Table of Contents Author Guidelines Submit a Manuscript
Journal of Sensors
Volume 2016, Article ID 2567305, 10 pages
http://dx.doi.org/10.1155/2016/2567305
Research Article

Determining the Optimal Placement of Sensors on a Concrete Arch Dam Using a Quantum Genetic Algorithm

Kai Zhu,1,2,3 Chongshi Gu,1,2,3 Jianchun Qiu,1,2,3 Wanxin Liu,1,2,3 Chunhui Fang,4 and Bo Li5

1State Key Laboratory of Hydrology-Water Resources and Hydraulic Engineering, Hohai University, Nanjing 210098, China
2National Engineering Research Center of Water Resources Efficient Utilization and Engineering Safety, Hohai University, Nanjing 210098, China
3College of Water-Conservancy and Hydropower, Hohai University, Nanjing 210098, China
4Zhejiang Institute of Hydraulics and Estuary, Hangzhou 310020, China
5Engineering Safety and Disaster Prevention Department, Changjiang River Scientific Research Institute, Wuhan 430010, China

Received 18 September 2015; Accepted 1 December 2015

Academic Editor: Kourosh Kalantar-Zadeh

Copyright © 2016 Kai Zhu et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. C. Houqun, H. Shunzai, and S. Kezhong, The Field Test Report of Dynamic Interaction of Dam-Foundation-Water of Dongjiang Arch Dam, China Institute of Water Resources and Hydropower Research, Beijing, China, 1993.
  2. W. Yifeng and G. Ming, “The experimental modal analysis of arch dam,” in Hydro-Science and Engineering, pp. 857–860, 1991. View at Google Scholar
  3. L. Jijian, Z. Jianwei, and L. Huokun, “Study on modal parameter identification of high arch dam under flood discharge excitation,” Journal of Vibration and Shock, vol. 26, no. 12, pp. 101–105, 2007. View at Google Scholar
  4. S. Mridha and D. Maity, “Experimental investigation on nonlinear dynamic response of concrete gravity dam-reservoir system,” Engineering Structures, vol. 80, pp. 289–297, 2014. View at Publisher · View at Google Scholar · View at Scopus
  5. A. C. A. Altunişik, M. Günaydin, B. Sevim, A. Bayraktar, and S. Adanur, “CFRP composite retrofitting effect on the dynamic characteristics of arch dams,” Soil Dynamics & Earthquake Engineering, vol. 74, pp. 1–9, 2015. View at Publisher · View at Google Scholar
  6. G. R. Darbre, C. A. M. De Smet, and C. Kraemer, “Natural frequencies measured from ambient vibration response of the arch dam of Mauvoisin,” Earthquake Engineering and Structural Dynamics, vol. 29, no. 5, pp. 577–586, 2000. View at Publisher · View at Google Scholar · View at Scopus
  7. C.-H. Loh and T.-S. Wu, “Identification of Fei-Tsui arch dam from both ambient and seismic response data,” Soil Dynamics & Earthquake Engineering, vol. 15, no. 7, pp. 465–483, 1996. View at Publisher · View at Google Scholar · View at Scopus
  8. S. T. Mau and S. Wang, “Arch dam system identification using vibration test data,” Earthquake Engineering & Structural Dynamics, vol. 18, no. 4, pp. 491–505, 1989. View at Publisher · View at Google Scholar · View at Scopus
  9. B. Sevim, A. C. Altunişik, and A. Bayraktar, “Earthquake behavior of berke arch dam using ambient vibration test results,” Journal of Performance of Constructed Facilities, vol. 26, no. 6, pp. 780–792, 2012. View at Publisher · View at Google Scholar · View at Scopus
  10. I. Matiss, “Multi-element capacitive sensor for non-destructive measurement of the dielectric permittivity and thickness of dielectric plates and shells,” NDT and E International, vol. 66, pp. 99–105, 2014. View at Publisher · View at Google Scholar · View at Scopus
  11. K. J. Lemler and W. H. Semke, “The reduction of modal sensor channels through a pareto chart methodology,” Journal of Sensors, vol. 2015, Article ID 869258, 10 pages, 2015. View at Publisher · View at Google Scholar
