Table of Contents Author Guidelines Submit a Manuscript
Modelling and Simulation in Engineering
Volume 2017 (2017), Article ID 3258376, 18 pages
https://doi.org/10.1155/2017/3258376
Research Article

Numerical Modal Analysis of Vibrations in a Three-Phase Linear Switched Reluctance Actuator

1Instituto de Telecomunicações (IT), Calçada Fonte do Lameiro, 6201-001 Covilhã, Portugal
2Polytechnic Institute of Castelo Branco, School of Technology, Av. Empresário, S/N, 6000-767 Castelo Branco, Portugal
3University of Beira Interior, Faculty of Engineering, Calçada Fonte do Lameiro, 6201-001 Covilhã, Portugal
4Center for Mechanical and Aerospace Science and Technologies (C-MAST), Calçada Fonte do Lameiro, 6201-001 Covilhã, Portugal

Correspondence should be addressed to José Salvado; tp.bcpi@odavlasesoj

Received 5 December 2016; Revised 6 February 2017; Accepted 12 March 2017; Published 18 April 2017

Academic Editor: Min-Chie Chiu

Copyright © 2017 José Salvado et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. D. E. Cameron, J. H. Lang, and S. D. Umans, “The origin and reduction of acoustic noise in doubly salient variable-reluctance motors,” IEEE Transactions on Industry Applications, vol. 28, no. 6, pp. 1250–1255, 1992. View at Publisher · View at Google Scholar · View at Scopus
  2. B. Fahimi, G. Suresh, and M. Ehsani, “Design considerations of switched reluctance motors: vibration and control issues,” in Proceedings of the Conference Record of the 1999 IEEE Industry Applications Conference. 34th IAS Annual Meeting, vol. 4, pp. 2259–2266, 1999, Cat. No. 99CH36370.
  3. R. S. Colby, F. M. Mottier, and T. J. E. Miller, “Vibration modes and acoustic noise in a four-phase switched reluctance motor,” IEEE Transactions on Industry Applications, vol. 32, no. 6, pp. 1357–1364, 1996. View at Publisher · View at Google Scholar · View at Scopus
  4. P. Pillay and W. Cai, “An investigation into vibration in switched reluctance motors,” in Proceedings of the 33rd IAS Annual Meeting in Conference Record of IEEE Industry Applications Conference, vol. 1, pp. 341–350, 2008.
  5. W. Cai and P. Pillay, “Resonant frequencies and mode shapes of switched reluctance motors,” IEEE Transactions on Energy Conversion, vol. 16, no. 1, pp. 43–48, 2001. View at Publisher · View at Google Scholar · View at Scopus
  6. S. A. Long, Z. Q. Zhu, and D. Howe, “Influence of load on noise and vibration of voltage and current controlled switched reluctance machines,” in Proceedings of the International Conference on: Power Electronics, Machines and Drives, pp. 534–539, April 2002. View at Scopus
  7. Z. Tang, P. Pillay, A. M. Omekanda, C. Li, and C. Cetinkaya, “Effects of material properties on switched reluctance motor vibration determination,” in Proceedings of the 38th IAS Annual Meeting on Conference Record of the Industry Applications Conference, vol. 1, pp. 235–241, October 2003. View at Scopus
  8. J.-P. Lecointe, R. Romary, J.-F. Brudny, and T. Czapla, “Five methods of stator natural frequency determination: case of induction and switched reluctance machines,” Mechanical Systems and Signal Processing, vol. 18, no. 5, pp. 1133–1159, 2004. View at Publisher · View at Google Scholar · View at Scopus
  9. G. Bhuvaneswari, P. S. Rao, S. G. Thakurta, and S. S. Murthy, “Impact of dwell angle on the electromagnetic torque ripples of the switched reluctance motor,” Defence Science Journal, vol. 58, no. 3, pp. 363–371, 2008. View at Publisher · View at Google Scholar · View at Scopus
