Table of Contents Author Guidelines Submit a Manuscript
Advances in Materials Science and Engineering
Volume 2014, Article ID 769206, 8 pages
http://dx.doi.org/10.1155/2014/769206
Research Article

Characterization of Material Stiffness on Injection Moulded Microspecimens Using Different Test Methods

Institute of Polymer Technology, University Erlangen-Nuernberg, Am Weichselgarten 9, 91058 Erlangen, Germany

Received 10 March 2014; Accepted 25 June 2014; Published 10 July 2014

Academic Editor: Steve Bull

Copyright © 2014 Dietmar Drummer et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Citations to this Article [3 citations]

The following is the list of published articles that have cited the current article.

  • Dietmar Drummer, and Steve Meister, “Correlation of Processing, Inner Structure, and Part Properties of Injection Moulded Thin-Wall Parts on Example of Polyamide 66,” International Journal of Polymer Science, vol. 2014, pp. 1–8, 2014. View at Publisher · View at Google Scholar
  • Steve Meister, Sebastian Hertle, and Dietmar Drummer, “Layer-dependent characterization of wear behaviour on variothermal injection moulded micro parts using pin on disc measurements,” Microsystem Technologies, 2016. View at Publisher · View at Google Scholar
  • Anne M. Gohn, Alicyn M. Rhoades, Nichole Wonderling, Tim Tighe, and René Androsch, “The effect of supercooling of the melt on the semicrystalline morphology of PA 66,” Thermochimica Acta, 2017. View at Publisher · View at Google Scholar