Table of Contents Author Guidelines Submit a Manuscript
International Journal of Photoenergy
Volume 2016 (2016), Article ID 3801918, 17 pages
http://dx.doi.org/10.1155/2016/3801918
Research Article

Performance Analysis of Solar Assisted Fluidized Bed Dryer Integrated Biomass Furnace with and without Heat Pump for Drying of Paddy

Fakultas Teknologi Industri, Institut Teknologi Padang, Padang, West Sumatra 25132, Indonesia

Received 22 July 2016; Accepted 27 September 2016

Academic Editor: Alessandro Burgio

Copyright © 2016 M. Yahya. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. BPS (Badan Pusat Statistik Indonesia), Statistik Indonesia, BPS, Jakarta, Indonesia, 2015.
  2. H. K. Purwadaria, “Problems and priorities of grain drying in Indonesia,” in Proceedings of the International Conference Grain Drying in Asia, vol. 71 of ACIAR Proceedings, pp. 201–209, 74 FAO Regional Office for Asia and the Pacific, Bangkok, Thailand, 1995.
  3. C. Bonazzi, M. A. du Peuty, and A. Themelin, “Influence of drying conditions on the processing quality of rough rice,” Drying Technology, vol. 15, no. 3-4, pp. 1141–1157, 1997. View at Publisher · View at Google Scholar · View at Scopus
  4. M. Izadifar and D. Mowla, “Simulation of a cross-flow continuous fluidized bed dryer for paddy rice,” Journal of Food Engineering, vol. 58, no. 4, pp. 325–329, 2003. View at Publisher · View at Google Scholar · View at Scopus
  5. R. Sivakumar, R. Saravanan, A. Elaya Perumal, and S. Iniyan, “Fluidized bed drying of some agro products—a review,” Renewable and Sustainable Energy Reviews, vol. 61, pp. 280–301, 2016. View at Publisher · View at Google Scholar
  6. A. S. Kassem, A. Z. Shokr, A. R. El-Mahdy, A. M. Aboukarima, and E. Y. Hamed, “Comparison of drying characteristics of Thompson seedless grapes using combined microwave oven and hot air drying,” Journal of the Saudi Society of Agricultural Sciences, vol. 10, no. 1, pp. 33–40, 2011. View at Publisher · View at Google Scholar
  7. S. Soponronnarit, M. Yapha, and S. Prachayawarakorn, “Cross-flow fluidized bed paddy dryer: prototype and commercialization,” Drying Technology, vol. 13, no. 8-9, pp. 2207–2216, 1995. View at Publisher · View at Google Scholar · View at Scopus
  8. M. N. Ibrahim, M. S. H. Sarker, N. Ab Aziz, and P. M. Salleh, “Drying performances and milling quality of rice during industrial fluidized bed drying of paddy in Malaysia,” Pertanika Journal of Science and Technology, vol. 23, no. 2, pp. 297–309, 2015. View at Google Scholar · View at Scopus
  9. M. Yahya, “Design and performance evaluation of a solar assisted heat pump dryer integrated with biomass furnace for red chilli,” International Journal of Photoenergy, vol. 2016, Article ID 8763947, 14 pages, 2016. View at Publisher · View at Google Scholar
  10. J. O. Akowuah, A. Addo, and A. B. Plauge, “Influence of drying temperature and storage duration on fissuring and milling quality of Jasmin 85 rice variety,” Journal of Science and Technology, vol. 32, no. 2, pp. 26–33, 2012. View at Google Scholar
  11. P. Jaiboon, S. Prachayawarakorn, S. Devahastin, and S. Soponronnarit, “Effects of fluidized bed drying temperature and tempering time on quality of waxy rice,” Journal of Food Engineering, vol. 95, no. 3, pp. 517–524, 2009. View at Publisher · View at Google Scholar · View at Scopus
  12. D. A. Schluterman and T. J. Siebenmorgen, “Relating rough rice moisture content reduction and tempering duration to head rice yield reduction,” Transactions of the ASABE, vol. 50, no. 1, pp. 137–142, 2007. View at Publisher · View at Google Scholar · View at Scopus
  13. A. Karbassi and Mehdizadeh, “Drying rough rice in a fluidized bed dryer,” Journal of Agricultural Science and Technology, vol. 14, pp. 233–241, 2008. View at Google Scholar
