Table of Contents Author Guidelines Submit a Manuscript
Mathematical Problems in Engineering
Volume 2014, Article ID 512406, 10 pages
http://dx.doi.org/10.1155/2014/512406
Research Article

Simulation and Experimental Investigation on the AE Tomography to Improve AE Source Location in the Concrete Structure

1School of Mechanical Engineering, Southeast University, Nanjing 211189, China
2School of Science, Nanjing University of Technology, Nanjing 210009, China
3Department of Applied Physics, University of Granada, 18071 Granada, Spain

Received 12 February 2014; Revised 29 April 2014; Accepted 8 May 2014; Published 8 June 2014

Academic Editor: Qingsong Xu

Copyright © 2014 Yu Jiang et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. T. Shiotani, S. Momoki, H. Chai, and D. G. Aggelis, “Elastic wave validation of large concrete structures repaired by means of cement grouting,” Construction and Building Materials, vol. 23, no. 7, pp. 2647–2652, 2009. View at Publisher · View at Google Scholar · View at Scopus
  2. D. G. Aggelis and T. Shiotani, “Repair evaluation of concrete cracks using surface and through-transmission wave measurements,” Cement and Concrete Composites, vol. 29, no. 9, pp. 700–711, 2007. View at Publisher · View at Google Scholar · View at Scopus
  3. T. Shiotani, D. G. Aggelis, and O. Makishima, “Global monitoring of large concrete structures using acoustic emission and ultrasonic techniques: case study,” Journal of Bridge Engineering, vol. 14, no. 3, pp. 188–192, 2009. View at Publisher · View at Google Scholar · View at Scopus
  4. T. Shiotani, D. G. Aggelis, and O. Makishima, “Global monitoring of concrete bridge using acoustic emission,” Journal of Acoustic Emission, vol. 25, pp. 308–315, 2007. View at Google Scholar
  5. F. Ito, F. Nakahara, R. Kawano, S. S. Kang, and Y. Obara, “Visualization of failure in a pull-out test of cable bolts using X-ray CT,” Construction and Building Materials, vol. 15, pp. 263–270, 2001. View at Google Scholar
  6. E. Maire, V. Carmona, J. Courbon, and W. Ludwig, “Fast X-ray tomography and acoustic emission study of damage in metals during continuous tensile tests,” Acta Materialia, vol. 55, no. 20, pp. 6806–6815, 2007. View at Publisher · View at Google Scholar · View at Scopus
  7. E. Kase and T. Ross, “Using seismic tomography and holography ground imaging to improve site investigation,” in Proceedings of the No-Dig Conference, New Orleans, La, USA, 2004, paper no. C-4-02.
  8. L. Liu and T. Guo, “Seismic non-destructive testing on a reinforced concrete bridge column using tomographic imaging techniques,” Journal of Geophysics and Engineering, vol. 2, no. 1, pp. 23–31, 2005. View at Publisher · View at Google Scholar · View at Scopus
  9. A. A. Shah and Y. Ribakov, “Effectiveness of nonlinear ultrasonic and acoustic emission evaluation of concrete with distributed damages,” Materials and Design, vol. 31, no. 8, pp. 3777–3784, 2010. View at Publisher · View at Google Scholar · View at Scopus
  10. R. K. Miller and P. McIntire, “Acoustic emission testing,” in NDT Handbook, vol. 5, American Society for Non-Destructive Testing, Columbus, Ohio, USA, 1987. View at Google Scholar
  11. H. J. Rindorf, “Acoustic emission source location in theory and in practice,” Bruel and Kjaer Technical Review, vol. 2, pp. 3–44, 1981. View at Google Scholar · View at Scopus
  12. R. Pullin, Structural integrity monitoring of steel bridges using acoustic emission techniques [Ph.D. thesis], Division of Mechanical Engineering and Energy Studies, 2001.
  13. Division of Mechanical Engineering and Energy Studies, University of Wales, Cardiff, UK, 2001.
  14. K. L. Rens, D. J. Transue, and M. P. Schuller, “Acoustic tomographic imaging of concrete infrastructure,” Journal of Infrastructure Systems, vol. 6, no. 1, pp. 15–23, 2000. View at Publisher · View at Google Scholar · View at Scopus
  15. F. Schubert, “Tomography techniques for acoustic emission monitoring,” in Proceedings of the 28th European Conference on NDT, Berlin, Germany, September 2006, ECNDT2006.
  16. J. A. Baron and S. P. Ying, “Acoustic emission source location,” in Non-Destructive Testing Handbook, American Society for Non-Destructive Testing, Columbus, Ohio, USA, 1987. View at Google Scholar
  17. A. C. Kak and M. Slaney, Principles of Computerized Tomographic Imaging, IEEE Press, New York, NY, USA, 1988. View at MathSciNet
  18. N. Diamanti, A. Giannopoulos, and M. C. Forde, “Numerical modelling and experimental verification of GPR to investigate ring separation in brick masonry arch bridges,” NDT & E International, vol. 41, no. 5, pp. 354–363, 2008. View at Publisher · View at Google Scholar · View at Scopus
  19. K. M. Holford and D. C. Carter, “Acoustic emission source location,” Key Engineering Materials, vol. 167, pp. 162–171, 1999. View at Google Scholar · View at Scopus
  20. F. Schubert, “Basic principles of acoustic emission tomography,” Journal of Acoustic Emission, vol. 22, pp. 147–158, 2004. View at Google Scholar
  21. D. G. Aggelis, “Damage characterisation of inhomogeneous materials: experiments and numerical simulations of wave propagation,” Strain, vol. 47, no. 6, pp. 525–533, 2011. View at Publisher · View at Google Scholar · View at Scopus
  22. S. Q. Fan, S. D. Zhao, Q. Zhang, and Y. Y. Li, “Plastic mechanism of multi-pass double-roller clamping spinning for arc-shaped surface flange,” Chinese Journal of Mechanical Engineering, vol. 26, no. 6, pp. 1127–1137, 2013. View at Publisher · View at Google Scholar
  23. ABAQUS, Inc., ABAQUS Analysis User's Manual, Version 6.8, 2008.