Table of Contents Author Guidelines Submit a Manuscript
Advances in Materials Science and Engineering
Volume 2014 (2014), Article ID 274071, 12 pages
http://dx.doi.org/10.1155/2014/274071
Research Article

Acoustic Emission Measurement by Fiber Bragg Grating Glued to Cylindrical Sensor Holder

1Department of Mechanical Engineering, Kansai University, Yamatecho 3-3-35, Suita, Osaka 564-8680, Japan
2Graduate School of Engineering, Kansai University, Yamatecho 3-3-35, Suita, Osaka 564-8680, Japan

Received 10 October 2013; Revised 11 December 2013; Accepted 12 December 2013; Published 10 February 2014

Academic Editor: Noriah Bidin

Copyright © 2014 Masanori Takuma et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. F. K. Chang, Structural Health Monitoring 2003, DEStech Publications, Lancaster, Pa, USA, 2003.
  2. H. Iwaki, H. Yamakawa, K. Shiba, and A. Mita, “Structural health monitoring system using FBG-based sensors for a damage tolerant building,” in Proceedings of the 3rd International Workshop on Structural Health monitoring, pp. 584–539, September 2001. View at Scopus
  3. S. Yashiro and N. Takeda, “A new approach for estimation of damage patterns in CFRP composite laminates using embedded FBG sensors,” Transactions of the Japan Society of Mechanical Engineers A, vol. 71, no. 706, pp. 897–904, 2005. View at Google Scholar · View at Scopus
  4. T. Matsuo, H. Cho, and M. Takemoto, “A new cascade multi sensor optical fiber AE system for the source dynamics and location,” Transactions of the Japan Society of Mechanical Engineers A, vol. 72, no. 724, pp. 1895–1903, 2006. View at Google Scholar · View at Scopus
  5. M. Takamoto, H. Cho, and H. Suzuki, “Lamb-wave acoustic emission for condition monitoring of tank bottom plates,” Journal of Acoustic Emission, vol. 24, pp. 12–21, 2006. View at Google Scholar
  6. S. Yuyama, Z. Li, M. Yamada et al., “Noise analysis for acoustic emission evaluation of floor conditions in above-ground tank,” Journal of the Japanese Society for Non-Destructive Inspection, vol. 53, no. 11, pp. 693–700, 2004. View at Google Scholar
  7. H. Yuki, H. Ishikawa, T. Iwamoto, and S. Ijima, “Development of acoustic emission sensor using transverse misalignment of optical fibers,” Journal of the Japanese Society for Non-Destructive Inspection, vol. 53, no. 3, pp. 170–175, 2004. View at Google Scholar
  8. T. Matsuo, Y. Mizutani, H. Nishino, and M. Takemoto, “Source location of lamb AEs using optical fiber AE monitoring systems,” Journal of the Japanese Society for Non-Destructive Inspection, vol. 52, no. 3, pp. 137–142, 2003. View at Google Scholar
  9. R. Tsuji, J. Mizusawa, Y. Maeda, and N. Aya, “Development of multipurpose sensor using Mach-Zehnder type optical fiber interferometer,” IEICE Technical Report, Vol.104 507, 2004. View at Google Scholar
  10. H. Yuki, “Characteristics of Mach-Zehnder interferometer type optical fiber AE sensor,” Journal of the Japanese Society for Non-Destructive Inspection, vol. 54, no. 2, pp. 66–69, 2005. View at Google Scholar
  11. H. Cho, R. Arai, and M. Takemoto, “Development of stabilized and high sensitive optical fiber acoustic emission system and its application,” Journal of Acoustic Emission, vol. 23, pp. 72–80, 2005. View at Google Scholar
  12. T. Matsuo, H. Cho, and M. Takemoto, “Utilization of cascade optical fiber AE system for source location of lamb waves through a cross-ply CFRP plate,” Journal of Acoustic Emission, vol. 24, pp. 84–96, 2006. View at Google Scholar
