Table of Contents Author Guidelines Submit a Manuscript
Advances in Materials Science and Engineering
Volume 2017, Article ID 3658161, 9 pages
https://doi.org/10.1155/2017/3658161
Research Article

Evaluation of Materials in a Biomechanical System for Uses in Industrial Lifting Activities

1Bioengineering and Environmental Health Department, Universidad Autónoma de Baja California, Mexicali, BC, Mexico
2Tecnologico Nacional de Mexico, Mexicali, BC, Mexico
3Instituto Tecnologico de Rehabilitacion, Mexicali, BC, Mexico
4Computer Science Department, California State University, Bakersfield, CA, USA

Correspondence should be addressed to Roberto L. Avitia; xm.ude.cbau@aitivar

Received 23 September 2016; Revised 12 December 2016; Accepted 5 January 2017; Published 19 February 2017

Academic Editor: Sumin Kim

Copyright © 2017 Roberto L. Avitia et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. M. Fernández, Preparación Mecánica y Química de Minerales, Editorial Dossat SA, 2006.
  2. A. Reardon, “Metallurgy for the non-metallurgist,” in ASTM Standards Book, ASM International, 2nd edition, 2011. View at Google Scholar
  3. L.-B. Gustavo, V.-S. Benjamín, and S.-W. Michael, “Atmospheric corrosion in the sea food industry in the Northwwest of México,” Revista Científica Instituto Politécnico, vol. 16, no. 2, pp. 67–73, 2012. View at Google Scholar
  4. G. L. Badilla, B. V. Salas, and M. S. Wiener, “Micro and nano corrosion in steel cans used in the seafood industry,” in Scientific, Health and Social Aspects of the Food Industry, InTech, 2012. View at Google Scholar
  5. M. Anthony, D. Jones, and H. Rayner, “An introduction to microstructures, processing and design of steels,” Materials, Methods and Treatments Journal, vol. 3, no. 2, pp. 56–63, 2002. View at Google Scholar
  6. A. Tsouknidas, S. Savvakis, Y. Asaniotis, K. Anagnostidis, A. Lontos, and N. Michailidis, “The effect of kyphoplasty parameters on the dynamic load transfer within the lumbar spine considering the response of a bio-realistic spine segment,” Clinical Biomechanics, vol. 28, no. 9-10, pp. 949–955, 2013. View at Publisher · View at Google Scholar · View at Scopus
  7. J. S. Temenoff and A. G. Mikos, Biomaterials: The Intersection of Biology and Materials Science, Pearson/Prentice Hall, Upper Saddle River, NJ, USA, 2008.
  8. ASTM Standards, Standards to Technical Experiments, ASTM, 2000.