Table of Contents Author Guidelines Submit a Manuscript
Mathematical Problems in Engineering
Volume 2013, Article ID 816385, 8 pages
http://dx.doi.org/10.1155/2013/816385
Research Article

Analytic Solutions for Heat Conduction in Functionally Graded Circular Hollow Cylinders with Time-Dependent Boundary Conditions

Department of Mechanical Engineering, National Cheng Kung University, Tainan 701, Taiwan

Received 16 May 2013; Revised 27 June 2013; Accepted 1 July 2013

Academic Editor: Abdelouahed Tounsi

Copyright © 2013 Sen-Yung Lee and Chih-Cheng Huang. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. M. N. Őzisik, Boundary Value Problems of Heat Conduction, International Textbook Company, Scranton, Pa, USA, 1st edition, 1968.
  2. Y. Obata and N. Noda, “Steady thermal stresses in a hollow circular cylinder and a hollow sphere of a functionally gradient material,” Journal of Thermal Stresses, vol. 17, no. 3, pp. 471–487, 1994. View at Google Scholar · View at Scopus
  3. H. Awaji and R. Sivakumar, “Temperature and stress distributions in a hollow cylinder of functionally graded material: the case of temperature-independent material properties,” Journal of the American Ceramic Society, vol. 84, no. 5, pp. 1059–1065, 2001. View at Google Scholar · View at Scopus
  4. G. N. Praveen and J. N. Reddy, “Nonlinear transient thermoelastic analysis of functionally graded ceramic-metal plates,” International Journal of Solids and Structures, vol. 35, no. 33, pp. 4457–4476, 1998. View at Google Scholar · View at Scopus
  5. M. Jabbari, S. Sohrabpour, and M. R. Eslami, “Mechanical and thermal stresses in a functionally graded hollow cylinder due to radially symmetric loads,” International Journal of Pressure Vessels and Piping, vol. 79, no. 7, pp. 493–497, 2002. View at Publisher · View at Google Scholar · View at Scopus
  6. M. Jabbari, S. Sohrabpour, and M. R. Eslami, “General solution for mechanical and thermal stresses in a functionally graded hollow cylinder due to nonaxisymmetric steady-state loads,” ASME Transactions Journal of Applied Mechanics, vol. 70, no. 1, pp. 111–118, 2003. View at Publisher · View at Google Scholar · View at Scopus
  7. Y. Ootao and Y. Tanigawa, “Transient thermoelastic analysis for a functionally graded hollow cylinder,” Journal of Thermal Stresses, vol. 29, no. 11, pp. 1031–1046, 2006. View at Publisher · View at Google Scholar · View at Scopus
  8. J. Zhao, X. Ai, Y. Li, and Y. Zhou, “Thermal shock resistance of functionally gradient solid cylinders,” Materials Science and Engineering A, vol. 418, no. 1-2, pp. 99–110, 2006. View at Publisher · View at Google Scholar · View at Scopus
  9. S. M. Hosseini, M. Akhlaghi, and M. Shakeri, “Transient heat conduction in functionally graded thick hollow cylinders by analytical method,” Heat and Mass Transfer, vol. 43, no. 7, pp. 669–675, 2007. View at Publisher · View at Google Scholar · View at Scopus
  10. Y. Ootao, T. Akai, and Y. Tanigawa, “Three-dimensional transient thermal stress analysis of a nonhomogeneous hollow circular cylinder due to a moving heat source in the axial direction,” Journal of Thermal Stresses, vol. 18, no. 5, pp. 497–512, 1995. View at Google Scholar · View at Scopus
  11. Z. S. Shao and G. W. Ma, “Thermo-mechanical stresses in functionally graded circular hollow cylinder with linearly increasing boundary temperature,” Composite Structures, vol. 83, no. 3, pp. 259–265, 2008. View at Publisher · View at Google Scholar · View at Scopus
  12. M. Jabbari, A. H. Mohazzab, and A. Bahtui, “One-dimensional moving heat source in a hollow FGM cylinder,” ASME Transactions Journal of Pressure Vessel Technology, vol. 131, no. 2, article 021202, 7 pages, 2009. View at Publisher · View at Google Scholar · View at Scopus
  13. M. Asgari and M. Akhlaghi, “Transient thermal stresses in two-dimensional functionally graded thick hollow cylinder with finite length,” Archive of Applied Mechanics, vol. 80, no. 4, pp. 353–376, 2010. View at Publisher · View at Google Scholar · View at Scopus
  14. S. Singh, P. K. Jain, and R.-U. Rizwan-Uddin, “Finite integral transform method to solve asymmetric heat conduction in a multilayer annulus with time-dependent boundary conditions,” Nuclear Engineering and Design, vol. 241, no. 1, pp. 144–154, 2011. View at Publisher · View at Google Scholar · View at Scopus
  15. P. Malekzadeh and Y. Heydarpour, “Response of functionally graded cylindrical shells under moving thermo-mechanical loads,” Thin-Walled Structures, vol. 58, pp. 51–66, 2012. View at Google Scholar
  16. H. M. Wang and C. B. Liu, “Analytical solution of two-dimensional transient heat conduction in fiber-reinforced cylindrical composites,” International Journal of Thermal Sciences, vol. 69, pp. 43–52, 2013. View at Google Scholar
  17. S. Y. Lee and S. M. Lin, “Dynamic analysis of nonuniform beams with time-dependent elastic boundary conditions,” ASME Transactions Journal of Applied Mechanics, vol. 63, no. 2, pp. 474–478, 1996. View at Google Scholar · View at Scopus
  18. H. T. Chen, S. L. Sun, H. C. Huang, and S. Y. Lee, “Analytic closed solution for the heat conduction with time dependent heat convection coefficient at one boundary,” Computer Modeling in Engineering and Sciences, vol. 59, no. 2, pp. 107–126, 2010. View at Google Scholar · View at MathSciNet · View at Scopus