  13. T. Matsuo, H. Cho, and M. Takemoto, “Development of a new cascade multi-sensor optical fiber AE system,” in Proceedings of the Progress in Acoustic Emission XIII, pp. 19–26, 2006.
  14. T. Matsuo, H. Cho, and M. Takemoto, “A new cascade multi sensor optical fiber AE system for the source dynamics and location,” Transactions of the Japan Society of Mechanical Engineers A, vol. 72, no. 724, pp. 1895–1903, 2006. View at Google Scholar · View at Scopus
  15. K. O. Hill and G. Meltz, “Fiber Bragg grating technology fundamentals and overview,” Journal of Lightwave Technology, vol. 15, no. 8, pp. 1263–1276, 1997. View at Publisher · View at Google Scholar · View at Scopus
  16. H. Tsuda, “AE measurement using fiber Bragg gratings,” Journal of the Japanese Society for Non-Destructive Inspection, vol. 52, no. 10, pp. 539–543, 2003. View at Google Scholar
  17. N. Takahashi, K. Yoshimura, S. Takahashi, and K. Imamura, “Development of an optical fiber hydrophone with fiber Bragg grating,” Ultrasonics, vol. 38, no. 1–8, pp. 581–585, 2000. View at Publisher · View at Google Scholar · View at Scopus
  18. G. Wild and S. Hinckley, “Acousto-ultrasonic optical fiber sensors: overview and state-of-the-art,” IEEE Sensors Journal, vol. 8, no. 7, pp. 1184–1193, 2008. View at Publisher · View at Google Scholar · View at Scopus
  19. H. Tsuda, “Development of fiber Bragg grating sensors for structural health monitoring,” Journal of the Japanese Society for Non-Destructive Inspection, vol. 54, no. 2, pp. 71–75, 2005. View at Google Scholar
  20. H. Tamada, J. Kuwahara, Y. Okabe, N. Takeda, and S. Kojima, “Detection of delaminations in CFRP laminates by using FBG sensors as lamb wave receiver,” Transactions of the Japan Society for Aeronautical and Space Sciences, vol. 53, no. 615, pp. 166–173, 2005. View at Google Scholar
  21. “The Japanese society for non-destructive inspection,” Acoustic Emission, pp.22–23, (1990).
  22. S. Hisada, T. Suzuki, S. Nakahara, and T. Fujita, “Visualization and measurements of sound pressure distribution of ultrasonic wave by stroboscopic real-time holographic interferometry,” Japanese Journal of Applied Physics, vol. 41, no. 5B, pp. 3316–3324, 2002. View at Publisher · View at Google Scholar · View at Scopus
  23. S. Somiya, T. Asano, and T. Sugiyama, “Relationship between frequency distribution characteristics of acoustic emission and fracture mechanisms on AFRP (2nd report, analysis of frequency distribution by weighted mean frequency distribution method),” Transactions of the Japan Society of Mechanical Engineers A, vol. 62, no. 598, pp. 1376–1381, 1996. View at Google Scholar · View at Scopus
  24. H. Suzuki, T. Kinjo, Y. Hayashi, M. Takemoto, and K. Ono, “Wavelet transform of acoustic emission signals,” Journal of Acoustic Emission, vol. 14, no. 2, pp. 69–84, 1996. View at Google Scholar
  25. E. P. Serrano and M. A. Fabio, “Application of the wavelet transform to acoustic emission signals processing,” IEEE Transactions on Signal Processing, vol. 44, no. 5, pp. 1270–1275, 1996. View at Publisher · View at Google Scholar · View at Scopus
  26. H. Inoue, K. Kishimoto, T. Nakanishi, and T. Shibuya, “Time-frequency analysis of dispersive stress waves by means of wavelet transform (identification of group velocity and application to ultrasonic materials evaluation),” Transactions of the Japan Society of Mechanical Engineers A, vol. 61, no. 581, pp. 153–160, 1995. View at Google Scholar · View at Scopus