Table of Contents Author Guidelines Submit a Manuscript
Advances in Materials Science and Engineering
Volume 2014, Article ID 485267, 13 pages
http://dx.doi.org/10.1155/2014/485267
Research Article

Investigating the Possibility to Reduce the Residual Stress Level in 2.5D Cutting Using Titanium Coated Carbide Ball End Mill

1Centre of Advanced Manufacturing and Material Processing, Department of Mechanical Engineering, University of Malaya, 50603 Kuala Lumpur, Malaysia
2Institute of Product Design and Manufacturing, Universiti Kuala Lumpur, Cheras, 56100 Kuala Lumpur, Malaysia
3Department of Mechanical Engineering, Faculty of Engineering, Assiut University, Assiut 71516, Egypt

Received 2 April 2014; Accepted 6 August 2014; Published 27 August 2014

Academic Editor: Haiming Lu

Copyright © 2014 N. Masmiati et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

How to Cite this Article

N. Masmiati, H. S. Chan, Ahmed A. D. Sarhan, M. A. Hassan, and M. Hamdi, “Investigating the Possibility to Reduce the Residual Stress Level in 2.5D Cutting Using Titanium Coated Carbide Ball End Mill,” Advances in Materials Science and Engineering, vol. 2014, Article ID 485267, 13 pages, 2014. https://doi.org/10.1155/2014/485267.