vol. 7, no. 30, pp. 13051–13060, 2015. View at Google Scholar
  9. K. Khun Khun, A. Mahajan, and R. K. Bedi, “SnO2 thick films for room temperature gas sensing applications,” Journal of Applied Physics, vol. 106, no. 12, Article ID 124509, 2009. View at Publisher · View at Google Scholar · View at Scopus
  10. J. Shi, G. Hu, Y. Sun et al., “WO3 nanocrystals: synthesis and application in highly sensitive detection of acetone,” Sensors and Actuators B: Chemical, vol. 156, no. 2, pp. 820–824, 2011. View at Publisher · View at Google Scholar · View at Scopus
  11. P. P. González-Borrero, F. Sato, A. N. Medina et al., “Optical band-gap determination of nanostructured WO3 film,” Applied Physics Letters, vol. 96, no. 6, Article ID 061909, 2010. View at Publisher · View at Google Scholar
  12. X. Ding, D. Zeng, S. Zhang, and C. Xie, “C-doped WO3 microtubes assembled by nanoparticles with ultrahigh sensitivity to toluene at low operating temperature,” Sensors and Actuators B: Chemical, vol. 155, no. 1, pp. 86–92, 2011. View at Publisher · View at Google Scholar · View at Scopus
  13. U. Patil, N. S. Ramgir, N. Karmakar et al., “Room temperature ammonia sensor based on copper nanoparticle intercalated polyaniline nanocomposite thin films,” Applied Surface Science, vol. 339, pp. 69–74, 2015. View at Publisher · View at Google Scholar
  14. D. K. Bandgar, S. T. Navale, M. Naushad, R. S. Mane, F. J. Stadler, and V. B. Patil, “Ultra-sensitive polyaniline-iron oxide nanocomposite room temperature flexible ammonia sensor,” RSC Advances, vol. 5, no. 84, pp. 68964–68971, 2015. View at Publisher · View at Google Scholar · View at Scopus
  15. M. Parmar, C. Balamurugan, and D.-W. Lee, “PANI and graphene/PANI nanocomposite films--comparative toluene gas sensing behavior,” Sensors, vol. 13, no. 12, pp. 16611–16624, 2013. View at Publisher · View at Google Scholar · View at Scopus
  16. S. M. Hicks and A. J. Killard, “Electrochemical impedance characterisation of tungsten trioxide-polyaniline nanocomposites for room temperature acetone sensing,” Sensors and Actuators B: Chemical, vol. 194, pp. 283–289, 2014. View at Publisher · View at Google Scholar · View at Scopus
  17. S. Bai, Y. Ma, R. Luo, A. Chen, and D. Li, “Room temperature triethylamine sensing properties of polyaniline-WO3 nanocomposites with p-n heterojunctions,” RSC Advances, vol. 6, no. 4, pp. 2687–2694, 2016. View at Publisher · View at Google Scholar · View at Scopus
  18. A. Rahy and D. J. Yang, “Synthesis of highly conductive polyaniline nanofibers,” Materials Letters, vol. 62, no. 28, pp. 4311–4314, 2008. View at Google Scholar
  19. P. Lu and Y.-L. Hsieh, “Preparation and properties of cellulose nanocrystals: rods, spheres, and network,” Carbohydrate Polymers, vol. 82, pp. 329–336, 2010. View at Publisher · View at Google Scholar · View at Scopus
  20. S. Bai, Y. Ma, X. Shu et al., “Doping metal elements of WO,” Industrial & Engineering Chemistry Research, vol. 56, no. 10, pp. 2616–2623, 2017. View at Google Scholar
  21. C. Guo, L. Zhou, and J. Lv, “Potassium Iodate Initiated Polimerization of aniline,” Polymers & Polymer Composites, vol. 21, no. 7, pp. 449–456, 2013. View at Google Scholar
  22. J. Li, X. Tang, H. Li, Y. Yan, and Q. Zhang, “Synthesis and thermoelectric properties of hydrochloric acid-doped polyaniline,” Synthetic Metals, vol. 160, no. 11-12, pp. 1153–1158, 2010. View at Google Scholar
  23. S. Pandey, “Highly sensitive and selective chemiresistor gas/vapor sensors based on polyaniline nanocomposite: a comprehensive review,” Journal of Science: Advanced Materials and Devices, vol. 1, no. 4, pp. 431–453, 2016. View at Google Scholar
  24. P. P. Sahay, “Zinc oxide thin film gas sensor for detection of acetone,” Journal of Materials Science, vol. 40, no. 16, pp. 4383–4385, 2005. View at Publisher · View at Google Scholar · View at Scopus
  25. F. Shaikh, L. Chikhale, J. Patil, I. Mulla, and S. Suryavanshi, “Enhanced acetone sensing performance of nanostructured Sm2O3 doped SnO2 thick films,” Journal of Rare Earths, vol. 35, no. 8, pp. 813–823, 2017. View at Google Scholar
  26. Z. Ling and C. Leach, “The effect of relative humidity on the NO2 sensitivity of a SnO2/WO3 heterojunction gas sensor,” Sensors and Actuators B: Chemical, vol. 102, no. 1, pp. 102–106, 2004. View at Google Scholar
  27. J. Huang, T. Yang, Y. Kang, Y. Wang, and S. Wang, “Gas sensing performance of polyaniline/ZnO organic-inorganic hybrids for detecting VOCs at low temperature,” Journal of Natural Gas Chemistry, vol. 20, no. 5, pp. 515–519, 2011. View at Google Scholar
  28. G. Sakai, N. Matsunaga, K. Shimanoe, and N. Yamazoe, “Theory of gas-diffusion controlled sensitivity for thin film semiconductor gas sensor,” Sensors and Actuators B: Chemical, vol. 80, no. 2, pp. 125–131, 2001. View at Google Scholar