Table of Contents Author Guidelines Submit a Manuscript
Mathematical Problems in Engineering
Volume 2006, Article ID 48542, 13 pages
http://dx.doi.org/10.1155/MPE/2006/48542

Levenberg-Marquardt application to two-phase nonlinear parameter estimation for finned-tube coil evaporators

1Products Research & Development, Tecumseh do Brasil Ltda, P. O. Box 54, São Carlos, SP CEP 13565-900, Brazil
2Department of Mechanical Engineering, São Paulo State University, (UNESP), P. O. Box 31, Ilha Solteira, SP CEP 15385-000, Brazil

Received 30 August 2004; Revised 19 June 2005; Accepted 7 July 2005

Copyright © 2006 S. S. Bueno et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. ASHRAE, Fundamental Handbook, American Society of Heating, Refrigerating and Air-Conditioning Engineers, Georgia, 1993, chapter 6.
  2. P. E. L. Barbieri, Dynamic analysis of evaporators with finned tube coils, M.Sc. Thesis, Department of Mechanical Engineering, São Paulo State University - UNESP, São Paulo, 2001.
  3. J. C. Chen, “A correlation for boiling heat transfer to saturated fluids in convective flow,” Industrial and Engineering Chemistry Process Design and Development, vol. 5, no. 3, pp. 322–329, 1966. View at Google Scholar
  4. S. W. Churchill, “Friction factor equation spans all fluid flow regimes,” Chemical Engineering, vol. 84, no. 24, pp. 91–92, 1977. View at Google Scholar
  5. F. W. Dittus and L. M. K. Boelter, Heat Transfer in Automobile Radiators of the Tubular Type, vol. 2 of University of California Publications in Engineering, University of California Press, Berkeley, 1930.
  6. F. P. Incropera and D. P. Dewitt, Fundamentals of Heat and Mass Transfer, John Wiley & Sons, New York, 2003.
  7. X. Jia, C. P. Tso, P. Jolly, and Y. W. Wong, “Distributed steady and dynamic modelling of dry-expansion evaporators,” International Journal of Refrigeration, vol. 22, no. 2, pp. 126–136, 1999. View at Google Scholar
  8. S. D. Jung and R. Radermacher, “Prediction of heat transfer coefficients of various refrigerants during evaporation,” ASHRAE Transactions, vol. 97, pp. part 2, 48–53, 1991. View at Google Scholar
  9. S. Y. Liang, M. Liu, T. N. Wong, and G. K. Nathan, “Analytical study of evaporator coil in humid environment,” Applied Thermal Engineering, vol. 19, no. 11, pp. 1129–1145, 1999. View at Google Scholar
  10. S. Y. Liang, T. N. Wong, and G. K. Nathan, “Numerical and experimental studies of refrigerant circuitry of evaporator coils,” International Journal of Refrigeration, vol. 24, no. 8, pp. 823–833, 2001. View at Google Scholar
  11. M. O. McLinden, S. A. Klein, E. W. Lemmon, and A. P. Peskin, “Users' Guide: Thermodynamic and Transport Properties of Refrigerants and Refrigerant Mixtures—REFPROP,” Software Version 6.0, National Institute of Standards and Technology, Colorado, 1998.
  12. F. C. McQuiston, “Finned tube heat exchangers: state of the art for the air side,” ASHRAE Transactions, vol. 87, pp. 1077–1085, 1981. View at Google Scholar
  13. F. C. McQuiston and J. D. Parker, Heating, Ventilating and Air Conditioning: Analysis and Design, John Wiley & Sons, New York, 4th edition, 1994.
  14. A. Paliwoda, “Generalized method of pressure drop and tube length calculation with boiling and condensing refrigerants within the entire zone of saturation,” International Journal of Refrigeration, vol. 12, no. 6, pp. 314–322, 1989. View at Google Scholar
  15. M. Turaga, S. Lin, and P. P. Fazio, “Correlation for heat transfer and pressure drop factors for direct expansion air cooling and dehumidifying coils,” ASHRAE Transactions, \textbf{94} (1988), part 2, 616–629.