  14. M. M. S. Dezfouli, S. Mat, M. H. Ruslan, and K. Sopian, “Evaluation of drying chili by two methods: solar assisted heat pump dryer and open sun drying,” in Proceedings of the 1st International Conference on Environmental Informatics (ENINF '13), pp. 112–116, Kuala Lumpur, Malaysia, 2013.
  15. S. Şevik, M. Aktaş, H. Doğan, and S. Koçak, “Mushroom drying with solar assisted heat pump system,” Energy Conversion and Management, vol. 72, pp. 171–178, 2013. View at Publisher · View at Google Scholar
  16. M. Mohanraj, “Performance of a solar-ambient hybrid source heat pump drier for copra drying under hot-humid weather conditions,” Energy for Sustainable Development, vol. 23, pp. 165–169, 2014. View at Publisher · View at Google Scholar · View at Scopus
  17. N. A. Handayani and D. Ariyanti, “Potency of solar energy application in Indonesia,” International Journal of Renewable Energy Development, vol. 1, no. 2, pp. 33–38, 2012. View at Google Scholar
  18. B. Prastowo, “Biomass resource in Indonesia: Indonesia's solid biomass energy potential,” in Proceedings of the Indonesia-German Workshop and Seminar, pp. 1–15, Institute Technology of Bandung, September 2011.
  19. S. Şevik, “Experimental investigation of a new design solar-heat pump dryer under the different climatic conditions and drying behavior of selected products,” Solar Energy, vol. 105, pp. 190–205, 2014. View at Publisher · View at Google Scholar · View at Scopus
  20. E. K. Akpinar and Y. Bicer, “Mathematical modelling of thin layer drying process of long green pepper in solar dryer and under open sun,” Energy Conversion and Management, vol. 49, no. 6, pp. 1367–1375, 2008. View at Publisher · View at Google Scholar · View at Scopus
  21. I. Ceylan and M. Aktaş, “Modeling of a hazelnut dryer assisted heat pump by using artificial neural networks,” Applied Energy, vol. 85, no. 9, pp. 841–854, 2008. View at Publisher · View at Google Scholar · View at Scopus
  22. S. Kooli, A. Fadhel, A. Farhat, and A. Belghith, “Drying of red pepper in open sun and greenhouse conditions. Mathematical modeling and experimental validation,” Journal of Food Engineering, vol. 79, no. 3, pp. 1094–1103, 2007. View at Publisher · View at Google Scholar · View at Scopus
  23. A. Fudholi, M. Y. Othman, M. H. Ruslan, and K. Sopian, “Drying of malaysian Capsicum annuum L. (Red Chili) dried by open and solar drying,” International Journal of Photoenergy, vol. 2013, Article ID 167895, 9 pages, 2013. View at Publisher · View at Google Scholar · View at Scopus
  24. I. Ceylan, M. Aktaş, and H. Doğan, “Energy and exergy analysis of timber dryer assisted heat pump,” Applied Thermal Engineering, vol. 27, no. 1, pp. 216–222, 2007. View at Publisher · View at Google Scholar · View at Scopus
  25. M. Fatouh, M. N. Metwally, A. B. Helali, and M. H. Shedid, “Herbs drying using a heat pump dryer,” Energy Conversion and Management, vol. 47, no. 15-16, pp. 2629–2643, 2006. View at Publisher · View at Google Scholar · View at Scopus
  26. A. Fudholi, K. Sopian, M. Y. Othman, and M. H. Ruslan, “Energy and exergy analyses of solar drying system of red seaweed,” Energy and Buildings, vol. 68, pp. 121–129, 2014. View at Publisher · View at Google Scholar · View at Scopus
  27. M. S. H. Sarker, M. N. Ibrahim, N. A. Aziz, and M. S. Punan, “Application of simulation in determining suitable operating parameters for industrial scale fluidized bed dryer during drying of high impurity moist paddy,” Journal of Stored Products Research, vol. 61, pp. 76–84, 2015. View at Publisher · View at Google Scholar · View at Scopus
  28. M. N. Ibrahim, M. S. H. Sarker, N. A. B. Aziz, and M. Salleh, “Drying performance and overall energy requisite of industrial inclined bed paddy drying in Malaysia,” Journal of Engineering Science and Technology, vol. 9, no. 3, pp. 398–409, 2014. View at Google Scholar
