Table of Contents Author Guidelines Submit a Manuscript
Modelling and Simulation in Engineering
Volume 2014, Article ID 897315, 7 pages
http://dx.doi.org/10.1155/2014/897315
Research Article

Analytic Model of Microcantilevers as Low Frequency Generator

Department of Physics & Electronics, University of Jammu, Jammu 180006, India

Received 3 January 2014; Accepted 18 March 2014; Published 25 May 2014

Academic Editor: Nikos D. Lagaros

Copyright © 2014 Sandeep Arya et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. H.-K. Liu, C. H. Pan, and P.-P. Liu, “Dimension effect on mechanical behavior of silicon micro-cantilever beams,” Measurement, vol. 41, no. 8, pp. 885–895, 2008. View at Publisher · View at Google Scholar · View at Scopus
  2. A. Boisen, S. Dohn, S. S. Keller, S. Schmid, and M. Tenje, “Cantilever-like micromechanical sensors,” Reports on Progress in Physics, vol. 74, no. 3, Article ID 036101, 2011. View at Publisher · View at Google Scholar · View at Scopus
  3. R. Raiteri, M. Grattarola, H.-J. Butt, and P. Skládal, “Micromechanical cantilever-based biosensors,” Sensors and Actuators, B: Chemical, vol. 79, no. 2-3, pp. 115–126, 2001. View at Publisher · View at Google Scholar · View at Scopus
  4. R. Herdier, D. Jenkins, D. Remiens, M. Dupont, and D. Osmont, “A silicon cantilever beam structure for the evaluation of d31, d33 and e31 piezoelectric coefficients of PZT thin films,” in Proceedings of the 16th IEEE International Symposium on the Applications of Ferroelectrics (ISAF '07), pp. 725–727, May 2007. View at Publisher · View at Google Scholar · View at Scopus
  5. X. Li and D.-W. Lee, “Integrated microcantilevers for high-resolution sensing and probing,” Measurement Science and Technology, vol. 23, no. 2, Article ID 022001, 2012. View at Google Scholar · View at Scopus
  6. H. H. Yoo and S. H. Shin, “Vibration analysis of rotating cantilever beams,” Journal of Sound and Vibration, vol. 212, no. 5, pp. 807–808, 1998. View at Google Scholar · View at Scopus
  7. J. Thaysen, A. Boisen, O. Hansen, and S. Bouwstra, “Atomic force microscopy probe with piezoresistive read-out and a highly symmetrical Wheatstone bridge arrangement,” Sensors and Actuators, A: Physical, vol. 83, no. 1, pp. 47–53, 2000. View at Publisher · View at Google Scholar · View at Scopus
  8. L. A. Pinnaduwage, A. Gehl, D. L. Hedden et al., “A microsensor for trinitrotoluene vapour,” Nature, vol. 425, no. 6957, p. 474, 2003. View at Publisher · View at Google Scholar · View at Scopus
  9. S. Arya, S. Khan, and P. Lehana, “Finite element modelling of piezoelectric micro-cantilever as gas sensor,” in Proceedings of the 1st International Conference on Emerging Trends and Applications in Computer Science (ICETACS '13), 2013.
  10. B. Rogers, L. Manning, M. Jones et al., “Mercury vapor detection with a self-sensing, resonating piezoelectric cantilever,” Review of Scientific Instruments, vol. 74, no. 11, pp. 4899–4901, 2003. View at Publisher · View at Google Scholar · View at Scopus
  11. S. Dohn, R. Sandberg, W. Svendsen, and A. Boisen, “Enhanced functionality of cantilever based mass sensors using higher modes,” Applied Physics Letters, vol. 86, no. 23, Article ID 233501, pp. 1–3, 2005. View at Publisher · View at Google Scholar · View at Scopus
  12. H. Irschik, “A review on static and dynamic shape control of structures by piezoelectric actuation,” Engineering Structures, vol. 24, no. 1, pp. 5–11, 2002. View at Publisher · View at Google Scholar · View at Scopus
  13. A. T. Tran, G. Pandrauda, H. Schellevisa et al., “Fabrication of AlN slender piezoelectric cantilevers for high speed MEMS actuations,” Procedia Engineering, vol. 25, pp. 673–676, 2011. View at Google Scholar
  14. T. W. Kenny, S. B. Waltman, J. K. Reynolds, and W. J. Kaiser, “Micromachined silicon tunnel sensor for motion detection,” Applied Physics Letters, vol. 58, no. 1, pp. 100–102, 1991. View at Publisher · View at Google Scholar · View at Scopus
  15. S.-H. S. Lim, D. Raorane, S. Satyanarayana, and A. Majumdar, “Nano-chemo-mechanical sensor array platform for high-throughput chemical analysis,” Sensors and Actuators, B: Chemical, vol. 119, no. 2, pp. 466–474, 2006. View at Publisher · View at Google Scholar · View at Scopus
  16. A. J. Qavi, A. L. Washburn, J.-Y. Byeon, and R. C. Bailey, “Label-free technologies for quantitative multiparameter biological analysis,” Analytical and Bioanalytical Chemistry, vol. 394, no. 1, pp. 121–135, 2009. View at Publisher · View at Google Scholar · View at Scopus
  17. J. Fritz, “Cantilever biosensors,” Analyst, vol. 133, no. 7, pp. 855–863, 2008. View at Publisher · View at Google Scholar · View at Scopus
  18. Y. Rao and G. Zhang, “3D modeling of a surface-acoustic-wave based sensor,” in Proceedings of the COMSOL Conference, Boston, Mass, USA, 2007.
  19. J. Wang, J.-K. Chen, and S. Liao, “An explicit solution of the large deformation of a cantilever beam under point load at the free tip,” Journal of Computational and Applied Mathematics, vol. 212, no. 2, pp. 320–330, 2008. View at Publisher · View at Google Scholar · View at Scopus
  20. I. Kim, H. Joo, S. Jeong, M. Kim, and J. Song, “Micro power generation of a PMN-PZT triple-morph cantilever for electric harvesting devices,” Journal of the Korean Physical Society, vol. 56, no. 12, pp. 370–373, 2010. View at Publisher · View at Google Scholar · View at Scopus