Table of Contents Author Guidelines Submit a Manuscript
The Scientific World Journal
Volume 2014, Article ID 163414, 5 pages
http://dx.doi.org/10.1155/2014/163414
Research Article

Ultra-Low-Voltage CMOS-Based Current Bleeding Mixer with High LO-RF Isolation

1Department of Electrical and Electronic Engineering, Universiti Putra Malaysia, 43400 Serdang, Malaysia
2Department of Electrical and Electronic Engineering, Segi University, 47810 Petaling Jaya, Selangor, Malaysia
3Department of Electrical Engineering, University of Malaya, 50603 Kuala Lumpur, Malaysia

Received 13 June 2014; Accepted 27 July 2014; Published 14 August 2014

Academic Editor: Changzhi Li

Copyright © 2014 Gim Heng Tan et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. G. H. Tan, R. M. Sidek, H. Ramiah, and W. K. Chong, “Design of ultra-low voltage 0.5V CMOS current bleeding mixer,” IEICE Electronics Express, vol. 9, no. 11, pp. 990–997, 2012. View at Publisher · View at Google Scholar · View at Scopus
  2. T. Song, H.-S. Oh, E. Yoon, and S. Hong, “A low-power 2.4-GHz current-reused receiver front-end and frequency source for wireless sensor network,” IEEE Journal of Solid-State Circuits, vol. 42, no. 5, pp. 1012–1022, 2007. View at Publisher · View at Google Scholar · View at Scopus
  3. B. Razavi, “Design considerations for direct-conversion receivers,” IEEE Transactions on Circuits and Systems, vol. 44, no. 6, pp. 428–435, 1997. View at Publisher · View at Google Scholar · View at Scopus
  4. H. Chiou, K. Lin, and W. Chen, “A 1-V 5-GHz self-bias folded-switch mixer in 90-nm CMOS for WLAN receiver,” IEEE Transactions on Circuits and Systems, vol. 59, no. 6, pp. 1215–1227, 2012. View at Publisher · View at Google Scholar · View at MathSciNet · View at Scopus
  5. J. Park, S. Member, C.-H. Lee, B.-S. Kim, and J. Laskar, “Design and analysis of low flicker-noise CMOS mixers for direct-conversion receivers,” IEEE Transactions on Microwave Theory and Techniques, vol. 54, no. 12, pp. 4372–4380, 2006. View at Google Scholar
  6. H.-M. Hsu and T.-H. Lee, “High LO-RF isolation of zero-IF mixer in 0.18 μm CMOS technology,” Analog Integrated Circuits and Signal Processing, vol. 49, no. 1, pp. 19–25, 2006. View at Publisher · View at Google Scholar · View at Scopus
  7. W. Liou, M. Yeh, C. Tsai, and S. Chang, “Design and implementation of a low-voltage 2.4-GHZ CMOS RF receiver front-end for wireless communication,” Journal of Marine Science and Technology, vol. 13, no. 3, pp. 170–175, 2005. View at Google Scholar · View at Scopus
  8. H. Lee and S. Mohammadi, “A 500 μW 2.4 GHz CMOS subthreshold mixer for ultra low power applications,” in Proceedings of the IEEE Radio Frequency Integrated Circuits Symposium (RFIC '07), pp. 325–328, Honolulu, Hawaii, USA, June 2007. View at Publisher · View at Google Scholar · View at Scopus
  9. B. Wei and Y. Dai, “Analysis and design of a 1.0-V CMOS mixer based on variable load technique,” Microelectronics Journal, vol. 43, no. 12, pp. 1003–1009, 2012. View at Publisher · View at Google Scholar · View at Scopus
  10. H. Ramiah, J. Kanesan, and T. Z. A. Zulkifli, “A CMOS up-conversion mixer in 0.18 μm technology for IEEE 802.11a WLAN application,” IETE Journal of Research, vol. 59, no. 4, pp. 454–460, 2013. View at Google Scholar
  11. K.-H. Liang and H.-Y. Chang, “0.5-6 GHz low-voltage low-power mixer using a modified cascode topology in 0.18 μm CMOS technology,” IET Microwaves, Antennas & Propagation, vol. 5, no. 2, pp. 167–174, 2011. View at Publisher · View at Google Scholar · View at Scopus