Table of Contents Author Guidelines Submit a Manuscript
Shock and Vibration
Volume 20 (2013), Issue 2, Pages 327-340
http://dx.doi.org/10.3233/SAV-2012-00747

Theoretical and Experimental Study on Synchronization of the Two Homodromy Exciters in a Non-Resonant Vibrating System

Xue-Liang Zhang, Chun-Yu Zhao, and Bang-Chun Wen

School of Mechanical Engineering and Automation, Northeastern University, Shenyang, Liaoning, China

Received 14 April 2012; Revised 28 September 2012; Accepted 3 October 2012

Copyright © 2013 Hindawi Publishing Corporation. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

In this paper we give some theoretical analyses and experimental results on synchronization of the two non-identical exciters. Using the average method of modified small parameters, the dimensionless coupling equation of the two exciters is deduced. The synchronization criterion for the two exciters is derived as the torque of frequency capture being equal to or greater than the absolute value of difference between the residual electromagnetic torques of the two motors. The stability criterion of synchronous state is verified to satisfy the Routh-Hurwitz criterion. The regions of implementing synchronization and that of stability of phase difference for the two exciters are manifested by numeric method. Synchronization of the two exciters stems from the coupling dynamic characteristic of the vibrating system having selecting motion, especially, under the condition that the parameters of system are complete symmetry, the torque of frequency capture stemming from the circular motion of the rigid frame drives the phase difference to approach PI and carry out the swing of the rigid frame; that from the swing of the rigid frame forces the phase difference to near zero and achieve the circular motion of the rigid frame. In the steady state, the motion of rigid frame will be one of three types: pure swing, pure circular motion, swing and circular motion coexistence. The numeric and experiment results derived thereof show that the two exciters can operate synchronously as long as the structural parameters of system satisfy the criterion of stability in the regions of frequency capture. In engineering, the distance between the centroid of the rigid frame and the rotational centre of exciter should be as far as possible. Only in this way, can the elliptical motion of system required in engineering be realized.