  10. J. Li, X. Song, and Y. Cho, “Comparison of 12/8 and 6/4 switched reluctance motor: noise and vibration aspects,” IEEE Transactions on Magnetics, vol. 44, no. 11, pp. 4131–4134, 2008. View at Publisher · View at Google Scholar · View at Scopus
  11. N. C. Lenin and R. Arumugam, “Acoustic noise, vibration, harmonics, thermal of three phase linear switched reluctance machines,” in Proceedings of the 2010 Joint International Conference on Power Electronics, Drives and Energy Systems (PEDES '10), pp. 1–4, December 2010. View at Publisher · View at Google Scholar · View at Scopus
  12. J. Boisson, F. Louf, J. Ojeda, X. Mininger, and M. Gabsi, “Analytical approach for mechanical resonance frequencies of high-speed machines,” IEEE Transactions on Industrial Electronics, vol. 61, no. 6, pp. 3081–3088, 2014. View at Publisher · View at Google Scholar · View at Scopus
  13. I. Husain, “Minimization of torque ripple in SRM drives,” IEEE Transactions on Industrial Electronics, vol. 49, no. 1, pp. 28–39, 2002. View at Publisher · View at Google Scholar · View at Scopus
  14. S. A. Long, Z. Q. Zhu, and D. Howe, “Effectiveness of active noise and vibration cancellation for switched reluctance machines operating under alternative control strategies,” IEEE Transactions on Energy Conversion, vol. 20, no. 4, pp. 792–801, 2005. View at Publisher · View at Google Scholar · View at Scopus
  15. K. A. Kasper, J. O. Fiedler, D. Schmitz, and R. W. de Doncker, “Noise reduction control strategies for switched reluctance drives,” in Proceedings of the IEEE Vehicle Power and Propulsion Conference (VPPC '06), pp. 1–6, IEEE, September 2006. View at Publisher · View at Google Scholar · View at Scopus
  16. Y. K. Choi, H. S. Yoon, and C. S. Koh, “Pole-shape optimization of a switched-reluctance motor for torque ripple reduction,” IEEE Transactions on Magnetics, vol. 43, no. 4, pp. 1797–1800, 2007. View at Publisher · View at Google Scholar · View at Scopus
  17. A. E. Espírito-Santo, M. R. A. Calado, and C. M. P. Cabrita, “On the influence of the pole and teeth shapes on the performance of linear switched reluctance actuator,” COMPEL—The International Journal for Computation and Mathematics in Electrical and Electronic Engineering, vol. 30, no. 2, pp. 412–430, 2011. View at Publisher · View at Google Scholar · View at Scopus
  18. C. Lin and B. Fahimi, “Prediction of radial vibration in switched reluctance machines,” IEEE Transactions on Energy Conversion, vol. 28, no. 4, pp. 1072–1081, 2013. View at Publisher · View at Google Scholar · View at Scopus
  19. K. Edamura and I. Miki, “Design of stator and rotor for noise reduction of SRM,” in Proceedings of the 17th International Conference on Electrical Machines and Systems (ICEMS '14), pp. 1871–1874, October 2014. View at Publisher · View at Google Scholar · View at Scopus
  20. C. Lin and B. Fahimi, “Prediction of acoustic noise in switched reluctance motor drives,” IEEE Transactions on Energy Conversion, vol. 29, no. 1, pp. 250–258, 2014. View at Publisher · View at Google Scholar · View at Scopus
  21. D. W. J. Pulle, J. C. S. Lai, J. F. Milthorpe, and N. Huynh, “Quantification and analysis of acoustic noise in switched reluctance drives,” in Proceedings of the 5th European Conference on Power Electronics and Applications, vol. 6, pp. 65–70, IEEE, Brighton, UK, September 1993.
