Abstract

This paper deals with a design problem of an adaptive robust controller for a class of nonlinear systems with specified input saturations. For the nonlinear system under consideration, the nonlinearity means unknown perturbations and satisfies the matching condition. In this paper, we show that sufficient conditions for the existence of the proposed adaptive robust controller giving consideration to input saturations are given in terms of linear matrix inequalities (LMIs). Finally, simple illustrative examples are shown.

1. Introduction

It is well known that robust control for uncertain dynamical systems is very important topic for the control engineering community, and therefore various robust control problems have been well studied (see [1] and references therein). Moreover many robust controllers, achieving some robust performance such as mixed control [2] and guaranteed cost control [3], have been suggested. Additionally, Šiljak and Stipanovic [4] and Zuo et al. [5] have presented results of robust stability and stabilization for linear continuous-time and discrete-time system under nonlinear perturbations using the linear matrix inequalities (LMIs). Although almost all of these controllers consist of a state feedback with a fixed feedback gain, the fixed feedback gain can be derived by considering the worst case for unknown parameter variations. In contrast with the above-mentioned control strategies, adaptive robust controllers which are adjusted by parameter updating laws have also been presented (e.g., [6, 7]). In the work of Maki and Hagino [6], an adaptation mechanism for improving transient behavior has been introduced, and the robust controller includes fixed gain parameters and adjustable ones which are tuned by some updating laws. Moreover, Oya and Hagino [7] have proposed a robust controller with adaptive compensation inputs, and the adaptive compensation input consists of a state feedback with an adaptive gain and a compensation input. One can see that these adaptive robust controllers have time-varying adjustable parameters which are tuned by adjustment laws.

On the other hand in practical systems, there are some constraints such as some limit of actuators and electric saturations for electronic circuits. If the constraint conditions are violated, they cannot generate the desired response, and at worst the system becomes unstable. From these viewpoints, analysis and/or controller design of dynamical systems with constraint conditions are very important issue, and there are a large number of the existing results such as reachable and controllable sets [8], Model Predictive Control (MPC) [9], and saturation-dependent Lyapunov functions [10]. Gilbert and Tan [11] have proposed a general theory which pertains to the maximal output admissible sets and for linear systems with state and input constraints. However, so far the design problem of adaptive robust controllers with adjustable parameters for uncertain dynamical systems with input saturations has little been considered as far as we know.

In this paper, on the basis of the work of Oya and Hagino [7] we propose a new LMI-based design method of adaptive robust controllers for a class of nonlinear systems with input saturations. For the nonlinear system considered here, the nonlinearity means unknown perturbations and satisfies the well-known matching condition [12]. By using the concept of state reachable sets, the proposed controller can flexibly be adjusted by parameter updating laws [7] and satisfies the specified input saturations. Namely, the result of this paper is a natural extension of the existing result [7]. In this paper, we show that sufficient conditions for the existence of the proposed adaptive robust controller are given in terms of LMIs. Thus, the proposed adaptive robust controller can easily be derived by solving LMIs, and this is also an advantage for the proposed controller design approach.

This paper is organized as follows. In Section 2, notation and useful lemmas which are used in this paper are shown, and in Section 3 we introduce the class of nonlinear systems with input constraints under consideration. Section 4 contains the main results. Finally we show simple illustrative examples to verify the effectiveness of the proposed robust controller.

2. Preliminaries

In this section, notations and useful and well-known lemmas (see [13, 14] for details) which are used in this paper are shown.

In the paper, the following notations are used: For a matrix , the inverse of matrix and its transpose are denoted by and , respectively. Additionally and mean and -dimensional identity matrix, respectively, and the notation represents a block diagonal matrix composed of matrices for . Trace represents trace of . For real symmetric matrices and , means that is positive (resp., nonnegative) definite matrix. For a vector , denotes standard Euclidian norm and for a matrix , represents its induced norm. All the eigenvalues of the matrix are denoted by , and means the maximum value of the eigenvalues. Additionally, for a symmetric positive definite matrix , represents a region . The symbols “” and “” mean equality by definition and symmetric blocks in matrix inequalities, respectively.

