Table of Contents Author Guidelines Submit a Manuscript
Research Article
Journal of Engineering
Volume 2018, Article ID 5034149, 1 page
https://doi.org/10.1155/2018/5034149
Corrigendum

Corrigendum to “Final Machining of Large-Scale Engine Block with Modularized Fixture and Virtual Manufacturing Technologies”

1North Minzu University, Yinchuan, Ningxia 750021, China
2KOCEL Machinery Limited, Yinchuan, Ningxia 750021, China

Correspondence should be addressed to Hong Liu; moc.361@uignolh

Received 29 July 2018; Accepted 6 August 2018; Published 2 September 2018

Copyright © 2018 Hong Liu et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.


In the article titled “Final Machining of Large-Scale Engine Block with Modularized Fixture and Virtual Manufacturing Technologies” [1], there was an error in the Acknowledgments section, where the sentence “This work was partially supported by the National Natural Science Foundation of China (2017A0497)” should be corrected to “This work was partially supported by the National Natural Science Foundation of Ningxia (NZ17236).”

References

  1. H. Liu, F. Peng, and Y. Liu, “Final Machining of Large-Scale Engine Block with Modularized Fixture and Virtual Manufacturing Technologies,” Journal of Engineering, vol. 2017, Article ID 3648954, 6 pages, 2017. View at Publisher · View at Google Scholar