Table of Contents Author Guidelines Submit a Manuscript
Advances in Materials Science and Engineering
Volume 2017 (2017), Article ID 8723239, 23 pages
https://doi.org/10.1155/2017/8723239
Review Article

A Review of Additive Mixed-Electric Discharge Machining: Current Status and Future Perspectives for Surface Modification of Biomedical Implants

1Centre for Intelligent Signal and Imaging Research, Universiti Teknologi PETRONAS, Bandar Seri Iskandar, Perak, Malaysia
2Mechanical Engineering Department, University Technology PETRONAS, Bandar Seri Iskandar, Perak, Malaysia
3School of Mechanical Engineering, Lovely Professional University, Phagwara, Punjab 144411, India
4Faculty of Machine Manufacturing & Industrial Management, Gheorghe Asachi Technical University of Iaşi, 59 A Prof. Dimitrie, Iaşi, Romania
5Manufacturing Section, Universiti Kuala Lumpur Malaysian Spanish Institute, Kulim Hi-Tech Park, 09000 Kedah, Malaysia

Correspondence should be addressed to Ahmad Majdi Abdul-Rani; ym.ude.ptu@idjam

Received 23 April 2017; Accepted 1 August 2017; Published 13 September 2017

Academic Editor: Patrice Berthod

Copyright © 2017 Abdul’Azeez Abdu Aliyu et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

How to Cite this Article

Abdul’Azeez Abdu Aliyu, Ahmad Majdi Abdul-Rani, Turnad Lenggo Ginta, et al., “A Review of Additive Mixed-Electric Discharge Machining: Current Status and Future Perspectives for Surface Modification of Biomedical Implants,” Advances in Materials Science and Engineering, vol. 2017, Article ID 8723239, 23 pages, 2017. doi:10.1155/2017/8723239