Table of Contents Author Guidelines Submit a Manuscript
Advances in Tribology
Volume 2016 (2016), Article ID 6545904, 11 pages
http://dx.doi.org/10.1155/2016/6545904
Research Article

The Application of Response Surface Methodology in the Investigation of the Tribological Behavior of Palm Cooking Oil Blended in Engine Oil

1Faculty of Mechanical Engineering, University Malaysia Pahang, Pekan, Pahang, Malaysia
2Automotive Engineering Research Group (AERG), University Malaysia Pahang, Pekan, Pahang, Malaysia

Received 16 July 2015; Revised 20 October 2015; Accepted 29 October 2015

Academic Editor: Shyam Bahadur

Copyright © 2016 M. H. Sakinah et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. L. Pop, C. Puşcaş, G. Bandur, G. Vlase, and R. Nuţiu, “Basestock oils for lubricants from mixtures of corn oil and synthetic diesters,” Journal of the American Oil Chemists' Society, vol. 85, no. 1, pp. 71–76, 2008. View at Publisher · View at Google Scholar · View at Scopus
  2. S. Sadaka and A. A. Boateng, Pyrolysis and Bio-Oil, Cooperative Extension Service, US Department of Agriculture and County Governments Cooperating, University of Arkansas, Fayetteville, Ark, USA, 2009.
  3. C.-C. Ting and C.-C. Chen, “Viscosity and working efficiency analysis of soybean oil based bio-lubricants,” Measurement, vol. 44, no. 8, pp. 1337–1341, 2011. View at Publisher · View at Google Scholar
  4. K. Cheenkachorn and B. Fungtammasan, “Development of engine oil using palm oil as a base stock for four-stroke engines,” Energy, vol. 35, no. 6, pp. 2552–2556, 2010. View at Publisher · View at Google Scholar · View at Scopus
  5. M. H. Jayed, H. H. Masjuki, R. Saidur, M. A. Kalam, and M. I. Jahirul, “Environmental aspects and challenges of oilseed produced biodiesel in Southeast Asia,” Renewable and Sustainable Energy Reviews, vol. 13, no. 9, pp. 2452–2462, 2009. View at Publisher · View at Google Scholar · View at Scopus
  6. S. Syahrullail, B. M. Zubil, C. S. N. Azwadi, and M. J. M. Ridzuan, “Experimental evaluation of palm oil as lubricant in cold forward extrusion process,” International Journal of Mechanical Sciences, vol. 53, no. 7, pp. 549–555, 2011. View at Publisher · View at Google Scholar · View at Scopus
  7. R. Kreivaitis, M. Gumbyte, K. Kazancev, J. Padgurskas, and V. Makarevičiene, “A comparison of pure and natural antioxidant modified rapeseed oil storage properties,” Industrial Crops and Products, vol. 43, pp. 511–516, 2013. View at Publisher · View at Google Scholar · View at Scopus
  8. B. Balasubramaniam, A. Sudalaiyadum Perumal, J. Jayaraman, J. Mani, and P. Ramanujam, “Comparative analysis for the production of fatty acid alkyl esterase using whole cell biocatalyst and purified enzyme from Rhizopus oryzae on waste cooking oil (sunflower oil),” Waste Management, vol. 32, no. 8, pp. 1539–1547, 2012. View at Publisher · View at Google Scholar · View at Scopus
  9. M. A. Kalam, H. H. Masjuki, M. Varman, and A. M. Liaquat, “Friction and wear characteristics of waste vegetable oil contaminated lubricants,” International Journal of Mechanical and Materials Engineering, vol. 6, no. 3, pp. 431–436, 2011. View at Google Scholar · View at Scopus
  10. A. Zeman, A. Sprengel, D. Niedermeier, and M. Späth, “Biodegradable lubricants—studies on thermo-oxidation of metal-working and hydraulic fluids by differential scanning calorimetry (DSC),” Thermochimica Acta, vol. 268, pp. 9–15, 1995. View at Publisher · View at Google Scholar
  11. H. H. Masjuki and M. A. Maleque, “The effect of palm oil diesel fuel contaminated lubricant on sliding wear of cast irons against mild steel,” Wear, vol. 198, no. 1-2, pp. 293–299, 1996. View at Publisher · View at Google Scholar · View at Scopus
  12. İ. Cesur, V. Ayhan, A. Parlak, O. Sava , and Z. Aydin, “The effects of different fuels on wear between piston ring and cylinder,” Advances in Mechanical Engineering, vol. 6, Article ID 503212, pp. 1–8, 2014. View at Publisher · View at Google Scholar
  13. D. C. Montgomery, Design and Analysis of Experiments, Wiley, New Delhi, India, 2007.
  14. C. P. Koshy, P. K. Rajendrakumar, and M. V. Thottackkad, “Evaluation of the tribological and thermo-physical properties of coconut oil added with MoS2 nanoparticles at elevated temperatures,” Wear, vol. 330-331, pp. 288–308, 2015. View at Publisher · View at Google Scholar
  15. M. M. Noor, A. P. Wandel, and T. Yusaf, “A review of mild combustion and open furnace design consideration,” International Journal of Automotive and Mechanical Engineering, vol. 6, no. 1, pp. 730–754, 2012. View at Publisher · View at Google Scholar · View at Scopus
  16. H. M. Mobarak, E. Niza Mohamad, H. H. Masjuki et al., “The prospects of biolubricants as alternatives in automotive applications,” Renewable and Sustainable Energy Reviews, vol. 33, pp. 34–43, 2014. View at Publisher · View at Google Scholar · View at Scopus
  17. N. W. M. Zulkifli, M. A. Kalam, H. H. Masjuki, M. Shahabuddin, and R. Yunus, “Wear prevention characteristics of a palm oil-based TMP (trimethylolpropane) ester as an engine lubricant,” Energy, vol. 54, pp. 167–173, 2013. View at Publisher · View at Google Scholar · View at Scopus
  18. Water in Oil Contamination, http://www.machinerylubrication.com/Read/192/water-contaminant-oil.
  19. P. Rajasekhar, G. Ganesan, and C. Senthilkumar, “Studies on tribological behavior of polyamide filled jute fiber-nano-ZnO hybrid composites,” Procedia Engineering, vol. 97, pp. 2099–2109, 2014. View at Publisher · View at Google Scholar
  20. B. P. Chang, H. M. Akil, M. G. Affendy, A. Khan, and R. B. M. Nasir, “Comparative study of wear performance of particulate and fiber-reinforced nano-ZnO/ultra-high molecular weight polyethylene hybrid composites using response surface methodology,” Materials & Design, vol. 63, pp. 805–819, 2014. View at Publisher · View at Google Scholar · View at Scopus
  21. M. Shahabuddin, H. H. Masjuki, M. A. Kalam, M. M. K. Bhuiya, and H. Mehat, “Comparative tribological investigation of bio-lubricant formulated from a non-edible oil source (Jatropha oil),” Industrial Crops and Products, vol. 47, pp. 323–330, 2013. View at Publisher · View at Google Scholar · View at Scopus