Next, we show some useful lemmas which are used in this paper.

Lemma 1. For arbitrary vectors and and the matrices and which have appropriate dimensions, the following inequality holds:where with appropriate dimensions is a time-varying unknown matrix satisfying .

Lemma 2 (-procedure [14]). Let , , and be three arbitrary quadratic forms over . Then satisfying and if there exist nonnegative scalars and such that

Lemma 3 (Schur complement [14]). For a given constant real symmetric matrix , we consider the following inequality conditions:(i)(ii)(iii)Then the inequality condition of (i) is equivalent to inequalities of (ii) and (iii).

3. Problem Formulation

Let us consider the nonlinear system represented by the following state equation:where , , and are the vectors of the state, the control input, and the reference input, respectively. In (6), the reference input is assumed to belong to the ellipsoidal set defined asNote that is a given symmetric positive definite matrix. In addition, the vector in (6) means nonlinearity and uncertainty in the controlled system, and it satisfies the relation ; that is, a well-known matching condition [12] is satisfied. Although the nonlinear function is “unknown,” for the known matrix , it is assumed to satisfy the following inequality condition [4, 5]:In the sequel, we deal with the case of for simplicity, because the results for the case of can easily be obtained by the following result (see Remark 5). Therefore, we consider the following constraint for the control input :where is a known positive constant, and this relation is equivalent to .

Now for the nonlinear system of (6), we consider the control input described asIn (10) and are a fixed feedback gain and an adaptive compensation input, respectively. From (6) and (10), the closed-loop system can be described aswhere is a matrix given by .

Next we consider a state reachable set for the nonlinear system of (6). By using a symmetric positive definite matrix , we introduce the quadratic function and consider the time derivative of the quadratic function along the trajectory of the closed-loop system of (11). The ellipsoid contains the state reachable set ; that is, provided that, for any and satisfying and , the following inequality condition holds [14]:

Therefore, our objective in this paper is to develop an LMI-based design procedure of the proposed adaptive robust controller which guarantees the internal stability of the resultant closed-loop system of (11) and the input constraint of (9). In this paper, by using the concept of the state reachable set, we derive an LMI-based design method for the fixed gain and the adaptive compensation input such that the closed-loop system of (11) achieves not only internal stability but also the control input constraint of .

4. Synthesis of Adaptive Robust Controllers

In this section, we show an LMI-based design method of the fixed feedback gain and the adaptive compensation input which ensure internal stability of the closed-loop system of (11) and satisfy the input constraint .

4.1. Analysis of State Reachable Set

The time derivative of the quadratic function can be expressed as

Firstly, we consider the case of . Then by defining the adaptive compensation input of (10) asand using Lemma 1, the inequalityis derived. Moreover, one can see that the inequality of (15) can be represented aswhere is given by

On the other hand, if is satisfied, then we see from (13) that the following equation holds:Note that, in this case, the adaptive compensation input can be defined aswhere is given by [6]. Note that the norm of can be expressed as .

From the above discussion, in order for the state reachable set of the system of (6) to belong to , the relationshould be satisfied. Therefore we introduce defined asNote that the inequality condition of (20), , and correspond to , respectively. Therefore we considerBy using Lemma 2 (-procedure), the condition of (22) is equivalent toNamely, if there exist the positive definite symmetric matrix , the fixed gain matrix , and the positive scalars and satisfyingthen . Clearly we must have . If the inequality condition of (24) is satisfied for some , then it holds for all . Therefore, we can assume without loss of generality that , and the condition of (24) can be rewritten as the following form [14]:Here by introducing the complementary matrices and and pre- and postmultiplying (25) by , we have

Consequently, if there exist the symmetric positive definite matrix , the matrix , and the positive scalar which satisfy the matrix inequality of (26), then the state reachable set for the closed-loop system of (11) is included in .

