Table of Contents Author Guidelines Submit a Manuscript
Shock and Vibration
Volume 2015, Article ID 916870, 7 pages
http://dx.doi.org/10.1155/2015/916870
Research Article

An Enhanced Piezoelectric Vibration Energy Harvesting System with Macro Fiber Composite

1State Key Laboratory for Strength and Vibration of Mechanical Structures, School of Aerospace, Xi’an Jiaotong University, Xianning West Road, No. 28, Xi’an 710049, China
2Technology and Engineering Center for Space Utilization, Chinese Academy of Sciences, Dengzhuang South Road, No. 9, Beijing 100094, China

Received 15 April 2015; Revised 7 July 2015; Accepted 12 July 2015

Academic Editor: Carlo Trigona

Copyright © 2015 Shuwen Zhang et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. V. Mudupu, M. B. Trabia, W. Yim, and P. Weinacht, “Design and validation of a fuzzy logic controller for a smart projectile fin with a piezoelectric macro-fiber composite bimorph actuator,” Smart Materials and Structures, vol. 17, no. 3, Article ID 035034, 2008. View at Publisher · View at Google Scholar · View at Scopus
  2. J. Schröck, T. Meurer, and A. Kugi, “Control of a flexible beam actuated by macro-fiber composite patches: I. Modeling and feedforward trajectory control,” Smart Materials and Structures, vol. 20, no. 1, Article ID 015015, 2011. View at Publisher · View at Google Scholar · View at Scopus
  3. H. A. Sodano, G. Park, and D. J. Inman, “An investigation into the performance of macro-fiber composites for sensing and structural vibration applications,” Mechanical Systems and Signal Processing, vol. 18, no. 3, pp. 683–697, 2004. View at Publisher · View at Google Scholar · View at Scopus
  4. J. Schrock, T. Meurer, and A. Kugi, “Control of a flexible beam actuated by macro-fiber composite patches: II. Hysteresis and creep compensation, experimental results,” Smart Materials and Structures, vol. 20, Article ID 015016, 2011. View at Google Scholar
  5. B. Yan, X. Zhang, and H. Niu, “Design and test of a novel isolator with negative resistance electromagnetic shunt damping,” Smart Materials and Structures, vol. 21, no. 3, Article ID 035003, 2012. View at Publisher · View at Google Scholar · View at Scopus
  6. H. Painter and J. Flynn, “Current and future wet-mate connector technology developments for scientific E scabbed observatory application,” in Proceedings of the MTS/IEEE OCEANS, pp. 881–886, Boston, Mass, USA, September 2006.
  7. T. Kojiya, F. Sato, and H. Matsuki, “Construction of non-contacting power feeding system to underwater vehicle utilizing electromagnetic induction,” in Proceedings of the Oceans 2005—Europe, vol. 1-2, pp. 709–712, 2005.
  8. X. Zhang, H. Niu, and B. Yan, “A novel multimode negative inductance negative resistance shunted electromagnetic damping and its application on a cantilever plate,” Journal of Sound and Vibration, vol. 331, no. 10, pp. 2257–2271, 2012. View at Publisher · View at Google Scholar · View at Scopus
  9. A. Erturk and D. J. Inman, “An experimentally validated bimorph cantilever model for piezoelectric energy harvesting from base excitations,” Smart Materials and Structures, vol. 18, no. 2, Article ID 025009, 2009. View at Publisher · View at Google Scholar
  10. K. A. Cook-Chennault, N. Thambi, and A. M. Sastry, “Powering MEMS portable devices—a review of non-regenerative and regenerative power supply systems with special emphasis on piezoelectric energy harvesting systems,” Smart Materials and Structures, vol. 17, no. 4, Article ID 043001, 2008. View at Publisher · View at Google Scholar · View at Scopus
  11. M. Lallart and D. Guyomar, “An optimized self-powered switching circuit for non-linear energy harvesting with low voltage output,” Smart Materials and Structures, vol. 17, no. 3, Article ID 035030, 2008. View at Publisher · View at Google Scholar · View at Scopus
  12. J.-Q. Liu, H.-B. Fang, Z.-Y. Xu et al., “A MEMS-based piezoelectric power generator array for vibration energy harvesting,” Microelectronics Journal, vol. 39, no. 5, pp. 802–806, 2008. View at Publisher · View at Google Scholar · View at Scopus
  13. D. Shen, J.-H. Park, J. H. Noh et al., “Micromachined PZT cantilever based on SOI structure for low frequency vibration energy harvesting,” Sensors and Actuators, A: Physical, vol. 154, no. 1, pp. 103–108, 2009. View at Publisher · View at Google Scholar · View at Scopus
  14. H.-B. Fang, J.-Q. Liu, Z.-Y. Xu et al., “Fabrication and performance of MEMS-based piezoelectric power generator for vibration energy harvesting,” Microelectronics Journal, vol. 37, no. 11, pp. 1280–1284, 2006. View at Publisher · View at Google Scholar · View at Scopus
  15. M. Ferrari, V. Ferrari, M. Guizzetti, B. Andò, S. Baglio, and C. Trigona, “Improved energy harvesting from wideband vibrations by nonlinear piezoelectric converters,” Procedia Chemistry, vol. 1, no. 1, pp. 1203–1206, 2009. View at Publisher · View at Google Scholar
  16. F. Cottone, L. Gammaitoni, H. Vocca, M. Ferrari, and V. Ferrari, “Piezoelectric buckled beams for random vibration energy harvesting,” Smart Materials and Structures, vol. 21, no. 3, Article ID 035021, 2012. View at Publisher · View at Google Scholar · View at Scopus
  17. B. Yang, C. Lee, W. Xiang et al., “Electromagnetic energy harvesting from vibrations of multiple frequencies,” Journal of Micromechanics and Microengineering, vol. 19, no. 3, Article ID 035001, 2009. View at Publisher · View at Google Scholar · View at Scopus
  18. L. Gu and C. Livermore, “Impact-driven, frequency up-converting coupled vibration energy harvesting device for low frequency operation,” Smart Materials and Structures, vol. 20, no. 4, Article ID 045004, 2011. View at Publisher · View at Google Scholar · View at Scopus
  19. A. F. Arrieta, P. Hagedorn, A. Erturk, and D. J. Inman, “A piezoelectric bistable plate for nonlinear broadband energy harvesting,” Applied Physics Letters, vol. 97, no. 10, Article ID 104102, 2010. View at Publisher · View at Google Scholar · View at Scopus
  20. S. C. Stanton, C. C. McGehee, and B. P. Mann, “Nonlinear dynamics for broadband energy harvesting: investigation of a bistable piezoelectric inertial generator,” Physica D: Nonlinear Phenomena, vol. 239, no. 10, pp. 640–653, 2010. View at Publisher · View at Google Scholar · View at Scopus
  21. M. Ferrari, V. Ferrari, M. Guizzetti, B. Andò, S. Baglio, and C. Trigona, “Improved energy harvesting from wideband vibrations by nonlinear piezoelectric converters,” Sensors and Actuators, A: Physical, vol. 162, no. 2, pp. 425–431, 2010. View at Publisher · View at Google Scholar · View at Scopus
  22. R. Torah, P. Glynne-Jones, M. Tudor, T. O'Donnell, S. Roy, and S. Beeby, “Self-powered autonomous wireless sensor node using vibration energy harvesting,” Measurement Science and Technology, vol. 19, no. 12, Article ID 125202, 2008. View at Publisher · View at Google Scholar · View at Scopus