  22. P. Vijayraghavan and R. Krishnan, “Noise in electric machines: a review,” IEEE Transactions on Industry Applications, vol. 35, no. 5, pp. 1007–1013, 1999. View at Publisher · View at Google Scholar · View at Scopus
  23. J. O. Fiedler, K. A. Kasper, and R. W. De Doncker, “Acoustic noise in switched reluctance drives: an aerodynamic problem?” in Proceedings of the IEEE International Conference on Electric Machines and Drives, pp. 1275–1280, May 2005. View at Scopus
  24. A. E. Santo, M. D. R. Calado, and C. Cabrita, “Static simulation of a linear switched reluctance actuator with the flux tube method,” Advances in Electrical and Computer Engineering, vol. 10, no. 2, pp. 35–42, 2010. View at Publisher · View at Google Scholar · View at Scopus
  25. X. Xue, K.-W. E. Cheng, Z. Zhang, J. Lin, and N. Cheung, “A novel method to minimize force ripple of multimodular linear switched reluctance actuators/motors,” IEEE Transactions on Magnetics, vol. 48, no. 11, pp. 3859–3862, 2012. View at Publisher · View at Google Scholar · View at Scopus
  26. J. Salvado, A. E. Santo, and M. Do Rosário Calado, “Vibration analysis of a linear switched reluctance actuator,” in Proceedings of the International Conference on Computer as a Tool (EUROCON '11), pp. 1–4, April 2011. View at Publisher · View at Google Scholar · View at Scopus
  27. Z. Q. Zhu, B. Lee, L. Huang, and W. Chu, “Contribution of current harmonics to average torque and torque ripple in switched reluctance machines,” IEEE Transactions on Magnetics, vol. 53, no. 3, pp. 1–9, 2017. View at Publisher · View at Google Scholar
  28. B. Ganji and M. H. Askari, “Analysis and modeling of different topologies for linear switched reluctance motor using finite element method,” Alexandria Engineering Journal, vol. 55, no. 3, pp. 2531–2538, 2016. View at Publisher · View at Google Scholar
  29. R. Krishnan, Switched Reluctance Motor Drives: Modeling, Simulation, Analysis, Design, and Applications, CRC Press, Boca Raton, Fla, USA, 2001.
  30. J. Jacques, “Noise and standardization, focusing on machinery and workplace domains,” in Proceedings of the Joint Baltic-Nordic Acosutics Meeting, pp. 8–10, June 2001.
  31. L. Meirovitch, Fundamentals of Vibrations, McGraw-Hill, Boston, Mass, USA, 2001.
  32. A. G. Piersol, T. L. Paez, and C. M. Harris, Harris' Shock and Vibration Handbook, McGraw-Hill, New York, NY, USA, 6th edition, 2010.
  33. A. E. Santo, R. Calado, and C. M. Cabrita, “Sliding mode position controller for a linear switched reluctance actuator,” in Sliding Mode Control, A. Bartoszewicz, Ed., pp. 181–202, In Tech Open, Rijeka, Croatia, 2011. View at Google Scholar
  34. P. J. P. Gonçalves, M. J. Brennan, and S. J. Elliott, “Numerical evaluation of high-order modes of vibration in uniform Euler-Bernoulli beams,” Journal of Sound and Vibration, vol. 301, no. 3–5, pp. 1035–1039, 2007. View at Publisher · View at Google Scholar · View at Scopus
  35. S. A. Hambric, “Structural acoustics tutorial—Part 1: vibrations in structures,” Acoustics Today, vol. 2, no. 4, pp. 21–33, 2006. View at Publisher · View at Google Scholar
  36. A. W. Leissa, Vibration of Plates, National Aeronautics and Space Administration, 1st edition, 1969.
  37. B. Schwarz and M. Richardson, “Proportional damping from experimental data,” in Proceedings of the 31st International Modal Analysis Conference on Structural Dynamics (IMAC '13), pp. 179–186, February 2013. View at Publisher · View at Google Scholar · View at Scopus