4.2. Analysis of Input Constraints

In Section 4.1, the condition for achieving the relation has been derived. Next we consider the input constraints.

From (10) and (14), we find that the control input can be written asMoreover, one can see from Section 4.1 that the state reachable set belongs to .

Firstly, we consider the 1st term of the right hand side of (27). Taking the Euclidian norm of , we obtainFurthermore, one can easily see that, for the 2nd term of the right hand side of (27), the inequalityis satisfied. Additionally, by using the similar way to the calculation of (28), we have

From (28) and (30), in order to satisfy the specified constraint , the following inequalities should be satisfied:In this paper, in order to derive an LMI-based design method, we introduce the conditionsinstead of the inequalities of (31). Note that the 1st and the 2nd inequalities of (32) are equivalent to them of (31), and the 3rd inequality of (32) is a sufficient condition of the 3rd one of (31). Thus, if the conditions of (32) hold, then the inequalities of (31) are also satisfied. Namely, if there exist the positive scalars and satisfying the inequalities of (32), then the input constraint is also satisfied.

Now, by introducing the complementary variables and we consider the following inequalities:One can see from Lemma 3 (Schur complement) that the 4th and 5th inequalities in (33) are equivalent toMoreover, by applying Lemma 3 (Schur complement) to the 1st inequality of (33), we obtainAdditionally, since the matrix is known, one can easily calculate the scalar satisfying . Thus, we introduce the inequality conditionand this inequality is a sufficient condition of the 2nd inequality of (33).

From the above discussion, one can see that, for given positive constants and , if the symmetric positive definite matrix , the matrix , and the positive scalars , , , and which satisfy LMIs of (26), (34), (35), and (36) are obtained, then the input constraints are satisfied.

Consequently, our main result is summarized as the following theorem.

Theorem 4. Consider the nonlinear system of (6) and the control input of (10).
For given positive constants and , if there exist the symmetric positive definite matrix , the matrix , and the positive scalars , , , and which satisfy the LMIsthe fixed gain matrix and the adaptive compensation input are determined aswhere [6]. Then the closed-loop system of (11) is internally stable and the state reachable set belongs to . Moreover the input constraints for the control input are also guaranteed.

Remark 5. In this paper, we introduce the assumption and consider the input constraint of (9).
By the way, for the control input there exist the componentwise input constraints; that is,where is a given positive constant. If the positive constant for the constraints of (39) satisfies , one can adopt the inequality [14]and the proposed design approach can be easily extended to this case.
On the other hand, for the case of , although we can consider the conditioninstead of (40), where means , then the resulting controller which is obtained by adopting the condition of (41) becomes very conservative. Thus the constraint condition of (41) is not desirable, and efficient and tractable conditions corresponding to the constraint of (39) have not been developed. Namely, the design problem for such constraints is one of our future research subjects.

Remark 6. In this paper, we deal with a stabilization problem of an adaptive robust controller for a class of nonlinear systems with input constraints. On the other hand, in the work of Oya and Hagino [7], by introducing an error signal between the time response and the desired one, the robust controller in [7] can achieve not only robust stability but also satisfactory transient behavior. Note that the proposed controller design approach can easily be extended to such control strategy.

5. Numerical Examples

In order to demonstrate the efficiency of the proposed robust controller, we have run a simple numerical example.

Let us consider the nonlinear systemwith the input constraintAdditionally in this simulation, the reference input and selected as and , respectively; that is, .

Firstly, in order to derive the proposed adaptive robust controller, we select the design parameter in (37) such as . Then by solving the LMIs of (37), the symmetric positive definite matrix , the matrix , and the positive constants , , , and can be calculated asNamely, the following inequality holds:Thus the constraint of (43) for the control input is satisfied, because .