Table of Contents Author Guidelines Submit a Manuscript
Research Letters in Materials Science
Volume 2007 (2007), Article ID 34737, 4 pages
http://dx.doi.org/10.1155/2007/34737
Research Letter

Freeform Fabrication of Titanium Aluminide via Electron Beam Melting Using Prealloyed and Blended Powders

Edward P. Fitts Department of Industrial and Systems Engineering, North Carolina State University, Raleigh, NC 27695-7906, USA

Received 28 October 2007; Accepted 27 December 2007

Academic Editor: Rui Vilar

Copyright © 2007 Denis Cormier et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. J. H. Moll and B. J. McTiernan, “PM TiAl alloys: the sky's the limit,” Metal Powder Report, vol. 55, no. 1, pp. 18–22, 2000. View at Publisher · View at Google Scholar
  2. J. H. Moll, E. Whitney, C. Yolton, and U. Habel, “Laser forming of gamma titanium aluminide,” in Gamma Titanium Aluminides, Y.-W. Kim, D. M. Dimiduk, and M. H. Loretto, Eds., pp. 255–263, TMS, Warrendale, Pa, USA, 1999. View at Google Scholar
  3. D. Srivastava, I. T. H. Chang, and M. H. Loretto, “The effect of process parameters and heat treatment on the microstructure of direct laser fabricated TiAl alloy samples,” Intermetallics, vol. 9, no. 12, pp. 1003–1013, 2001. View at Publisher · View at Google Scholar
  4. W. Liu and J. DuPont, “In-situ reactive rapid prototyping of intermetallic compounds by LENS processing,” in Rapid Prototyping of Materials, F. D. S. Marquis and D. L. Bourell, Eds., pp. 95–106, TMS, Warrendale, Pa, USA, 2002. View at Google Scholar
  5. D. Cormier, O. Harrysson, and H. West, “Characterization of H13 steel produced via electron beam melting,” Rapid Prototyping Journal, vol. 10, no. 1, pp. 35–41, 2004. View at Publisher · View at Google Scholar
  6. M. Chandrasekaran and Z. S. Xia, “Effect of alloying time and composition on the mechanical properties of Ti alloy,” Materials Science and Engineering A, vol. 394, no. 1-2, pp. 220–228, 2005. View at Publisher · View at Google Scholar
  7. F. Wenbin, H. Lianxi, H. Wenxiong, W. Erde, and L. Xiaoqing, “Microstructure and properties of a TiAl alloy prepared by mechanical milling and subsequent reactive sintering,” Materials Science and Engineering A, vol. 403, no. 1-2, pp. 186–190, 2005. View at Publisher · View at Google Scholar