Investigation on the Achievable Flow Length in Injection Moulding of Polymeric Materials with Dynamic Mould Tempering

<table class="table-group" id="tab2"><tr><td><table class="table"><tr><td class="thead-hr" colspan="5"><hr/></td></tr><tr class="thead"><td align="left">Parameter</td><td align="center">PA66</td><td align="center">POM</td><td align="center">PP</td><td align="center">PC</td></tr><tr><td class="thead-hr" colspan="5"><hr/></td></tr><tr><td align="left">Melt temperature (°C)</td><td align="center">290</td><td align="center">210</td><td align="center">260</td><td align="center">300</td></tr><tr><td align="left">Injection velocity (cm<sup>3</sup> s<sup>−1</sup>)</td><td align="center">100</td><td align="center">100</td><td align="center">100</td><td align="center">100</td></tr><tr class="table-tr"><td colspan="5"><hr class="tbody-hr"/></td></tr></table></td></tr></table>

The Scientific World Journal

tab2

Table 2

Table 2: Investigation on the Achievable Flow Length in Injection Moulding of Polymeric Materials with Dynamic Mould Tempering 