Table of Contents Author Guidelines Submit a Manuscript
The Scientific World Journal
Volume 2014 (2014), Article ID 645734, 12 pages
http://dx.doi.org/10.1155/2014/645734
Research Article

Novel Modulation Method for Multidirectional Matrix Converter

1Department of Electrical & Electronic, Faculty of Engineering, Universiti Putra Malaysia (UPM), 43400 Serdang, Selangor, Malaysia
2Institute of Advanced Technology (ITMA), Universiti Putra Malaysia (UPM), 43400 Serdang, Selangor, Malaysia
3Department of Biological Functions Engineering, Graduate School of Life Science and Systems Engineering, Kyushu Institute of Technology, 2-4 Hibikino Wakamatsu-ku, Kitakyushu 808-0916, Japan
4Graduate School of Science and Engineering, Yamaguchi University, 2-16-1 Tokiwadai, Ube-shi, Yamaguchi 755-8611, Japan

Received 21 May 2014; Revised 22 August 2014; Accepted 22 August 2014; Published 14 September 2014

Academic Editor: Fernando Lessa Tofoli

Copyright © 2014 Saman Toosi et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. S. Bhattacharyya, Rural Electrification Through Decentralised Off-Grid Systems in Developing Countries, Green Energy and Technology, Springer, London, UK, 2013. View at Publisher · View at Google Scholar
  2. S. Colle, S. Luna Abreu, and R. Rüther, “Economic evaluation and optimization of hybrid diesel/photovoltaic systems integrated to utility grids,” Solar Energy, vol. 76, no. 1–3, pp. 295–299, 2004. View at Publisher · View at Google Scholar · View at Scopus
  3. M. J. Khan and M. T. Iqbal, “Pre-feasibility study of stand-alone hybrid energy systems for applications in Newfoundland,” Renewable Energy, vol. 30, no. 6, pp. 835–854, 2005. View at Publisher · View at Google Scholar · View at Scopus
  4. P. K. Goel, B. Singh, S. S. Murthy, and N. Kishore, “Isolated wind-hydro hybrid system using cage generators and battery storage,” IEEE Transactions on Industrial Electronics, vol. 58, no. 4, pp. 1141–1153, 2011. View at Publisher · View at Google Scholar · View at Scopus
  5. P. W. Wheeler, J. Rodríguez, J. C. Clare, L. Empringham, and A. Weinstein, “Matrix converters: a technology review,” IEEE Transactions on Industrial Electronics, vol. 49, no. 2, pp. 276–288, 2002. View at Publisher · View at Google Scholar · View at Scopus
  6. M. Venturini and A. Alesina, “he generalised transformer—a new bidirectional sinusoidal waveform frequency converter with continuously adjustable input power factor,” in Proceedings of the Power Electronics Specialists Conference (PESC '80), pp. 242–252, 1980.
  7. A. Alesina and M. G. B. Venturini, “Solid-state power conversion: a fourier analysis approach to generalized transformer synthesis,” IEEE Transactions on Circuits and Systems, vol. 28, no. 4, pp. 319–330, 1981. View at Publisher · View at Google Scholar · View at MathSciNet · View at Scopus
  8. A. Alesina and M. G. B. Venturini, “Analysis and design of optimum-amplitude nine-switch direct AC-AC converters,” IEEE Transactions on Power Electronics, vol. 4, no. 1, pp. 101–112, 1989. View at Publisher · View at Google Scholar · View at Scopus
  9. J. Rodriguez, “A new control technique for AC-AC converters,” in Proceedings of the IFAC Control in Power Electronics and Electrical Drives Conference, pp. 203–208, 1983.
  10. D. Casadei, G. Serra, A. Tani, and L. Zarri, “Matrix converter modulation strategies: a new general approach based on space-vector representation of the switch state,” IEEE Transactions on Industrial Electronics, vol. 49, no. 2, pp. 370–381, 2002. View at Publisher · View at Google Scholar · View at Scopus
  11. C. Klumpner, P. Nielsen, I. Boldea, and F. Blaabjerg, “A new matrix converter motor (MCM) for industry applications,” IEEE Transactions on Industrial Electronics, vol. 49, no. 2, pp. 325–335, 2002. View at Publisher · View at Google Scholar · View at Scopus
  12. K. S. Muhammad, R. Baharom, and M. K. Hamzah, “Advance battery charger topology using SPMC incorporating active power filter,” in Proceeding of the International Conference on Science and Social Research (CSSR ’10), pp. 548–553, Kuala Lumpur, Malaysia, December 2010. View at Publisher · View at Google Scholar · View at Scopus
  13. N. Nguyen-Quang, D. A. Stone, C. M. Bingham, and M. P. Foster, “A three-phase to single-phase matrix converter for high-frequency induction heating,” in Proceedings of the 13th European Conference on Power Electronics and Applications (EPE '09), pp. 1–10, September 2009. View at Scopus
  14. S. Ferreira Pinto and J. Fernando Silva, “Input filter design for sliding mode controlled matrix converters,” in Proceedings of the IEEE 32nd Annual Power Electronics Specialists Conference (PESC '01), pp. 648–653, June 2001. View at Scopus
