Table of Contents Author Guidelines Submit a Manuscript
Advances in Materials Science and Engineering
Volume 2017, Article ID 2394641, 11 pages
https://doi.org/10.1155/2017/2394641
Research Article

Properties and Internal Curing of Concrete Containing Recycled Autoclaved Aerated Lightweight Concrete as Aggregate

1Department of Civil Engineering, Faculty of Engineering, Chiang Mai University, 239 Huay Kaew Road, Muang District, Chiang Mai 50200, Thailand
2Center of Excellence for Natural Disaster Management (CENDIM), Chiang Mai University, 239 Huay Kaew Road, Muang District, Chiang Mai 50200, Thailand

Correspondence should be addressed to Pitiwat Wattanachai; ht.ca.umc.gne@tawitip

Received 1 June 2017; Accepted 10 July 2017; Published 20 August 2017

Academic Editor: Tung-Chai Ling

Copyright © 2017 Teewara Suwan and Pitiwat Wattanachai. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. I.-J. Chiou, K.-S. Wang, C.-H. Chen, and Y.-T. Lin, “Lightweight aggregate made from sewage sludge and incinerated ash,” Waste Management, vol. 26, no. 12, pp. 1453–1461, 2006. View at Publisher · View at Google Scholar · View at Scopus
  2. S. Zhao, C. Li, M. Zhao, and X. Zhang, “Experimental study on autogenous and drying shrinkage of steel fiber reinforced lightweight-aggregate concrete,” Advances in Materials Science and Engineering, vol. 2016, Article ID 2589383, 9 pages, 2016. View at Publisher · View at Google Scholar · View at Scopus
  3. P. Lura, M. Wyrzykowski, C. Tang, and E. Lehmann, “Internal curing with lightweight aggregate produced from biomass-derived waste,” Cement and Concrete Research, vol. 59, pp. 24–33, 2014. View at Publisher · View at Google Scholar · View at Scopus
  4. B. Akcay and M. A. Tasdemir, “Optimisation of using lightweight aggregates in mitigating autogenous deformation of concrete,” Construction and Building Materials, vol. 23, no. 1, pp. 353–363, 2009. View at Publisher · View at Google Scholar · View at Scopus
  5. ACI Committee 213, Guild for Structural Lightweight Aggregate Concrete, American Concrete Institute, Detroit, Michigan, Mich, USA, 1999.
  6. K. M. A. Hossain, S. Ahmed, and M. Lachemi, “Lightweight concrete incorporating pumice based blended cement and aggregate: Mechanical and durability characteristics,” Construction and Building Materials, vol. 25, no. 3, pp. 1186–1195, 2011. View at Publisher · View at Google Scholar · View at Scopus
  7. D. Sari and A. G. Pasamehmetoglu, “The effects of gradation and admixture on the pumice lightweight aggregate concrete,” Cement and Concrete Research, vol. 35, no. 5, pp. 936–942, 2005. View at Publisher · View at Google Scholar · View at Scopus
  8. S. Weber and H. W. Reinhardt, “New generation of high performance concrete: concrete with autogeneous curing,” Advanced Cement Based Materials, vol. 6, no. 2, pp. 59–68, 1997. View at Publisher · View at Google Scholar · View at Scopus
  9. T. Y. Lo, H. Z. Cui, and Z. G. Li, “Influence of aggregate pre-wetting and fly ash on mechanical properties of lightweight concrete,” Waste Management, vol. 24, no. 4, pp. 333–338, 2004. View at Publisher · View at Google Scholar · View at Scopus
  10. W. Yodsudjai, Evaluation of strengths and choride ion diffusivity of minute regions in concrete using newly developed methods [Ph.D. thesis], Tokyo Institute of Technology, Japan, 2003.
  11. W. C. Tang, P. C. Ryan, H. Z. Cui, and W. Liao, “Properties of self-compacting concrete with recycled coarse aggregate,” Advances in Materials Science and Engineering, vol. 2016, Article ID 2761294, 2016. View at Publisher · View at Google Scholar · View at Scopus
  12. M. Singh and R. Siddique, “Effect of coal bottom ash as partial replacement of sand on workability and strength properties of concrete,” Journal of Cleaner Production, vol. 112, pp. 620–630, 2016. View at Publisher · View at Google Scholar · View at Scopus
  13. I. B. Topçu and B. Işikdaǧ, “Effect of expanded perlite aggregate on the properties of lightweight concrete,” Journal of Materials Processing Technology, vol. 204, no. 1-3, pp. 34–38, 2008. View at Publisher · View at Google Scholar · View at Scopus
  14. P. Wattanachai, N. Otsuki, T. Saito, and R. Wongjeeraphat, “Influence of curing condition on the properties of mae moh fly ash mortar at surface and interior,” in Proceedings of the Proceeding of the 6th Regional Symposium on Infrastructure Development, Bangkok, Thailand, January 2009.
  15. M. Suzuki, M. Seddik Meddah, and R. Sato, “Use of porous ceramic waste aggregates for internal curing of high-performance concrete,” Cement and Concrete Research, vol. 39, no. 5, pp. 373–381, 2009. View at Publisher · View at Google Scholar · View at Scopus
  16. R. Kasemchaisiri and S. Tangtermsirikul, “A method to determine water retainability of porous fine aggregate for design and quality control of fresh concrete,” Construction and Building Materials, vol. 21, no. 6, pp. 1322–1334, 2007. View at Publisher · View at Google Scholar · View at Scopus