Table of Contents Author Guidelines Submit a Manuscript
Modelling and Simulation in Engineering
Volume 2016 (2016), Article ID 5072404, 12 pages
http://dx.doi.org/10.1155/2016/5072404
Research Article

Prediction on Power Produced from Power Turbine as a Waste Heat Recovery Mechanism on Naturally Aspirated Spark Ignition Engine Using Artificial Neural Network

1Centre for Advanced Research on Energy, Faculty of Mechanical Engineering, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76100 Durian Tunggal, Malacca, Malaysia
2Department of Mechanical Engineering, Faculty of Engineering, International Islamic University Malaysia (IIUM), P.O. Box 10, 50728 Kuala Lumpur, Malaysia

Received 30 September 2015; Accepted 21 February 2016

Academic Editor: Ahmed Rachid

Copyright © 2016 Safarudin Gazali Herawan et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. R. El Chammas and D. Clodic, “Combined cycle for hybrid vehicles,” SAE Technical Paper 2005-01-1171, 2005. View at Publisher · View at Google Scholar
  2. Z. Peng, T. Wang, Y. He, X. Yang, and L. Lu, “Analysis of environmental and economic benefits of integrated Exhaust Energy Recovery (EER) for vehicles,” Applied Energy, vol. 105, pp. 238–243, 2013. View at Publisher · View at Google Scholar · View at Scopus
  3. T.-C. Hung, “Waste heat recovery of organic Rankine cycle using dry fluids,” Energy Conversion and Management, vol. 42, no. 5, pp. 539–553, 2001. View at Publisher · View at Google Scholar · View at Scopus
  4. C. Yu and K. T. Chau, “Thermoelectric automotive waste heat energy recovery using maximum power point tracking,” Energy Conversion and Management, vol. 50, no. 6, pp. 1506–1512, 2009. View at Publisher · View at Google Scholar · View at Scopus
  5. B. Deok In, H. Ik Kim, J. Wook Son, and K. Hyung Lee, “The study of a thermoelectric generator with various thermal conditions of exhaust gas from a diesel engine,” International Journal of Heat and Mass Transfer, vol. 86, pp. 667–680, 2015. View at Publisher · View at Google Scholar
  6. F. Yang, G. Gao, M. Ouyang, L. Chen, and Y. Yang, “Research on a diesel HCCI engine assisted by an ISG motor,” Applied Energy, vol. 101, pp. 718–729, 2013. View at Publisher · View at Google Scholar · View at Scopus
  7. S. A. Frei, L. Guzzella, C. H. Onder, and C. Nizzola, “Improved dynamic performance of turbocharged SI engine power trains using clutch actuation,” Control Engineering Practice, vol. 14, no. 4, pp. 363–373, 2006. View at Publisher · View at Google Scholar · View at Scopus
  8. M. Tancrez, J. Galindo, C. Guardiola, P. Fajardo, and O. Varnier, “Turbine adapted maps for turbocharger engine matching,” Experimental Thermal and Fluid Science, vol. 35, no. 1, pp. 146–153, 2011. View at Publisher · View at Google Scholar · View at Scopus
  9. R. Zhao, W. Zhuge, Y. Zhang, Y. Yin, Z. Chen, and Z. Li, “Parametric study of power turbine for diesel engine waste heat recovery,” Applied Thermal Engineering, vol. 67, no. 1-2, pp. 308–319, 2014. View at Publisher · View at Google Scholar · View at Scopus
  10. M. Algrain, “Controlling an electric turbo compound system for exhaust gas energy recovery in a diesel engine,” in Proceedings of the IEEE International Conference on Electro Information Technology, Lincoln, Neb, USA, May 2005. View at Publisher · View at Google Scholar
  11. R. Zhao, W. Zhuge, Y. Zhang, M. Yang, R. Martinez-Botas, and Y. Yin, “Study of two-stage turbine characteristic and its influence on turbo-compound engine performance,” Energy Conversion and Management, vol. 95, pp. 414–423, 2015. View at Publisher · View at Google Scholar · View at Scopus
  12. A. M. I. Mamat, A. Romagnoli, and R. F. Martinez-Botas, “Design and development of a low pressure turbine for turbocompounding applications,” International Journal of Gas Turbine, Propulsion and Power Systems, vol. 4, no. 3, pp. 1–8, 2012. View at Google Scholar · View at Scopus
  13. Y.-Q. Zhang, Y.-T. Wu, G.-D. Xia et al., “Development and experimental study on organic Rankine cycle system with single-screw expander for waste heat recovery from exhaust of diesel engine,” Energy, vol. 77, pp. 499–508, 2014. View at Publisher · View at Google Scholar · View at Scopus
  14. M. C. Esposito, N. Pompini, A. Gambarotta, V. Chandrasekaran, J. Zhou, and M. Canova, “Nonlinear model predictive control of an organic rankine cycle for exhaust waste heat recovery in automotive engines,” IFAC-PapersOnLine, vol. 48, no. 15, pp. 411–418, 2015. View at Publisher · View at Google Scholar
  15. F. Yang, X. Yuan, and G. Lin, “Waste heat recovery using heat pipe heat exchanger for heating automobile using exhaust gas,” Applied Thermal Engineering, vol. 23, no. 3, pp. 367–372, 2003. View at Publisher · View at Google Scholar · View at Scopus
