Table of Contents Author Guidelines Submit a Manuscript
Mathematical Problems in Engineering
Volume 2017, Article ID 1387210, 15 pages
https://doi.org/10.1155/2017/1387210
Research Article

Effects of Impeller Diameter on High-Speed Rescue Pump

1National Research Center of Pumps, Jiangsu University, Zhenjiang, Jiangsu 212013, China
2College of Mechanical Engineering, Wuxi Institute of Technology, Wuxi, Jiangsu 214121, China

Correspondence should be addressed to Yuxing Bai; moc.361@2101iabxy

Received 25 May 2017; Revised 1 October 2017; Accepted 1 November 2017; Published 29 November 2017

Academic Editor: Andrea L. Facci

Copyright © 2017 Yuxing Bai et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. S. N. Dong, “Current situation and prospect of coal mine geological guarantee technologies to improve safety and efficiency,” Coal Science & Technology, vol. 35, no. 3, pp. 1–5, 2007. View at Google Scholar
  2. S. P. Peng, “Present study and development trend of the deepen coal resource distribution and mining geologic evaluation,” Coal, vol. 17, no. 2, pp. 1–11, 2008. View at Google Scholar
  3. D. W. Jin, Q. S. Liu, and L. Wang, “Development and prospect of coal deposit hydrogeology,” Coal Geology & Exploration, vol. 37, no. 5, pp. 28–31, 2009. View at Google Scholar
  4. Q. Wu, “Progress, problems and prospects of prevention and control technology of mine water and reutilization in China,” Journal of the China Coal Society, vol. 39, no. 5, pp. 795–805, 2014. View at Google Scholar · View at Scopus
  5. J. Zhu, H. Banjar, Z. Xia, and H.-Q. Zhang, “CFD simulation and experimental study of oil viscosity effect on multi-stage electrical submersible pump (ESP) performance,” Journal of Petroleum Science and Engineering, vol. 146, pp. 735–745, 2016. View at Publisher · View at Google Scholar · View at Scopus
  6. J. Feng, F.-K. Benra, and H. J. Dohmen, “Investigation of periodically unsteady flow in a radial pump by CFD simulations and LDV measurements,” Journal of Turbomachinery, vol. 133, no. 1, Article ID 011004, pp. 1–4, 2011. View at Publisher · View at Google Scholar · View at Scopus
  7. H.-X. Cui, K. Feng, H.-L. Li, and J.-H. Han, “Response characteristics analysis and optimization design of load sensing variable pump,” Mathematical Problems in Engineering, vol. 2016, Article ID 6379121, 10 pages, 2016. View at Publisher · View at Google Scholar · View at Scopus
  8. F. Yang, H.-R. Zhao, and C. Liu, “Improvement of the efficiency of the axial-flow pump at part loads due to installing outlet guide vanes mechanism,” Mathematical Problems in Engineering, vol. 2016, Article ID 6375314, 10 pages, 2016. View at Publisher · View at Google Scholar · View at Scopus
  9. L. J. Barrios, S. L. Scott, and K. K. Sheth, “ESP technology maturation: subsea boosting system with high GOR and viscous fluids,” in Proceedings of the SPE Annual Technical Conference and Exhibition 2012: Unconventional Wisdom (ATCE '12), vol. 2, pp. 1580–1601, October 2012. View at Scopus
  10. C. Maitelli, V. Bezerra, and W. D. Mata, “Simulation of flow in a centrifugal pump of ESP systems using computational fluid dynamics,” Brazilian Journal of Petroleum & Gas, vol. 4, pp. 1–9, 2010. View at Google Scholar
  11. R. Barrio, J. Parrondo, and E. Blanco, “Numerical analysis of the unsteady flow in the near-tongue region in a volute-type centrifugal pump for different operating points,” Computers & Fluids, vol. 39, no. 5, pp. 859–870, 2010. View at Publisher · View at Google Scholar · View at Scopus
  12. L. Yun, Z. Rongsheng, W. Dezhong, Y. Junlian, and L. Tianbin, “Numerical and experimental investigation on the diffuser optimization of a reactor coolant pump with orthogonal test approach,” Journal of Mechanical Science and Technology, vol. 30, no. 11, pp. 4941–4948, 2016. View at Publisher · View at Google Scholar · View at Scopus
  13. J. Skrzypacz, “Investigating the impact of multi-piped impellers design on the efficiency of rotodynamic pumps operating at ultra-low specific speed,” Chemical Engineering and Processing: Process Intensification, vol. 86, pp. 145–152, 2014. View at Publisher · View at Google Scholar · View at Scopus
  14. A. Boccazzi, R. Sala, and P. Gaetani, “Flow field in the vaned diffuser of a centrifugal pump at different vane setting angles,” Asme-Jsme-Ksme Joint Fluids Engineering Conference, vol. 134, no. 3, pp. 369–380, 2011. View at Publisher · View at Google Scholar · View at Scopus
