Table of Contents Author Guidelines Submit a Manuscript
Advances in Materials Science and Engineering
Volume 2014, Article ID 975041, 5 pages
http://dx.doi.org/10.1155/2014/975041
Research Article

Influence of Sc on Microstructure and Mechanical Properties of High Zn-Containing Mg Alloy

1Key Laboratory of Automobile Materials, Ministry of Education, Jilin University, Changchun 130025, China
2State Key Laboratory of Rare Earth Resource Utilization, Changchun Institute of Applied Chemistry, Chinese Academy of Sciences, Changchun 130022, China

Received 1 September 2014; Revised 28 November 2014; Accepted 2 December 2014; Published 18 December 2014

Academic Editor: Jie Dai

Copyright © 2014 Lidong Wang et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. D. K. Xu, W. N. Tang, L. Liu, Y. B. Xu, and E. H. Han, “Effect of Y concentration on the microstructure and mechanical properties of as-cast Mg-Zn-Y-Zr alloys,” Journal of Alloys and Compounds, vol. 432, no. 1-2, pp. 129–134, 2007. View at Publisher · View at Google Scholar · View at Scopus
  2. Q. Li, Q. Wang, Y. Wang, X. Zeng, and W. Ding, “Effect of Nd and Y addition on microstructure and mechanical properties of as-cast Mg-Zn-Zr alloy,” Journal of Alloys and Compounds, vol. 427, no. 1-2, pp. 115–123, 2007. View at Publisher · View at Google Scholar · View at Scopus
  3. Y. Wang, G. Wu, W. Liu, S. Pang, Y. Zhang, and W. Ding, “Effects of chemical composition on the microstructure and mechanical properties of gravity cast Mg-xZn-yRE-Zr alloy,” Materials Science and Engineering A, vol. 594, pp. 52–61, 2014. View at Publisher · View at Google Scholar · View at Scopus
  4. Q. C. Le, Z. Q. Zhang, Z. W. Shao, J. Z. Cui, and Y. Xie, “Microstructures and mechanical properties of Mg-2%Zn-0.4%RE alloys,” Transactions of Nonferrous Metals Society of China, vol. 20, pp. 352–356, 2010. View at Publisher · View at Google Scholar · View at Scopus
  5. Y. Liu, M. Qian, and Z. Fan, “Microstructure and mechanical properties of a Rheo-diecast Mg-10Zn-4.5Al alloy,” Materials Transactions, vol. 46, no. 10, pp. 2221–2228, 2005. View at Publisher · View at Google Scholar · View at Scopus
  6. I. N. G. Antara, K. Suzuki, T. Kayuta, S. Kamado, and Y. Kojima, “Application of semi-solid forming to magnesium alloys with high Al and Zn contents,” Materials Science Forum, vol. 419–422, pp. 629–634, 2003. View at Publisher · View at Google Scholar · View at Scopus
  7. X. C. Wan, H. J. Ni, M. Y. H. Hang, H. L. Zhang, and J. H. Sun, “Microstructure, mechanical properties and creep resistance of Mg−(8%−12%)Zn−(2%−6%)Al alloys,” Transactions of Nonferrous Metals Society of China, vol. 23, pp. 896–903, 2013. View at Google Scholar
  8. F. Von Buch, J. Lietzau, B. L. Mordike, A. Pisch, and R. Schmid-Fetzer, “Development of Mg-Sc-Mn alloys,” Materials Science and Engineering A, vol. 263, no. 1, pp. 1–7, 1999. View at Publisher · View at Google Scholar · View at Scopus
  9. B. L. Mordike, “Development of highly creep resistant magnesium alloys,” Journal of Materials Processing Technology, vol. 117, no. 3, pp. 391–394, 2001. View at Publisher · View at Google Scholar · View at Scopus
  10. B. L. Mordike, I. Stulíková, and B. Smola, “Mechanisms of creep deformation in Mg-Sc-based alloys,” Metallurgical and Materials Transactions A: Physical Metallurgy and Materials Science, vol. 36, no. 7, pp. 1729–1736, 2005. View at Publisher · View at Google Scholar · View at Scopus
  11. X. Y. Fang, D. Q. Yi, and J. F. Nie, “Influence of solution treatments on the age-hardening response of Mg-Gd(-Mn-Sc) alloys,” Journal of Alloys and Compounds, vol. 486, no. 1-2, pp. 900–904, 2009. View at Publisher · View at Google Scholar · View at Scopus
  12. T. T. Liu, F. S. Pan, and X. Y. Zhang, “Effect of Sc addition on the work-hardening behavior of ZK60 magnesium alloy,” Materials & Design, vol. 43, pp. 572–577, 2013. View at Publisher · View at Google Scholar · View at Scopus
  13. J. Z. Dang, Y. F. Huang, and J. Cheng, “Effect of Sc and Zr on microstructures and mechanical properties of as-cast Al-Mg-Si-Mn alloys,” Transactions of Nonferrous Metals Society of China, vol. 19, no. 3, pp. 540–544, 2009. View at Publisher · View at Google Scholar · View at Scopus
  14. S. Costa, H. Puga, J. Barbosa, and A. M. P. Pinto, “The effect of Sc additions on the microstructure and age hardening behaviour of as cast Al-Sc alloys,” Materials and Design, vol. 42, pp. 347–352, 2012. View at Publisher · View at Google Scholar · View at Scopus
  15. J. S. Chun and J. G. Byrne, “Precipitate strengthening mechanisms in magnesium zinc alloy single crystals,” Journal of Materials Science, vol. 4, no. 10, pp. 861–872, 1969. View at Publisher · View at Google Scholar · View at Scopus
  16. Y. Zhang, X. Zeng, L. Liu et al., “Effects of yttrium on microstructure and mechanical properties of hot-extruded Mg-Zn-Y-Zr alloys,” Materials Science and Engineering A, vol. 373, no. 1-2, pp. 320–327, 2004. View at Publisher · View at Google Scholar · View at Scopus
  17. L. L. Rokhlin, Magnesium Alloys Containing Rare Earth Metals, Structure and Properties, Taylor & Francis, London, UK, 2003.
  18. A. Singh, M. Watanabe, A. Kato, and A. P. Tsai, “Microstructure and strength of quasicrystal containing extruded Mg-Zn-Y alloys for elevated temperature application,” Materials Science and Engineering A, vol. 385, no. 1-2, pp. 382–396, 2004. View at Publisher · View at Google Scholar · View at Scopus
  19. C. H. Cáceres and A. Blake, “The strength of concentrated Mg-Zn solid solutions,” Physica Status Solidi (a), vol. 194, no. 1, pp. 147–158, 2002. View at Google Scholar