Table of Contents Author Guidelines Submit a Manuscript
Mathematical Problems in Engineering
Volume 2016, Article ID 1070517, 10 pages
http://dx.doi.org/10.1155/2016/1070517
Research Article

Modeling and Extended State Observer Based Dynamic Surface Control for Cold Rolling Mill System

1The State Key Laboratory of Rolling Automation, Northeastern University, Shenyang 110819, China
2School of Resources and Materials, Northeastern University, Qinhuangdao Branch, Qinhuangdao 066004, China

Received 23 September 2015; Revised 17 January 2016; Accepted 16 February 2016

Academic Editor: Thierry Floquet

Copyright © 2016 Xu Li and Xin Zhang. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. W. Soszyński and A. Studnicka, “A review of contemporary solutions for cold rolling that allow quality improvement,” Journal of Achievements in Materials and Manufacturing Engineering, vol. 55, no. 2, pp. 810–816, 2012. View at Google Scholar
  2. X.-Y. Xu, Z.-W. Bu, Y.-L. Cai, and X.-Y. Xu, “Fuzzy logic based thickness control system and its simulation,” in Proceedings of the 1st International Conference on Information Science and Engineering (ICISE '09), pp. 3792–3795, Nanjing, China, December 2009. View at Publisher · View at Google Scholar · View at Scopus
  3. C. C. Hua and C. Yu, “Controller design for cold rolling mill HAGC system with measurement delay perturbation,” Journal of Mechanical Engineering, vol. 50, no. 20, pp. 46–53, 2014. View at Publisher · View at Google Scholar · View at Scopus
  4. Z. Gang, Y. Yuan, and L. Haowen, “Research on modeling of Hydraulic rolling mill,” in Proceedings of the Chinese Control and Decision Conference (CCDC '11), pp. 1814–1818, IEEE, Mianyang, China, May 2011. View at Publisher · View at Google Scholar · View at Scopus
  5. S. H. Li, J. Yang, W.-H. Chen, and X. S. Chen, “Generalized extended state observer based control for systems with mismatched uncertainties,” IEEE Transactions on Industrial Electronics, vol. 59, no. 12, pp. 4792–4802, 2012. View at Publisher · View at Google Scholar · View at Scopus
  6. S. N. Huang, K. K. Tan, and T. H. Lee, “Further result on a dynamic recurrent neural-network-based adaptive observer for a class of nonlinear systems,” Automatica, vol. 41, no. 12, pp. 2161–2162, 2005. View at Publisher · View at Google Scholar · View at MathSciNet · View at Scopus
  7. X. W. Dai, Z. W. Gao, T. Breikin, and H. Wang, “High-gain observer-based estimation of parameter variations with delay alignment,” IEEE Transactions on Automatic Control, vol. 57, no. 3, pp. 726–732, 2012. View at Publisher · View at Google Scholar · View at MathSciNet · View at Scopus
  8. K. C. Veluvolu and D. Lee, “Sliding mode high-gain observers for a class of uncertain nonlinear systems,” Applied Mathematics Letters, vol. 24, no. 3, pp. 329–334, 2011. View at Publisher · View at Google Scholar · View at MathSciNet · View at Scopus
  9. A. A. Godbole, J. P. Kolhe, and S. E. Talole, “Performance analysis of generalized extended state observer in tackling sinusoidal disturbances,” IEEE Transactions on Control Systems Technology, vol. 21, no. 6, pp. 2212–2223, 2013. View at Publisher · View at Google Scholar · View at Scopus
  10. Z. Zhu, D. Xu, J. Liu, and Y. Xia, “Missile guidance law based on extended state observer,” IEEE Transactions on Industrial Electronics, vol. 60, no. 12, pp. 5882–5891, 2013. View at Publisher · View at Google Scholar · View at Scopus
  11. H. Liu and S. Li, “Speed control for PMSM servo system using predictive functional control and extended state observer,” IEEE Transactions on Industrial Electronics, vol. 59, no. 2, pp. 1171–1183, 2012. View at Publisher · View at Google Scholar · View at Scopus