  12. A. Cunha, E. Caetano, and R. Delgado, “Dynamic tests on large cable-stayed bridge,” Journal of Bridge Engineering, vol. 6, no. 1, pp. 54–62, 2001. View at Publisher · View at Google Scholar · View at Scopus
  13. A. K. Pandey, M. Biswas, and M. M. Samman, “Damage detection from changes in curvature mode shapes,” Journal of Sound and Vibration, vol. 145, no. 2, pp. 321–332, 1991. View at Publisher · View at Google Scholar · View at Scopus
  14. M. G. Srinivasan and C. A. Kot, Effect of Damage on the Modal Parameters of a Cylindrical Shell, Argonne National Laboratory, Lemont, Ill, USA, 1992.
  15. D. C. Kammer, “Sensor placement for on-orbit modal identification and correlation of large space structures,” in Proceedings of the American Control Conference, pp. 2984–2990, San Diego, Calif, USA, May 1990.
  16. C. Liu and F. A. Tasker, “Sensor placement for multi-input multi-output dynamic identification,” in Proceedings of the 36th Structures, Structural Dynamics and Materials Conference (SDM '95), AIAA-95-1114-CP, New Orleans, La, USA, April 1995.
  17. T. W. Lim, “Actuator/sensor placement for modal parameter identification of flexible structures,” The International Journal of Analytical & Experimental Modal Analysis, vol. 8, no. 1, pp. 1–13, 1993. View at Google Scholar
  18. E. Rafajłowicz, “Optimal experiment design for identification of linear distributed-parameter systems: frequency domain approach,” IEEE Transactions on Automatic Control, vol. 28, no. 7, pp. 806–808, 1983. View at Google Scholar · View at Scopus
  19. G.-Q. Xing and P. M. Bainum, “Actuator placement using degree of controllability for discrete-time systems,” Control & Dynamic Systems, vol. 79, pp. 51–88, 1996. View at Publisher · View at Google Scholar · View at Scopus
  20. M. Reynier and H. Abou-Kandil, “Sensors location for updating problems,” Mechanical Systems and Signal Processing, vol. 13, no. 2, pp. 297–314, 1999. View at Publisher · View at Google Scholar · View at Scopus
  21. Y.-T. Shih, A. C. Lee, and J.-H. Chen, “Sensor and actuator placement for modal identification,” Mechanical Systems and Signal Processing, vol. 12, no. 5, pp. 641–659, 1998. View at Publisher · View at Google Scholar · View at Scopus
  22. M. Salama, T. Rose, and J. Garba, “Optimal placement of excitations and sensors for verification of large dynamical systems,” in Proceedings of the 28th Structures, Structural Dynamics and Materials Conference (SDM '87), K. T. Kedward, Ed., Monterey, Calif, USA, April 1987.
  23. H. Baruh and K. Choe, “Sensor-failure detection method for flexible structures,” Journal of Guidance, Control, and Dynamics, vol. 10, no. 5, pp. 474–482, 1987. View at Publisher · View at Google Scholar · View at Scopus
  24. T. Breitfeld, “A method for identification of a set of optimal measurement points for experimental modal analysis,” Modal Analysis the International Journal of Analytical & Experimental Modal Analysis, vol. 11, no. 1-2, pp. 1–9, 1996. View at Google Scholar
  25. A. Cruz, W. Vélez, and P. Thomson, “Optimal sensor placement for modal identification of structures using genetic algorithms—a case study: the olympic stadium in Cali, Colombia,” Annals of Operations Research, vol. 181, no. 1, pp. 769–781, 2010. View at Publisher · View at Google Scholar · View at Scopus
  26. N. Debnath, A. Dutta, and S. K. Deb, “Placement of sensors in operational modal analysis for truss bridges,” Mechanical Systems & Signal Processing, vol. 31, no. 8, pp. 196–216, 2012. View at Publisher · View at Google Scholar · View at Scopus