  29. J. Banout, P. Ehl, J. Havlik, B. Lojka, Z. Polesny, and V. Verner, “Design and performance evaluation of a Double-pass solar drier for drying of red chilli (Capsicum annum L.),” Solar Energy, vol. 85, no. 3, pp. 506–515, 2011. View at Publisher · View at Google Scholar · View at Scopus
  30. M. Yahya, A. Fudholi, H. Hafizh, and K. Sopian, “Comparison of solar dryer and solar-assisted heat pump dryer for cassava,” Solar Energy, vol. 136, pp. 606–613, 2016. View at Publisher · View at Google Scholar
  31. M. N. A. Hawlader, S. K. Chou, and M. Z. Ullah, “The performance of a solar assisted heat pump water heating system,” Applied Thermal Engineering, vol. 21, no. 10, pp. 1049–1065, 2001. View at Publisher · View at Google Scholar · View at Scopus
  32. T. Swasdisevi, S. Soponronnarit, A. Shujinda, S. Wetchacama, and V. Thepent, “Rice husk furnace for fluidized bed paddy dryer,” in Proceedings of the 2nd ASEAN Renewable Energy Conference, pp. 603–612, Phuket, Thailand, 1997.
  33. A. Triyono, Skripsi: Karakteristik Briket Arang Dari Campuran Serbuk Gergajian Kayu Afrika dan Sengon Dengan Penambahan Tempurung Kelapa, Fakultas Kehutanan, Institut Pertanian Bogor, Bogor, Indonesia, 2006.
  34. A. M. Leon and S. Kumar, “Design and performance evaluation of a solar-assisted biomass drying system with thermal storage,” Drying Technology, vol. 26, no. 7, pp. 936–947, 2008. View at Publisher · View at Google Scholar · View at Scopus
  35. K. Sacilik, A. K. Elicin, and G. Unal, “Drying kinetics of Üryani plum in a convective hot-air dryer,” Journal of Food Engineering, vol. 76, no. 3, pp. 362–368, 2006. View at Publisher · View at Google Scholar · View at Scopus
  36. L. M. Diamante and P. A. Munro, “Mathematical modeling of hot air drying of sweet potato slices,” International Journal of Food Science & Technology, vol. 26, no. 1, pp. 99–109, 1991. View at Publisher · View at Google Scholar
  37. E. K. Akpinar, “Drying of mint leaves in a solar dryer and under open sun: modelling, performance analyses,” Energy Conversion and Management, vol. 51, no. 12, pp. 2407–2418, 2010. View at Publisher · View at Google Scholar · View at Scopus
  38. R. K. Goyal, A. R. P. Kingsly, M. R. Manikantan, and S. M. Ilyas, “Mathematical modelling of thin layer drying kinetics of plum in a tunnel dryer,” Journal of Food Engineering, vol. 79, no. 1, pp. 176–180, 2007. View at Publisher · View at Google Scholar · View at Scopus
  39. M. Aktaş, I. Ceylan, and S. Yilmaz, “Determination of drying characteristics of apples in a heat pump and solar dryer,” Desalination, vol. 238, no. 1–3, pp. 266–275, 2009. View at Publisher · View at Google Scholar · View at Scopus
  40. K. Sacilik, R. Keskin, and A. K. Elicin, “Mathematical modelling of solar tunnel drying of thin layer organic tomato,” Journal of Food Engineering, vol. 73, no. 3, pp. 231–238, 2006. View at Publisher · View at Google Scholar · View at Scopus
  41. I. Ceylan, M. Aktaş, and H. Doğan, “Mathematical modeling of drying characteristics of tropical fruits,” Applied Thermal Engineering, vol. 27, no. 11-12, pp. 1931–1936, 2007. View at Publisher · View at Google Scholar · View at Scopus
  42. S. Arora, S. Bharti, and V. K. Sehgal, “Convective drying kinetics of red chillies,” Drying Technology, vol. 24, no. 2, pp. 189–193, 2006. View at Publisher · View at Google Scholar · View at Scopus
  43. S. Kaleemullah and R. Kailappan, “Drying kinetics of red chillies in a rotary dryer,” Biosystems Engineering, vol. 92, no. 1, pp. 15–23, 2005. View at Publisher · View at Google Scholar · View at Scopus
  44. P. Luangmalawat, S. Prachayawarakorn, A. Nathakaranakule, and S. Soponronnarit, “Effect of temperature on drying characteristics and quality of cooked rice,” LWT—Food Science and Technology, vol. 41, no. 4, pp. 716–723, 2008. View at Publisher · View at Google Scholar · View at Scopus