  12. X. Shi and S. Chang, “Extended state observer-based time-optimal control for fast and precise point-to-point motions driven by a novel electromagnetic linear actuator,” Mechatronics, vol. 23, no. 4, pp. 445–451, 2013. View at Publisher · View at Google Scholar · View at Scopus
  13. S. C. Tong, Y. M. Li, and P. Shi, “Observer-based adaptive fuzzy backstepping output feedback control of uncertain MIMO pure-feedback nonlinear systems,” IEEE Transactions on Fuzzy Systems, vol. 20, no. 4, pp. 771–785, 2012. View at Publisher · View at Google Scholar · View at Scopus
  14. C. Hua, P. X. Liu, and X. Guan, “Backstepping control for nonlinear systems with time delays and applications to chemical reactor systems,” IEEE Transactions on Industrial Electronics, vol. 56, no. 9, pp. 3723–3732, 2009. View at Publisher · View at Google Scholar · View at Scopus
  15. C. Hua and Y. Li, “Output feedback prescribed performance control for interconnected time-delay systems with unknown Prandtl-Ishlinskii hysteresis,” Journal of the Franklin Institute, vol. 352, no. 7, pp. 2750–2764, 2015. View at Publisher · View at Google Scholar · View at MathSciNet
  16. C. C. Hua, G. Liu, L. Zhang, and X. Guan, “Output feedback tracking control for nonlinear time-delay systems with tracking errors and input constraints,” Neurocomputing, vol. 173, pp. 751–758, 2016. View at Publisher · View at Google Scholar
  17. D. Swaroop, J. K. Hedrick, P. P. Yip, and J. Gerdes, “Dynamic surface control for a class of nonlinear systems,” IEEE Transactions on Automatic Control, vol. 45, no. 10, pp. 1893–1899, 2000. View at Publisher · View at Google Scholar · View at MathSciNet · View at Scopus
  18. N. Qaiser, N. Iqbal, A. Hussain, and N. Qaiser, “Exponential stabilization of a class of underactuated mechanical systems using dynamic surface control,” International Journal of Control, Automation and Systems, vol. 5, no. 5, pp. 547–558, 2007. View at Google Scholar · View at Scopus
  19. X. Xia and T. Zhang, “Adaptive output feedback dynamic surface control of nonlinear systems with unmodeled dynamics and unknown high-frequency gain sign,” Neurocomputing, vol. 143, no. 2, pp. 312–321, 2014. View at Publisher · View at Google Scholar · View at Scopus
  20. B. Song, “Robust stabilization of decentralized dynamic surface control for a class of interconnected nonlinear systems,” International Journal of Control, Automation and Systems, vol. 5, no. 2, pp. 138–146, 2007. View at Google Scholar · View at Scopus
  21. J. B. Park, S. J. Yoo, and Y. H. Choi, “Output feedback dynamic surface control of flexible-joint robots,” International Journal of Control, Automation and Systems, vol. 6, no. 2, pp. 223–233, 2008. View at Google Scholar · View at Scopus
  22. S. J. Yoo, J. B. Park, and Y. H. Choi, “Adaptive dynamic surface control for stabilization of parametric strict-feedback nonlinear systems with unknown time delays,” IEEE Transactions on Automatic Control, vol. 52, no. 12, pp. 2360–2365, 2007. View at Publisher · View at Google Scholar · View at MathSciNet · View at Scopus
  23. Y. Cui, H. Zhang, Y. Wang, and Z. Zhang, “Adaptive neural dynamic surface control for a class of uncertain nonlinear systems with disturbances,” Neurocomputing, vol. 165, pp. 152–158, 2015. View at Publisher · View at Google Scholar
  24. M. H. Sun, W. Zhang, and Y. Q. Wang, “Modeling and simulation on screw-down electric-hydraulic servo system of cold rolling mill based on virtual rolling,” Machine Tool & Hydraulics, vol. 40, no. 9, pp. 144–146, 2012. View at Google Scholar
  25. X. Yang and Y. Huang, “Capabilities of extended state observer for estimating uncertainties,” in Proceedings of the American Control Conference (ACC '09), pp. 3700–3705, IEEE, St. Louis, Mo, USA, June 2009. View at Publisher · View at Google Scholar