  15. J.-K. Kang, H. Hara, E. Yamamoto, E. Watanabe, and J. Oyama, “Input Harmonics Damping for High Power Quality Applications of Matrix Converter,” in Proceedings of the 38th IAS Annual Meeting. Conference Record of the Industry Applications Conference, pp. 1498–1503, October 2003. View at Scopus
  16. F. Blaabjerg, D. Casadei, C. Klumpner, and M. Matteini, “Comparison of two current modulation strategies for matrix converters under unbalanced input voltage conditions,” IEEE Transactions on Industrial Electronics, vol. 49, no. 2, pp. 289–296, 2002. View at Publisher · View at Google Scholar · View at Scopus
  17. L. Wei, Y. Matsushita, and T. A. Lipo, “Investigation of dual-bridge matrix converter operating under unbalanced source voltages,” in Proceedings of the IEEE 34th Annual Power Electronics Specialists Conference (PESC '03), pp. 1293–1298, June 2003. View at Scopus
  18. Y.-D. Yoon and S.-K. Sul, “Carrier-based modulation method for matrix converter with input power factor control and under unbalanced input voltage conditions,” in Proceedings of the 22nd Annual IEEE Applied Power Electronics Conference and Exposition (APEC '07), pp. 310–314, March 2007. View at Publisher · View at Google Scholar · View at Scopus
  19. O. Simon, J. Mahlein, M. N. Muenzer, and M. Bruckmann, “Modern solutions for industrial matrix-converter applications,” IEEE Transactions on Industrial Electronics, vol. 49, no. 2, pp. 401–406, 2002. View at Publisher · View at Google Scholar · View at Scopus
  20. D. Casadei, G. Serra, A. Tani, and L. Zarri, “Stability analysis of electrical drives fed by matrix converters,” in Proceedings of the IEEE International Symposium on Industrial Electronics (ISIE '02), pp. 1108–1113, 2002.
  21. D. Casadei, G. Serra, A. Tani, and L. Zarri, “Effects of input voltage measurement on stability of matrix converter drive system,” IEE Proceedings: Electric Power Applications, vol. 151, no. 4, pp. 487–497, 2004. View at Publisher · View at Google Scholar · View at Scopus
  22. Y. Li, N. S. Choi, B. M. Han, K. M. Kim, B. Lee, and J. H. Park, “Direct duty ratio pulse width modulation method for matrix converters,” International Journal of Control, Automation and Systems, vol. 6, no. 5, pp. 660–669, 2008. View at Google Scholar · View at Scopus
  23. Y.-D. Yoon and S.-K. Sul, “Carrier-based modulation technique for matrix converter,” IEEE Transactions on Power Electronics, vol. 21, no. 6, pp. 1691–1703, 2006. View at Publisher · View at Google Scholar · View at Scopus
  24. K. T. Chau and C. C. Chan, “Emerging energy-efficient technologies for hybrid electric vehicles,” Proceedings of the IEEE, vol. 95, no. 4, pp. 821–835, 2007. View at Publisher · View at Google Scholar · View at Scopus
  25. Y. Li and N.-S. Choi, “Carrier based pulse width modulation for matrix converters,” in Proceedings of the 24th Annual IEEE Applied Power Electronics Conference and Exposition (APEC ’09), pp. 1709–1715, February 2009. View at Publisher · View at Google Scholar · View at Scopus
  26. D. Liu and H. Li, “A ZVS bi-directional DC-DC converter for multiple energy storage elements,” IEEE Transactions on Power Electronics, vol. 21, no. 5, pp. 1513–1517, 2006. View at Publisher · View at Google Scholar · View at Scopus
  27. M. Qiang, W.-Y. Wu, and Z.-L. Xu, “A multi-directional power converter for a hybrid renewable energy distributed generation system with battery storage,” in CES/IEEE 5th International Power Electronics and Motion Control Conference (IPEMC '06), vol. 3, pp. 1–5, Shanghai, China, 2006. View at Publisher · View at Google Scholar
  28. S. Toosi, M. Norhisam, T. Hanamoto, I. B. Aris, M. A. M. Radzi, and H. Yamada, “Configurations comparison of multi directional matrix converter for low power application,” Journal of Engineering Science and Technology, vol. 9, pp. 1–10, 2014. View at Google Scholar
  29. S. Ashok, “Optimised model for community-based hybrid energy system,” Renewable Energy, vol. 32, no. 7, pp. 1155–1164, 2007. View at Publisher · View at Google Scholar · View at Scopus
  30. L. Barote, R. Weissbach, R. Teodorescu, C. Marinescu, and M. Cirstea, “Stand-alone wind system with vanadium redox battery energy storage,” in Proceedings of the 11th International Conference on Optimization of Electrical and Electronic Equipment (OPTIM '08), pp. 407–412, Brașov, Romania, May 2008. View at Publisher · View at Google Scholar · View at Scopus
  31. E. Koutroulis and K. Kalaitzakis, “Design of a maximum power tracking system for wind-energy-conversion applications,” IEEE Transactions on Industrial Electronics, vol. 53, no. 2, pp. 486–494, 2006. View at Publisher · View at Google Scholar · View at Scopus
  32. J. W. Stevens and G. P. Corey, “Study of lead-acid battery efficiency near top-of-charge and the impact on PV system design,” in Proceedings of the 25th IEEE Photovoltaic Specialists Conference, pp. 1485–1488, May 1996. View at Scopus