  27. C. Papadimitriou, “Optimal sensor placement methodology for parametric identification of structural systems,” Journal of Sound and Vibration, vol. 278, no. 4-5, pp. 923–947, 2004. View at Publisher · View at Google Scholar · View at Zentralblatt MATH · View at MathSciNet · View at Scopus
  28. J. Liu and W. Huang, “Application of a cumulative method of sensor placement for offshore platforms,” Journal of Ocean University of Qingdao, vol. 33, no. 3, pp. 476–482, 2003. View at Google Scholar
  29. J. Liu and W. P. Huang, “The reduced method of optimal sensor placement,” Ocean Engineering, vol. 22, no. 1, pp. 32–13, 2004. View at Google Scholar
  30. X. K. Lin and B. Y. Qin, “Application of particle swarm optimization to optimal sensor placement,” Control Engineering of China, vol. 20, no. 1, pp. 83–84, 2013. View at Google Scholar
  31. G. Rongxiong, G. Rong, and W. Liqiong, “Study on optimized layout of sensors based on simulated annealing algorithm using mac criterion,” China Municipal Engineering, vol. 5, pp. 103–107, 2014. View at Google Scholar
  32. W. Liu, W.-C. Gao, Y. Sun, and M.-J. Xu, “Optimal sensor placement for spatial lattice structure based on genetic algorithms,” Journal of Sound & Vibration, vol. 317, no. 1-2, pp. 175–189, 2008. View at Publisher · View at Google Scholar · View at Scopus
  33. Z. Shu, P. Wei, Z. Wei-Li, and D. Ying, “A novel quantum genetic algorithm based on particle swarm optimization method and its application,” Acta Electronica Sinica, vol. 34, no. 5, pp. 897–901, 2006. View at Google Scholar · View at Scopus
  34. K.-H. Han and J.-H. Kim, “Genetic quantum algorithm and its application to combinatorial optimization problem,” in Proceedings of the Congress on Evolutionary Computation, vol. 2, pp. 1354–1360, IEEE, La Jolla, Calif, USA, July 2000. View at Publisher · View at Google Scholar
  35. F. Kang, J.-J. Li, and Q. Xu, “Virus coevolution partheno-genetic algorithms for optimal sensor placement,” Advanced Engineering Informatics, vol. 22, no. 3, pp. 362–370, 2008. View at Publisher · View at Google Scholar · View at Scopus
  36. Y. Zhiyuan, The Research of the Theory and Method for the Modal Identification of Huge Engineering Structures, Southeast University, Nanjing, China, 2004.
  37. M. Meo and G. Zumpano, “On the optimal sensor placement techniques for a bridge structure,” Engineering Structures, vol. 27, no. 10, pp. 1488–1497, 2005. View at Publisher · View at Google Scholar · View at Scopus
  38. V. Meruane and W. Heylen, “An hybrid real genetic algorithm to detect structural damage using modal properties,” Mechanical Systems and Signal Processing, vol. 25, no. 5, pp. 1559–1573, 2011. View at Publisher · View at Google Scholar · View at Scopus
  39. S. V. Calcina, L. Eltrudis, L. Piroddi, and G. Ranieri, “Ambient vibration tests of an arch dam with different reservoir water levels: experimental results and comparison with finite element modelling,” The Scientific World Journal, vol. 2014, Article ID 692709, 12 pages, 2014. View at Publisher · View at Google Scholar · View at Scopus
  40. H. M. Westergaard, “Water pressures on dams during earthquakes,” Transactions of the American Society of Civil Engineers, vol. 98, no. 2, pp. 418–432, 1933. View at Google Scholar
  41. C. Rainieri and G. Fabbrocino, Operational Modal Analysis of Civil Engineering Structures, Springer, New York, NY, USA, 2014.
  42. A. Lazaridis, “A note regarding the condition number: the case of spurious and latent multicollinearity,” Quality & Quantity, vol. 41, no. 1, pp. 123–135, 2007. View at Publisher · View at Google Scholar · View at Scopus