Advances in Materials Science and Engineering

Table of Contents: 2016

  • Advances in Materials Science and Engineering -
  • Special Issue
  • Volume 2016
  • - Article ID 3728035
  • - Research Article

Applicability of the Modified Ritchie-Knott-Rice Failure Criterion to Examine the Feasibility of Miniaturized Charpy Type SE(B) Specimens

Toshiyuki Meshii | Teruhiro Yamaguchi | Yuma Higashino
  • Advances in Materials Science and Engineering -
  • Special Issue
  • Volume 2016
  • - Article ID 1898792
  • - Research Article

Investigation of the Performance of Two Passive Controllers in Mitigating the Rotational Response of Irregular Buildings

Yasser Bigdeli | Dookie Kim
  • Advances in Materials Science and Engineering -
  • Special Issue
  • - Volume 2016
  • - Article ID 9520294
  • - Research Article

Effect of Water-Cement Ratio on Pore Structure and Strength of Foam Concrete

Zhongwei Liu | Kang Zhao | ... | Yufei Tang
  • Advances in Materials Science and Engineering -
  • Special Issue
  • Volume 2016
  • - Article ID 6470351
  • - Research Article

Determination of Knitted Fabric Porosity Using Digital Imaging Techniques

Manoj Kumar Imrith | Roshan Unmar | Satyadev Rosunee
  • Advances in Materials Science and Engineering -
  • Special Issue
  • Volume 2016
  • - Article ID 7365906
  • - Research Article

Temperature-Dependent Generalized Planar Fault Energy and Twinnability of Mg Microalloyed with Er, Ho, Dy, Tb, and Gd: First-Principles Study

Lili Liu | Yelu He | ... | Rui Wang
  • Advances in Materials Science and Engineering -
  • Special Issue
  • Volume 2016
  • - Article ID 6371540
  • - Research Article

Quantitative Analysis of Ageing Condition of Insulating Paper Using Infrared Spectroscopy

R. Saldivar-Guerrero | E. N. Cabrera Álvarez | ... | R. Montes-Fernandez
  • Advances in Materials Science and Engineering -
  • Special Issue
  • Volume 2016
  • - Article ID 7841380
  • - Research Article

Effect of Mg Content and Heat Treatment on the Mechanical Properties of Low Pressure Die-Cast 380 Alloy

S. Morin | E. M. Elgallad | ... | F. H. Samuel
  • Advances in Materials Science and Engineering -
  • Special Issue
  • - Volume 2016
  • - Article ID 6474852
  • - Research Article

Impact-Induced Delamination Detection of Composites Based on Laser Ultrasonic Zero-Lag Cross-Correlation Imaging

Yun-Kyu An
  • Advances in Materials Science and Engineering -
  • Special Issue
  • Volume 2016
  • - Article ID 6257368
  • - Research Article

Fe and Fe-P Foam for Biodegradable Bone Replacement Material: Morphology, Corrosion Behaviour, and Mechanical Properties

Monika Hrubovčáková | Miriam Kupková | Miroslav Džupon
  • Advances in Materials Science and Engineering -
  • Special Issue
  • Volume 2016
  • - Article ID 5753970
  • - Research Article

Synergism Analysis of Bedding Slope with Piles and Anchor Cable Support under Sine Wave Vehicle Load

Li Dan-Feng | Wang Lian-Jun
  • Advances in Materials Science and Engineering -
  • Special Issue
  • - Volume 2016
  • - Article ID 4698561
  • - Research Article

Improvement of Saemangeum Dredged Soils Using Coffee Sludge for Vegetation Soil

Daehyeon Kim | Minseok Kim | ... | Kyungho Park
  • Advances in Materials Science and Engineering -
  • Special Issue
  • Volume 2016
  • - Article ID 9789061
  • - Research Article

Electromagnetic Stirring versus ECAP: Morphological Comparison of Al-Si-Cu Alloys to Make the Microstructural Refinement for Use in SSM Processing

Luis Vanderlei Torres | Luis Fernando Torres | Eugênio José Zoqui
  • Advances in Materials Science and Engineering -
  • Special Issue
  • Volume 2016
  • - Article ID 4356967
  • - Research Article

Development of Shear Capacity Prediction Model for FRP-RC Beam without Web Reinforcement

Md. Arman Chowdhury | Zubayer Ibna Zahid | Md. Mashfiqul Islam
  • Advances in Materials Science and Engineering -
  • Special Issue
  • Volume 2016
  • - Article ID 6942696
  • - Research Article

Influences by Air Voids on the Low-Temperature Cracking Property of Dense-Graded Asphalt Concrete Based on Micromechanical Modeling

Tao Ma | Yao Zhang | ... | Yongli Zhao
  • Advances in Materials Science and Engineering -
  • Special Issue
  • Volume 2016
  • - Article ID 6496348
  • - Research Article

Effect of Casting Conditions on the Fracture Strength of Al-5 Mg Alloy Castings

Fawzia Hamed Basuny | Mootaz Ghazy | ... | Mahmoud Ahmed El-Sayed
Advances in Materials Science and Engineering
 Journal metrics
See full report
Acceptance rate16%
Submission to final decision115 days
Acceptance to publication21 days
CiteScore3.300
Journal Citation Indicator-
Impact Factor-
 Submit Evaluate your manuscript with the free Manuscript Language Checker

We have begun to integrate the 200+ Hindawi journals into Wiley’s journal portfolio. You can find out more about how this benefits our journal communities on our FAQ.