  16. W.-D. Wu, H. Zhang, and C.-L. Men, “Performance of a modified zeolite 13X-water adsorptive cooling module powered by exhaust waste heat,” International Journal of Thermal Sciences, vol. 50, no. 10, pp. 2042–2049, 2011. View at Publisher · View at Google Scholar · View at Scopus
  17. F. Will, “Fuel conservation and emission reduction through novel waste heat recovery for internal combustion engines,” Fuel, vol. 102, pp. 247–255, 2012. View at Publisher · View at Google Scholar · View at Scopus
  18. S. G. Herawan, A. H. Rohhaizan, A. Putra, and A. F. Ismail, “Prediction of waste heat energy recovery performance in a naturally aspirated engine using artificial neural network,” ISRN Mechanical Engineering, vol. 2014, Article ID 240942, 6 pages, 2014. View at Publisher · View at Google Scholar · View at Scopus
  19. J. Bumby, S. Crossland, and J. Carter, “Electrically assisted turbochargers: their potential for energy recovery,” in Proceedings of the IET Hybrid Vehicle Conference, pp. 43–52, The Institution of Engineering and Technology (IET ), Coventry, UK, December 2006.
  20. J. Bumby, E. Spooner, and M. Jagiela, “Solid rotor induction machines for use in electrically-assisted turbochargers,” in Proceedings of the 3rd IET International Conference on Power Electronics, Machines and Drives, Dublin, Ireland, April 2006.
  21. J. R. Bumby, E. S. Spooner, J. Carter et al., “Electrical machines for use in electrcally assisted turbochargers,” in Proceedings of the 2nd International Conference on Power Electronics, Machines and Drives (PEMD '04), pp. 344–349, April 2004. View at Scopus
  22. J. Dellachà, L. Damiani, M. Repetto, and A. P. Prato, “Dynamic model for the energetic optimization of turbocompound hybrid powertrains,” Energy Procedia, vol. 45, pp. 1047–1056, 2014. View at Google Scholar
  23. C. O. Katsanos, D. T. Hountalas, and T. C. Zannis, “Simulation of a heavy-duty diesel engine with electrical turbocompounding system using operating charts for turbocharger components and power turbine,” Energy Conversion and Management, vol. 76, pp. 712–724, 2013. View at Publisher · View at Google Scholar · View at Scopus
  24. B. Sendyka and J. Soczówka, Recovery of Exhaust Gases Energy by Means of Turbocompound, Politechnika Krakowska, Kraków, Poland, 2001.
  25. Y. Cay, “Prediction of a gasoline engine performance with artificial neural network,” Fuel, vol. 111, pp. 324–331, 2013. View at Publisher · View at Google Scholar · View at Scopus
  26. H. Taghavifar, S. Khalilarya, and S. Jafarmadar, “Diesel engine spray characteristics prediction with hybridized artificial neural network optimized by genetic algorithm,” Energy, vol. 71, pp. 656–664, 2014. View at Publisher · View at Google Scholar · View at Scopus
  27. A. Uzun, “Air mass flow estimation of diesel engines using neural network,” Fuel, vol. 117, pp. 833–838, 2014. View at Publisher · View at Google Scholar · View at Scopus
  28. M. Bietresato, A. Calcante, and F. Mazzetto, “A neural network approach for indirectly estimating farm tractors engine performances,” Fuel, vol. 143, pp. 144–154, 2015. View at Publisher · View at Google Scholar · View at Scopus
  29. M. Hooshang, R. Askari Moghadam, S. Alizadeh Nia, and M. T. Masouleh, “Optimization of Stirling engine design parameters using neural networks,” Renewable Energy, vol. 74, pp. 855–866, 2015. View at Publisher · View at Google Scholar
  30. K. Nikzadfar and A. H. Shamekhi, “Investigating the relative contribution of operational parameters on performance and emissions of a common-rail diesel engine using neural network,” Fuel, vol. 125, pp. 116–128, 2014. View at Publisher · View at Google Scholar · View at Scopus
  31. A.-M. Shamekhi and A. H. Shamekhi, “A new approach in improvement of mean value models for spark ignition engines using neural networks,” Expert Systems with Applications, vol. 42, no. 12, pp. 5192–5218, 2015. View at Publisher · View at Google Scholar · View at Scopus
  32. H. Xie and C. Yang, “Dynamic behavior of Rankine cycle system for waste heat recovery of heavy duty diesel engines under driving cycle,” Applied Energy, vol. 112, pp. 130–141, 2013. View at Publisher · View at Google Scholar · View at Scopus
  33. The MathWorks, Matlab, The MathWorks, Natick, Mass, USA, 2009.
  34. N. Yamada and M. N. A. Mohamad, “Efficiency of hydrogen internal combustion engine combined with open steam Rankine cycle recovering water and waste heat,” International Journal of Hydrogen Energy, vol. 35, no. 3, pp. 1430–1442, 2010. View at Publisher · View at Google Scholar · View at Scopus