  15. Z. Gao, W. Zhu, L. Lu, J. Deng, J. Zhang, and F. Wuang, “Numerical and experimental study of unsteady flow in a large centrifugal pump with stay vanes,” Journal of Fluids Engineering, vol. 136, no. 7, Article ID 071101, 2014. View at Publisher · View at Google Scholar · View at Scopus
  16. N. Zhang, M. Yang, B. Gao, Z. Li, and D. Ni, “Experimental investigation on unsteady pressure pulsation in a centrifugal pump with special slope volute,” Journal of Fluids Engineering, vol. 137, no. 6, Article ID 061103, 2015. View at Publisher · View at Google Scholar · View at Scopus
  17. J. Pei, S. Yuan, F.-K. Benra, and H. J. Dohmen, “Numerical prediction of unsteady pressure field within the whole flow passage of a radial single-blade pump,” Journal of Fluids Engineering, vol. 134, no. 10, Article ID 101103, 2012. View at Publisher · View at Google Scholar · View at Scopus
  18. J. Pei, S.-Q. Yuan, X.-J. Li, and J.-P. Yuan, “Numerical prediction of 3-D periodic flow unsteadiness in a centrifugal pump under part-load condition,” Journal of Hydrodynamics, vol. 26, no. 2, pp. 257–263, 2014. View at Publisher · View at Google Scholar · View at Scopus
  19. J. Pei, S.-Q. Yuan, J.-P. Yuan, and W.-J. Wang, “The influence of the flow rate on periodic flow unsteadiness behaviors in a sewage centrifugal pump,” Journal of Hydrodynamics, vol. 25, no. 5, pp. 702–709, 2013. View at Publisher · View at Google Scholar · View at Scopus
  20. G. Singh and J. W. Mitchell, “Energy savings: From pump impeller trimming,” ASHRAE Journal, vol. 51, no. 11, pp. 34–44, 2009. View at Google Scholar · View at Scopus
  21. L. M. Tsang, “A theoretical account of impeller trimming of the centrifugal pump,” Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, vol. 206, no. 3, pp. 213-214, 1992. View at Publisher · View at Google Scholar · View at Scopus
  22. G. Singh, Energy and Environmental Benefits of Pump Impeller Trimming in Commercial Building Heating and Cooling Systems [PhD. Thesis], University of Wisconsin-Madison, 1997. View at Publisher · View at Google Scholar
  23. P. Singh and F. Nestmann, “Internal hydraulic analysis of impeller rounding in centrifugal pumps as turbines,” Experimental Thermal and Fluid Science, vol. 35, no. 1, pp. 121–134, 2011. View at Publisher · View at Google Scholar · View at Scopus
  24. S. V. Jain, A. Swarnkar, K. H. Motwani, and R. N. Patel, “Effects of impeller diameter and rotational speed on performance of pump running in turbine mode,” Energy Conversion and Management, vol. 89, no. 1, pp. 808–824, 2015. View at Publisher · View at Google Scholar · View at Scopus
  25. R. Barrio, E. Blanco, J. Parrondo, J. González, and J. Fernández, “The effect of impeller cutback on the fluid-dynamic pulsations and load at the blade-passing frequency in a centrifugal pump,” Journal of Fluids Engineering, vol. 130, no. 11, pp. 1111021–11110211, 2008. View at Publisher · View at Google Scholar · View at Scopus
  26. M. Šavar, H. Kozmar, and I. Sutlović, “Improving centrifugal pump efficiency by impeller trimming,” Desalination, vol. 249, no. 2, pp. 654–659, 2009. View at Publisher · View at Google Scholar · View at Scopus
  27. Y. Wang and J. Q. Liu, “Impeller trim of super-low specific speed centrifugal pump based on numerical simulation of 3D flow field,” Transactions of the Chinese Society of Agricultural Machinery, vol. 43, no. 5, pp. 79–83, 2012. View at Publisher · View at Google Scholar · View at Scopus
  28. D. S. Zhang, C. Wang, and W. D. Shi, “Establishment and experiment of impeller cutting law of double channel pump,” Transactions of the Chinese Society for Agricultural Machinery, vol. 45, no. 1, pp. 73–78, 2014. View at Publisher · View at Google Scholar · View at Scopus
  29. P. Zhou, J. Tang, J. Mou, and B. Zhu, “Effect of impeller trimming on performance,” World Pumps, vol. 2016, no. 9, pp. 38–41, 2016. View at Publisher · View at Google Scholar · View at Scopus
  30. M. A. Yates and I. Weybourne, “Improving the energy efficiency of pumping systems,” Iwa Publishing, vol. 50, no. 2, pp. 101–111, 2001. View at Google Scholar
  31. T. Q. Luo, Z. X. Cheng, and Y. Z. Xie, Hydrodynamics, China Machine Press, Beijing, China, 2007.
  32. C. G. Lu, Numerical Methods in Hydrodynamics, Science Press, Beijing, China, 2014.
  33. X. F. Guan, Modern Pumps Theory and Design, China Astronautic Press, 2011.
  34. “ANSYS User Manual 14.0,” ANSUS Inc, 2011.