Table of Contents Author Guidelines Submit a Manuscript
Journal of Sensors
Volume 2015 (2015), Article ID 876714, 8 pages
http://dx.doi.org/10.1155/2015/876714
Research Article

Low-Cost Open-Source Voltage and Current Monitor for Gas Metal Arc Weld 3D Printing

1Department of Electrical & Computer Engineering, Michigan Technological University, Houghton, MI 49931, USA
2Department of Materials Science & Engineering, Michigan Technological University, Houghton, MI 49931, USA
3Department of Computer Science, Michigan Technological University, Houghton, MI 49931, USA

Received 24 March 2015; Accepted 22 June 2015

Academic Editor: Christos Riziotis

Copyright © 2015 A. Pinar et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Supplementary Material

The Supplementary Material contains the full bill of materials (BOM) for the voltage and current monitoring circuit discussed in the article. This BOM lists all electrical components required to build a new board from scratch. Mechanical mounting components are not included in this BOM since the mounting method and positioning will generally vary due to the differences in form factors of various welders.

  1. Supplementary Materials