Table of Contents Author Guidelines Submit a Manuscript
Table of Contents Alerts

To receive news and publication updates for Advances in Materials Science and Engineering, enter your email address in the box below.

Advances in Materials Science and Engineering
Volume 2018, Article ID 9512957, 12 pages
https://doi.org/10.1155/2018/9512957
Research Article

Influence of Thermal Parameters, Microstructure, and Morphology of Si on Machinability of an Al–7.0 wt.% Si Alloy Directionally Solidified

Cássio A. P. Silva,1 Layo R. M. Leal,1 Emanuelle C. Guimarães,1 Paulo M. Júnior,1 Antonio L. Moreira,1 Otávio L. Rocha,2 and Adrina P. Silva1

1Federal University of Pará, Augusto Correa Avenue 01, P.O. Box 479, Belém, PA, Brazil
2Federal Institute of Education, Science and Technology of Pará, Almirante Barroso Avenue 1155, P.O. Box 66093-020, Belém, PA, Brazil

Correspondence should be addressed to Adrina P. Silva; moc.liamg@callitseairam

Received 16 August 2017; Accepted 20 February 2018; Published 3 April 2018

Academic Editor: Patrice Berthod

Copyright © 2018 Cássio A. P. Silva et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

How to Cite this Article

Cássio A. P. Silva, Layo R. M. Leal, Emanuelle C. Guimarães, et al., “Influence of Thermal Parameters, Microstructure, and Morphology of Si on Machinability of an Al–7.0 wt.% Si Alloy Directionally Solidified,” Advances in Materials Science and Engineering, vol. 2018, Article ID 9512957, 12 pages, 2018. https://doi.org/10.1155/2018/9512957.