Table of Contents
Textures and Microstructures
Volume 21, Issue 4, Pages 251-259
http://dx.doi.org/10.1155/TSM.21.251

The Mechanism of Influence of Non-Octahedral Slip on Rolling Texture Development in FCC Metals. Computer Simulation

Institute of Metal Physics, Ukrainian Academy of Science 36 Vernadsky str., Kiev-142 252680, Ukraine

Accepted 30 September 1992

Copyright © 1993 Hindawi Publishing Corporation. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

Simulation of the copper-type rolling texture development in FCC metals based on homogeneous slip under conditions of no constrains (Sachs-type model) is presented. Detailed analysis shows that, in fact, effective activation of a few (two or three, sometimes greater) independent slip systems occurs after reaching of some strain. These slip systems act by turns and may be essentially considered as acting simultaneously. Therefore, such extended description may be considered as a model which is intermediate between Taylor and Sachs ones. Taking these results into account, the characteristic features of main texture component development in copper under rolling have been studied by a computer simulation. Both octahedral, {111}, and cubic, {100}, slip planes are shown to act simultaneously in the process of the {112}111¯ component formation, but the action of only {111}11¯0 slip systems is characteristic for the {110}11¯2 component formation. The important role of the non-octahedral sip systems in plastic deformation processes in FCC metals of high staking-fault energy are also confirmed by the coincidence of model shear textures and experimental surface textures.